Electrolux Ewfm 14480 W User Manual

6. When no more water comes out, un-
screw the pump cover, using a pliers,
and remove the filter. Always keep a rag
nearby to dry up spillage of water when
removing the cover.
12
7. Remove any objects from the pump im-
peller by rotating it.
8. Replace the filter into the pump paying
attention to insert it properly. When
done, screw it firmly.
9. Replace the emergency emptying cap
into the filter cover and fix it firmly.
10. Close the pump door.
electrolux  21
 

Warning! When the appliance is in use
and depending on the programme
selected there can be hot water in the
pump. Never remove the pump cover
during a wash cycle, always wait until the
appliance has finished the cycle, and is
empty. When replacing the cover,
ensure it is securely re-tightened so as
to stop leaks and young children being
able to remove it.
Cleaning the water inlet filter
If you notice that the machine is taking longer
to fill, check that the filter in the water inlet
hose is not blocked....

What to do if...
Certain problems are due to lack of simple
maintenance or oversights, which can be
solved easily without calling out an engineer.
Before contacting your local Service Centre,
please carry out the checks listed below.
During machine operation it is possible that
the red pilot light of button 8 blinks, one of
the following alarm codes appears on the
display and some acoustic signals sound ev-
ery 20 seconds to indicate that the machine
is not working:• : problem with the water supply.
•
 :...

ProblemPossible cause/Solution
There is water on the floor:
Too much detergent or unsuitable detergent (creates too much
foam) has been used.
• Reduce the detergent quantity or use another one.
Check whether there are any leaks from one of the inlet hose fittings.
It is not always easy to see this as the water runs down the hose;
check to see if it is damp.
• Check the water inlet hose connection.
The drain or inlet hose is damaged.
• Replace it with a new one.
The emergency emptying cap has not been...

ProblemPossible cause/Solution
Unsatisfactory drying re-
sults:
The laundry was too wet because it had not be spun or wrung
enough.
• Do another drying cycle.
Too much items have been put on the board or they have been put
one upon another.
• Dry the items separately, spreading them out completely and
without covering one with another.
If you are unable to identify or solve the prob-
lem, contact our service centre. Before tele-
phoning, make a note of the model, serial
number and purchase date of your...

ProgrammeEnergy consumption
(KWh)Water consumption
(litres)Programme duration
(Minutes)
Wool/ Handwash 30°0.2555
1) «Cottons Eco» at 60°C with a load of 7 kg is the reference programme for the data entered in the
energy label, in compliance with EEC 92/75 standards.
The consumption data shown on this chart is to be considered purely indicative, as it
may vary depending on the quantity and type of laundry, on the inlet water temperature
and on the ambient temperature.
Installation
Unpacking
All transit...

5. Open the porthole and remove the poly-
styrene block fitted on the door seal.
6. Fill the smaller upper hole and the two
large ones with the corresponding plastic
plug caps supplied in the bag containing
the instruction booklet.
Positioning
Install the machine on a flat hard floor. Make
sure that air circulation around the machine
is not impeded by carpets, rugs etc. Check
that the machine does not touch the wall or
other kitchen units. Level the washing ma-
chine by raising or lowering the feet. The...

Water inlet
Warning! This appliance must be
connected to a cold water supply.
1. Connect the water inlet hose supplied
with the machine to a tap with a 3/4
thread. Always use the hose supplied
with the appliance.
Important! Do not use the hose from
your previous machine to connect to the
water supply.
2. The other end of the inlet hose which
connects to the machine can be turned
as showed in the picture.
Do not place the inlet hose downwards.
Angle the hose to the left or right depend-
ing on the...

The drain hose may be extended to a maximum of 4 metres. An additional drain hose and
joining piece is available from your local Service Centre.
Electrical connection
Information on the electrical connection is
given on the rating plate on the inner edge of
the appliance door.
Check that your domestic electrical installa-
tion can take the maximum load required, al-
so taking into account any other appliances
in use.
Connect the machine to an earthed
socket.
The manufacturer does not accept
any...

• With adequate pre-treatment, stains and
limited soiling can be removed; the laundry
can then be washed at a lower tempera-
ture.• Measure out detergent according to the
water hardness, the degree of soiling and
the quantity of laundry being washed.
30  electrolux