Electrolux Ewfm 14480 W User Manual

Press the button again to restart the pro-
gramme.
Cancelling a programme
Turn the selector dial to 
 to cancel a pro-
gramme which is running.
You can select now a new programme.
Opening the door
After the programme has started (or during
the delay time) the door is locked, if you need
to open it, set first the machine to PAUSE by
pressing the button 8 .
After a few minutes the pilot light 9 goes out
and it is possible to open the door.
If this pilot light remains lit, this means that
the machine is...

• DO NOT lean on the top and, espe-
cially, DO NOT lean on the shelf when
it is open, because it could be dam-
aged.
In any case, if the top or the shelf are
damaged, DO NOT try to fix them by
your self. Contact your local Service
Centre.• DO NOT place detergent, bleach or
fabric softener containers on top of
the appliance. They can damage the
finish or controls.
• The liquids that inadvertently run in-
side will be gathered inside the appli-
ance and can be emptied out as de-
scribe in the paragraph...

Operating Sequence
Shelf closed (Picture 1)
Shelf open (Picture 2)
Picture 3Picture 4
1. ACTIVATE button
2. DRYING DEGREE button
3. DRYING TIME button
4. START button
min
4321
1. Spread out the laundry on the top with
care (see picture 1). In this case, make
sure that the shelf is completely closed.
If its necessary, open the extractable
shelf , e.i. for larger amounts of washing
items or large items as large towel, trou-
sers, bath-robe...(see picture 2). Open
the shelf as shown in picture 3 and close...

2. Press the ACTIVATE button to activate
the drying board. The integrated light of
the START button starts blinking.
3. On the base of the kind of fabric and the
moisture degree, select the degree of
dryness by pressing the DRYING DE-
GREE button until the relevant pilot light
goes on.
4. Select the desired time by pressing the
DRYING TIME button until the relevant
pilot light goes on. If you select 90min all
the time pilot lights go on.
For choosing the most suitable drying
degree and temperature,...

Rub particularly soiled areas with a special
detergent or detergent paste.
Treat curtains with special care. Remove
hooks or tie them up in a bag or net.
Maximum loads
Recommended loads are indicated in the
washing programme charts.
General rules:
•
Cotton, linen: drum full but not too tightly
packed;
•
Synthetics: drum no more than half full;
•Delicate fabrics and woollens: drum no
more than one third full.
Washing a maximum load makes the most
efficient use of water and energy.
For heavily soiled...

Your appliance incorporates a recirculation
system which allows an optimal use of the
concentrated detergent.
Follow the product manufacturer’s recom-
mendations on quantities to use and do not
exceed the «MAX» mark in the detergent
dispenser drawer .
Degrees of water hardness
Water hardness is classified in so-called “de-
grees” of hardness. Information on hardness
of the water in your area can be obtained
from the relevant water supply company, or
from your local authority.
A water softener must be...

Programme
Maximum and Minimum Temperature
Cycle Description
Maximum Spin Speed
Maximum Fabrics Load
Type of Laundry
OptionsDetergent
Compartment
JEANS
60°-Cold
Main wash - Rinses
Maximum spin speed 1200 rpm
Max. load 3,5 kg
With this programme it is possible to wash items like pants,
shirts or jackets in denim and also jersey realized with hi-tech
materials. (The Extra Rinse option will be activated automat-
ically).SPIN
RINSE HOLD
PREWASH 
2)
SPIN
Drain and long spin
Maximum spin speed 1400 rpm
Max....

Programme
Maximum and Minimum Temperature
Cycle Description
Maximum Spin Speed
Maximum Fabrics Load
Type of Laundry
OptionsDetergent
Compartment
HANDWASH
40°-Cold
Main wash - Rinses
Maximum spin speed 900 rpm
Max. load 2 kg
Special programme for delicate fabrics with «hand washing»
care symbol.SPIN
RINSE HOLD
WOOL
40°-Cold
Main wash - Rinses
Maximum spin speed 900 rpm
Max. load 2 kg
Washing programme for machine washable wool as well as
for hand washable woollens and delicate fabrics. Note  : A
single or...

according to the softening powder manufac-
turers instructions. This will help to prevent
the formation of lime deposits.
After each wash
Leave the door open for a while. This helps
to prevent mould and stagnant smells form-
ing inside the appliance. Keeping the door
open after a wash will also help to preserve
the door seal.
Maintenance wash
With the use of low temperature washes it is
possible to get a build up of residues inside
the drum.
We recommend that a maintenance wash be
performed on a regular...

Washing drum
Rust deposits in the drum may occur due to
rusting foreign bodies in the washing or tap
water containing iron.
Important! Do not clean the drum with
acidic descaling agents, scouring agents
containing chlorine or iron or steel wool.
1. Remove any rust deposits on the drum
with a cleaning agent for stainless steel.
2. Run a washing cycle without any washing
to clean off any cleaning agent residues.
Programme: Short Cotton Programme at
maximum temperature and add approx.
1/4 measuring cup of...