Home > Electrolux > Washing Machine > Electrolux Ewf 86110 W User Manual

Electrolux Ewf 86110 W User Manual

    Download as PDF Print this page Share this page

    Have a look at the manual Electrolux Ewf 86110 W User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 208 Electrolux manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.

    							Positioning
    Install the machine on a flat hard floor. Make
    sure that air circulation around the machine
    is not impeded by carpets, rugs etc. Check
    that the machine does not touch the wall or
    other kitchen units. Level the washing ma-
    chine by raising or lowering the feet. The feet
    may be tight to adjust as they incorporate a
    self locking nut, but the machine MUST be
    level and stable. If necessary, check the set-
    ting with a spirit level. Any necessary adjust-
    ment can be made with a spanner. Accurate
    levelling prevents vibration, noise and dis-
    placement of the machine during operation.
    Caution! Never place cardboard, wood
    or similar materials under the machine to
    compensate for any unevenness in the
    floor.
    Water inlet
    Warning! This appliance must be
    connected to a cold water supply.
    1. Connect the water inlet hose supplied
    with the machine to a tap with a 3/4
    thread. Always use the hose supplied
    with the appliance.
    Important! Do not use the hose from
    your previous machine to connect to the
    water supply.
    2. The other end of the inlet hose which
    connects to the machine can be turned
    as showed in the picture.
    Do not place the inlet hose downwards.
    Angle the hose to the left or right depend-
    ing on the position of your water tap.
    3. Set the hose correctly by loosening the
    ring nut. After positioning the inlet hose,
    be sure to tighten the ring nut again to
    prevent leaks.
    The inlet hose must not be lengthened. If it is
    too short and you do not wish to move the
    electrolux  21
     
    						
    							tap, you will have to purchase a new, longer
    hose specially designed for this type of use.
    Important! Before connecting up the
    machine to new pipework or to pipework that
    has not been used for some time, run off a
    reasonable amount of water to flush out any
    debris that may have collected in the pipes.
    Water drainage
    The end of the drain hose can be positioned
    in three ways.
    •Hooked over the edge of a sink using
    the plastic hose guide supplied with the
    machine. In this case, make sure the end
    cannot come unhooked when the ma-
    chine is emptying. This could be done by
    tying it to the tap with a piece of string or
    attaching it to the wall.•
    In a sink drain pipe branch. This branch
    must be above the trap so that the bend is
    at least 60 cm above the ground.
    •Directly into a drain pipe at a height of
    not less than 60 cm and not more than 90
    cm. The end of the drain hose must always
    be ventilated, i.e. the inside diameter of the
    drain pipe must be larger than the outside
    diameter of the drain hose. The drain hose
    must not be kinked.
    The drain hose may be extended to a maximum of 4 metres. An additional drain hose and
    joining piece is available from your local Service Centre.
    22  electrolux
     
    						
    							Electrical connection
    Information on the electrical connection is
    given on the rating plate on the inner edge of
    the appliance door.
    Check that your domestic electrical installa-
    tion can take the maximum load required, al-
    so taking into account any other appliances
    in use.
    Connect the machine to an earthed
    socket.
    The manufacturer does not accept
    any responsibility for damage orinjury through failure to comply with
    the above safety precaution.
    The power supply cable must be
    easily accessible after installing the
    machine.
    Should the appliance power supply
    cable need to be replaced, this must
    be carried out by a Service Centre.
    Environment concerns
    The symbol    on the product or on its
    packaging indicates that this product may
    not be treated as household waste. Instead
    it should be taken to the appropriate
    collection point for the recycling of electrical
    and electronic equipment. By ensuring this
    product is disposed of correctly, you will help
    prevent potential negative consequences for
    the environment and human health, which
    could otherwise be caused by inappropriate
    waste handling of this product. For more
    detailed information about recycling of this
    product, please contact your local council,
    your household waste disposal service or the
    shop where you purchased the product.
    Packaging materials
    The materials marked with the symbol 
     are
    recyclable.
    >PEPSPP
    						
    							192991070-00-452009
    www.electrolux.com
     
    						
    All Electrolux manuals Comments (0)

    Related Manuals for Electrolux Ewf 86110 W User Manual