Electrolux Ewf 12470 W User Manual

MalfunctionPossible causeSolution
The machine vibrates or is
noisy:●The transit bolts and
packing have not been
removed.
●The support feet have not
been adjusted.
●The laundry is not evenly
distributed in the drum.
●Maybe there is very little
laundry in the drum.
●Check the correct
installation of the appliance.
●Check the correct levelling
of the appliance.
●Redistribute the laundry.
●Load more laundry.
Spinning starts late or the
machine does not spin:●The electronic unbalance
detection device has cut...

MalfunctionPossible causeSolution
If you are unable to identify or solve the
problem, contact our service centre.
Before telephoning, make a note of the
model, serial number and purchase date
of your machine: the Service Centre will
require this information.

	

	






The machine makes an
unusual noise●The machine is fitted with a
type of motor which makes
an unusual noise compared
with other...

Technical data
Dimensions Width 60 cm
85 cm
63 cm Height
Depth
Water supply pressure Minimum 0,05 MPa
0,8 MPa Maximum
Cotton
Synthetics
Delicates
Woollens and handwash
Jeans
Lingerie/SilkMaximum Load6     kg
2.5 kg
2.5 kg
2 kg
3kg
1kg
MaximumSpin Speed1000 rpm (EWF 10470W)
1200 rpm (EWF 12470W)
1400 rpm (EWF 14470W) 
Electrical connection Voltage
- Overall power - FuseInformation on the electrical connection is given on
the rating plate on the inner edge of the appliance
door
technical data...

34electroluxconsumption value
Consumption values
Water
consumption 
(in litres)Programme Energy
consumption 
(in kWh)Programme
duration 
(in minutes)
Cottons Normal 95° 2.162
Cottons  Eco 60° (*)1.02 54
Cottons + Prewash 2.374
Cottons  Eco + Prewash1.4 72
Synthetics 60°
0.85 52
For the duration of the programmes, please refer to the display on the
control panel.
Handwash 40° 0.145
Lingerie 40° --
Silk 30° -- Synthetics Eco
0.5 60
Synthetics Eco +Prewash0.4 58
Delicates 40° 0.458
Wool 40° 0.2550...

The consumption data shown on this
chart is to be considered purely
indicative, as it may vary depending on
the quantity and type of laundry, on the
inlet water temperature and on the
ambient temperature. It refers to the
highest temperature for each wash
programme.(*) The programme “Cottons Eco  ” at
60°C is the reference programme for
the data entered in the energy label,
in compliance with EEC 92/75
standards.
consumption value  electrolux 35
132979220.qxd  30/08/2006  12:04  Pagina  35
 

36electrolux installation
Installation
Unpacking
All transit bolts and packing must be
removed before using the appliance.
You are advised to keep all transit
devices so that they can be refitted if the
machine ever has to be transported
again.
1. After removing all the packaging,
carefully lay machine on it’s back to
remove the polystyrene base from the
bottom.
2. Remove the power supply cable and
the draining hose from the hose
holders on the rear of the appliance.
3. With a suitable spanner unscrew...

6. Open the porthole, take out the inlet
hose from the drum and remove the
polystyrene block fitted with the
adhesive tape on the door seal.
7. Fill the smaller upper hole and the two
large ones with the corresponding
plastic plug caps supplied in the bag
containing the instruction booklet.
Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the
machine is not impeded by carpets,
rugs etc. Check that the machine does
not touch the wall or other kitchen units.
Level...

38electroluxinstallation
After positioning the inlet hose, be
sure to tighten the ring nut again to
prevent leaks.
4. Connect the hose to a tap with a 3/4”
thread. Always use the hose supplied
with the appliance. 
The inlet hose must not be lengthened. If
it is too short and you do not wish to
move the tap, you will have to purchase
a new, longer hose specially designed
for this type of use.
Water drainage
The end of the drain hose can be
positioned in three ways:
Hooked over the edge of a sink
using the...

Electrical connection
This machine is designed to operate on
a 220-230 V, single-phase, 50 Hz
supply.
Check that your domestic electrical
installation can take the maximum load
required (2.2 kW), also taking into
account any other appliances in use.
Connect the machine to an earthed
socket. 
The manufacturer declines any
responsibility for damage or injury
through failure to comply with the above
safety precaution. Should the appliance
power supply cable need to be
replaced, this should be carried out...

Environment concerns
Packaging materials
The materials marked with the symbol
are recyclable.
>PEPSPP