Electrolux Esl 67050 User Manual

The cutlery basket is in two parts which can
be separated to give greater loading flexibili-
ty. To separate the two parts, slide them hor-
izontally in opposite directions and pull them
apart.
To reassemble, reverse the procedure.
The upper basket
The upper basket is designed for saucers,
salad bowls, cups, glasses, pots and lids.
Arrange items on and underneath the cup
racks so that water can reach all surfaces.
Glasses with long stems can be placed up-
side down in the cup racks.
For taller items the...

Mini cutlery basket
The upper basket is supplied with a mini cut-
lery basket.
Caution! NEVER PUT KNIVES IN THE
MINI CUTLERY BASKET. THIS WILL
PREVENT DAMAGE TO THE
APPLIANCE.
The mini cutlery basket must only be placed
in the front part of the upper basket, on the
left or on the right side.
The dimensions of the cutlery depend on the
position of the upper basket. Refer to the fol-
lowing table.
Cutlery dimensions for mini cutlery basket
Upper basket in higher
positionmaximum 15 cm
Upper basket in lower...

Caution! BEFORE CLOSING THE
DOOR, MAKE SURE THAT THE SPRAY
ARMS CAN ROTATE FREELY.
Adjusting the height of the upper basket
If washing very large plates you can load
them in the lower basket after moving the
upper basket to the higher position.
Maximum height of the dishes in the lower
basket
With upper basket
raised31 cm
With upper basket
lowered27 cm
To move to the higher position proceed
as follows:
1. Pull out the basket until it stops.
2. Carefully lift both sides upwards until the
mechanism is...

2. Fill the detergent dispenser (1) with de-
tergent. The marking indicates the dosing
levels:
20 = approximately 20 g of detergent
30 = approximately 30 g of detergent.
3. All programmes with prewash need an
additional detergent dose (5/10 g) that
must be placed in the prewash detergent
chamber (2).
This detergent will be used during the
prewash phase.
When using detergent tablets; place the
tablet in compartment (1)
1
2
4. Close the lid and press until it locks in
place.
Detergent tablets from...

If the drying results are not satisfac-
tory we suggest that you:
1. Fill up the rinse aid dispenser with
rinse aid.
2. Activate the rinse aid dispenser.
3. Set the rinse aid dosage to position
2.
• The activation/deactivation of the
rinse aid is only possible with the Mul-
titab function active.
Activation/deactivation of the rinse aid
dispenser
1. Press the On/Off button. The dishwasher
must be in setting mode.
2. Simultaneously press and hold function
buttons B and C , until the lights of func-
tion...

Interrupt a washing programme in
progress
• Open the dishwasher door; the pro-
gramme will stop. Close the door; the pro-
gramme will start from the point at which
it was interrupted.
Cancelling a delay start or a washing
programme in progress
• Press and hold the cancel button until the
digital display shows 2 horizontal bars.
• Cancelling a delay start will also cancel the
washing programme. You have to select
the washing programme again.
• If a new washing programme is to be se-
lected, check that...

Pro-
grammeDegree of
soilType of loadProgramme descriptionEnergy save 1)
3
 3)Normal or
light soilCrockery and
cutleryMain wash up to 60°C
Final rinseSelectable, no
impact on wash-
ing programme.
4
 4)Normal soilCrockery and
cutleryPrewash
Main wash up to 50°C
1 intermediate rinse
Final rinse
DryingSelectable, im-
pact on washing
programme.
5Light soilCrockery and
cutleryMain wash up to 55°C
1 intermediate rinse
Final rinseSelectable, no
impact on wash-
ing programme.
6Normal or
light soilDelicate...

Care and cleaning
Cleaning the filters
The filters must be checked and cleaned
from time to time. Dirty filters will degrade the
washing result.
Warning! Before cleaning the filters
ensure that the machine is switched off.
1. Open the door, remove the lower basket.
2. The dishwasher filter system comprises a
coarse filter ( A ), a microfilter ( B ) and a
flat filter. Unlock the filter system using the
handle on the microfilter.
3. Turn the handle about 1/4 a turn anti-
clockwise and remove the filter...

1. Unplug the appliance and then turn off
the water.
2. Leave the door ajar to prevent the forma-
tion of any unpleasant smells.
3. Leave the inside of the machine clean.
Frost precautions
Avoid placing the machine in a location
where the temperature is below 0°C. If this is
unavoidable, empty the machine, close the
appliance door, disconnect the water inlet
pipe and empty it.Moving the machine
If you have to move the machine (moving
house etc...):
1. Unplug it.
2. Turn the water tap off.
3. Remove the...

If the malfunction or fault code reappears
contact your local Service Force Centre.
For other fault codes not described in the
above chart, please contact your local Serv-
ice Force Centre.
Contact your local Service Force Centre,
quoting the model (Mod.), product number
(PNC) and serial number (S.N.).
This information can be found on the rating
plate located on the side of the dishwasher
door.So that you always have these numbers at
hand, we recommend you to make a note of
them here:
Mod. : . . . . . ....