Electrolux Esf 63020 X Manual

							Upper basket
cup racks: position A
Installation
Any electrical and/or plumbing work
required to install this appliance
should be carried out by a qualified
electrician and/or plumber or com-
petent person.
Remove all packaging before position-
ing the machine.
If possible, position the machine next to
a water tap and a drain.
Fitting under a counter (kitchen
worktop or sink)
By removing the machine’s worktop,
you can install it under a close fitting sink
unit or a pre-existing top, providing the
dimensions of the recess correspond to
those shown in the picture.
Proceed as follows:installation  electrolux   31 
						

							• Remove the machine’s worktop by
unscrewing the two rear retaining
screws, pull the worktop from the
back of the machine and slide out the
front slots, lifting the worktop.
• Insert the machine after adjusting the
levelling with the adjustable feet.
When inserting the machine, ensure that
the water inlet and drain hoses are not
kinked or squashed.
During all operations that involve
accessibility to internal components the
dishwasher has to be unplugged.
Be sure that once the appliance has
been installed, it is easily accessible for
the service engineer in the event that a
repair is required.
If the dishwasher is later used as a free-
standing appliance, the original worktop
must be re-mounted.
The plinth on free-standing appliances is
not adjustable.
Levelling
Good levelling is essential for correct
closure and sealing of the door. When
the appliance is correctly levelled, the
door will not catch on either side of the
cabinet. If the door does not close
correctly, loosen or tighten the adjusta-
ble feet until the machine is perfectly
level.
Water supply connections
This dishwasher may be fed with either
hot (max. 60°) or cold water. Neverthe-
less we advise you a cold water supply.
A hot water supply is not always efficient
with very soiled crockery as it shortens
the washing programmes a lot.
For making the connection itself, the
coupling nut fitted to the machine’s sup-
ply hose is designed to screw onto a
3/4 gas thread spout or to a purpose
made quick-coupling tap such as the
Press-block.
The water pressure must be within the
limits given in the Technical specifica-
tions. Your local Water Authority will ad-
vise you on the average mains pressure
in your area.
The water inlet hose must not be kinked,
crushed, or entangled when it is being
connected.
The dishwasher features fill and drain
hoses which can be turned either to the
left or the right to suit the installation by
means of the locknut.
The locknut must be correctly fitted
to avoid water leaks.
(Attention! NOT all models of dishwash-
ers have fill and drain hoses provided
with locknut. In this case, this kind of
facility is not possible). If the machine is
connected to new pipes or pipes which
have not been used for a long time, you
should run the water for a few minutes
before connecting the inlet hose.
DO NOT use connection hoses
which have previously been used for
an old appliance. 32  electrolux  installation 
						

							This appliance has been fitted with
safety features which will prevent
the water used in the appliance from
returning back into the drinking wa-
ter system. This appliance complies
with the applicable plumbing regu-
lations.
Water outlet hose connection
The end of the drain hose can be con-
nected in the following ways:
1. To the sink outlet spigot, securing it
to the underside of the work surface.
This will prevent waste water from
the sink running into the machine.
2. To a stand pipe provided with vent-
hole, minimum internal diameter 4
cm.
The waste connection must be at a
height of between 30 cm (minimum) and
100 cm (maximum) from the bottom of
the dishwasher.
The drain hose can face either to the
right or left of the dishwasher.
Ensure the hose is not bent or squashed
as this could prevent or slow down the
discharge of water.
The sink plug must not be in place when
the machine is draining as this could
cause the water to syphon back into the
machine.
If you use a drain hose extension it must
be no longer than 2 metres and its inter-
nal diameter must be no smaller than the
diameter of the hose provided.
Likewise the internal diameter of the
couplings used for connections to the
waste outlet must be no smaller than the
diameter of the hose provided.
When connecting the drain hose to an
under sink trap spigot, the entire plas-
tic membrane (A) must be removed.
Failure to remove all the membrane will
result in food particles building up over
time eventually blocking the dishwasher
drain hose spigot.
Our appliances are supplied with a
security device to protect against
the return of dirty water back into
the machine. If the spigot of your
sink has a no return valve incor-
porated this can prevent the correct
draining of your dishwasher. We
therefore advise you to remove it.installation  electrolux   33 
						

							Electrical connection
Safety standards require the appli-
ance to be earthed.
Prior to using the appliance for the
first time, ensure that the rated volt-
age and type of supply on the rating
plate match that of the supply where
the appliance is to be installed.
The fuse rating is also to be found on
the rating plate.
Always plug the mains plug into a
correctly installed shockproof
socket. Multi-way plugs, connec-
tors and extension cables must not
be used.This could constitute a fire hazard
through overheating.
If necessary, have the domestic wir-
ing system socket replaced. In case
that the electrical cable has to be
replaced, contact your local Service
Force centre.
The plug must be accessible after
the appliance has been installed.
Never unplug the appliance by pull-
ing on the cable. Always pull the
plug.
The manufacturer accepts no
liability for failure to observe the
above safety precautions.
Environment concerns
Packaging material
The packaging materials are
environmentally friendly and can be re-
cycled. The plastic components are
identified by markings, e.g. >PEPS
						

							this product, please contact your local
council, your household waste disposalservice or the shop where you pur-
chased the product. environment concerns  electrolux   35 
						

							36 electrolux 
						

							electrolux 37 
						

							38 electrolux 
						

							156993830-00-11092007
www.electrolux.com
www.electrolux.com.my
www.electrolux.com.sg