Electrolux Esf 63020 X Manual
Have a look at the manual Electrolux Esf 63020 X Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 208 Electrolux manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
1. After having selected the washing programme, press the delay start button. – The corresponding indicator light illuminates. 2. Press the start/cancel button, the countdown of the delay start begins automatically. – The phase indicator lights turn off. – The opening of the door will not modify or interrupt the count- down. – Once the delay start has elapsed the washing programme will start automatically, the delay start indi- cator light turns off while the indi- cator light of the phase in progress illuminates. Cancelling the delay start • Press the start/cancel button for about 5 seconds, the indicator lights of start/cancel and delay start but- tons turn off while the indicator lights of the phases start flashing. To start the selected washing pro- gramme press the start/cancel but- ton. The washing programme or the countdown of the delay start will be- gin only after having pressed the start/cancel button. Until that mo- ment it is possible to modify the se- lection made. Interrupt or cancel a washing pro- gramme in progress ONLY if it’s absolutely necessary. Attention! Hot steam may escape when the door is opened. Open the door carefully. Interrupt a washing programme in progress: • Open the dishwasher door; the pro- gramme will stop. Close the door; the programme will start from the point at which it was interrupted. Cancel a washing programme in progress • Press the start/cancel button for about 5 seconds. The start/cancel in- dicator light turns off and the phase indicator lights are flashing. The run- ning programme has been cancelled and it is now possible to set a new washing programme or switch off the machine. If a new washing pro- gramme is to be selected, check that there is detergent in the detergent dispenser. End of the washing programme • The dishwasher will automatically stop. •The end of programme indicator light will illuminate. 1. Switch off the dishwasher by return- ing the programme knob to the Off position. The On/Off indicator light turns off. 2. Open the dishwasher’s door, leave it ajar and wait a few minutes before removing the dishes; in this way they select and start a washing programme electrolux 21
will be cooler and the drying will be improved. Unloading the dishwasher • Hot dishes are sensitive to knocks. The dishes should therefore be al- lowed to cool down before removing from the appliance. • Empty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one. • Water may appear on the sides and the door of the dishwasher as thestainless steel will eventually become cooler than the dishes. When the washing programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off. Washing programmes ProgrammeDegree of soilType of loadProgramme de- scription A Intensive 70° Heavy soilCrockery, cutlery, pots and pansPrewash Main wash up to 70°C 2 intermediate rin- ses Final rinse Drying B Normal 65° Normal soilCrockery, cutlery, pots and pansPrewash Main wash up to 65°C 2 intermediate rin- ses Final rinse Drying 22 electrolux unloading the dishwasher
ProgrammeDegree of soilType of loadProgramme de- scription C Quick 1) Normal or light soilCrockery and cut- leryMain wash up to 60°C Final rinse D Eco 50° 2) Normal soilCrockery and cut- leryPrewash Main wash up to 50°C 1 intermediate rinse Final rinse Drying E Rinse and Hold Any. Partial load (to be completed later in the day).1 cold rinse (to avoid food scraps from sticking together). This programme does not require the use of deter- gent. 1) Ideal for washing a partially loaded dishwasher. This is the perfect daily programme, made to meet the needs of a family of 4 persons who only wish to load breakfast and dinner crockery and cutlery. 2) Test programme for test institutes. Care and cleaning Cleaning the filters The filters must be checked and cleaned from time to time. Dirty filters will de- grade the washing result. Before cleaning the filters ensure that the machine is switched off.1. Open the door, remove the lower basket. 2. The dishwasher filter system compri- ses a coarse filter (A), a microfilter (B) and a flat filter. Unlock the filter sys- tem using the handle on the microfil- ter.care and cleaning electrolux 23
3. Turn the handle about 1/4 a turn an- ticlockwise and remove the filter sys- tem. 4. Take hold of the coarse filter (A) by the handle with the hole and remove from the microfilter (B). 5. Clean all filters thoroughly under run- ning water. 6. Remove the flat filter from the base of the washing compartment and clean both faces thoroughly.7. Put the flat filter back in the base of the washing compartment and en- sure that it fits perfectly under the two guides (C). 8. Place the coarse filter (A) in the mi- crofilter (B) and press together. 9. Put the filter combination in place and lock by turning the handle clock- wise to the stop. During this process ensure that the flat filter does not protrude above the base of the washing compartment. 24 electrolux care and cleaning
NEVER use the dishwasher without filters. Incorrect repositioning and fitting of the filters will produce poor washing results and may result in damage to the appliance. Cleaning the spray arms NEVER try to remove the spray arms. If residues of soil have clogged the holes in the spray arms, remove them with a cocktail stick. External cleaning Clean the external surfaces of the ma- chine and control panel with a damp soft cloth. If necessary use only neutral de- tergents. Never use abrasive products, scouring pads or solvent (acetone, tri- chloroethylene etc....). Internal cleaning Ensure that the seals around the door, the detergent and rinse aid dispensers are cleaned regularly with a damp cloth. We recommend every 3 months to run the wash programme for heavy soiled dishes using detergent but without dishes. Prolonged periods of non- operation If you are not using the machine for any prolonged period of time you are ad- vised to: 1. Unplug the appliance and then turn off the water. 2. Leave the door ajar to prevent the formation of any unpleasant smells. 3. Leave the inside of the machine clean. Frost precautions Avoid placing the machine in a location where the temperature is below 0°C. If this is unavoidable, empty the machine, close the appliance door, disconnect the water inlet pipe and empty it. Moving the machine If you have to move the machine (moving house etc....): 1. Unplug it. 2. Turn the water tap off. 3. Remove the water inlet and dis- charge hoses. 4. Pull the machine out together with the hoses. Avoid over tilting the machine during transportation.care and cleaning electrolux 25
Something not working The dishwasher will not start or stops during operation. Certain problems are due to the lack of simple maintenance or oversights, which can be solved with the help of theindications described in the chart, with- out calling out an engineer. Switch off the dishwasher, open the door and carry out the following sugges- ted corrective actions. Fault code and malfunctionPossible cause and solution • continuous flashing of the start/can- cel indicator light • 1 flash of the end of programme indi- cator light The dishwasher does not fill with water• The water tap is blocked or furred with limescale Clean the water tap • The water tap is turned off Turn the water tap on • The filter (where present) in the threa- ded hose fitting at the water inlet valve is blocked Clean the filter in the threaded hose • The water inlet hose has not been correctly laid or it is bent or squashed Check the water drain hose connection • continuous flashing of the start/can- cel indicator light • 2 flashes of the end of programme indicator light The dishwasher will not drain• The sink spigot is blocked Clean out the sink spigot • The water drain hose has not been correctly laid or it is bent or squashed Check the water drain hose connection • continuous flashing of the start/can- cel indicator light • 3 flashes of the end of programme indicator light• Anti-flood device is activated Close the water tap and contact your local Service Force Center. 26 electrolux something not working
Fault code and malfunctionPossible cause and solution • The programme does not start• The dishwasher’s door has not been properly closed Close the door • The main plug is not plugged in Insert the main plug • The fuse has blown out in the house- hold fuse box Replace the fuse • Delay start has been set If dishes are to be washed immediately, cancel the delay start Once these checks have been carried out, switch on the appliance: the pro- gramme will continue from the point at which it was interrupted. If the malfunction or fault code reap- pears contact the Service Force Centre. For other fault codes not described in the above chart, please contact your lo- cal Service Force Centre, quoting the model (Mod.), product number (PNC) and serial number (S.N.).This information can be found on the rat- ing plate located on the side of the dishwasher door. So that you always have these numbers at hand, we recommend you to make a note of them here: Mod. : . . . . . . . . . . . . . . . . . . . . . . . PNC :. . . . . . . . . . . . . . . . . . . . . . . . S.N. : . . . . . . . . . . . . . . . . . . . . . . . . something not working electrolux 27
The wash results are not satisfactory The dishes are not clean• The wrong washing programme has been selected. • The dishes are arranged in such a way as to stop water reaching all parts of the surface. The baskets must not be overloaded. • The spray arms do not rotate freely due to incorrect arrangement of the load. • The filters in the base of the washing compartment are dirty or incorrectly positioned. • Too little or no detergent has been used. • Where there are limescales deposits on the dishes; the salt container is empty or the incorrect level of the wa- ter softener has been set. • The drain hose connection is not cor- rect. • The salt container cap is not properly closed. The dishes are wet and dull• Rinse aid was not used. • The rinse aid dispenser is empty. There are streaks, milky spots or a blu- ish coating on glasses and dishes• Decrease rinse aid dosing. Water drops have dries onto glasses and dishes• Increase rinse aid dosing. • The detergent may be the cause. Contact the detergent manufactur- er’s consumer care line. If after all these checks, the problem per- sists, contact your local Service Force Centre. 28 electrolux something not working
Technical data DimensionsWidth x Height x Depth (cm)60,0 x 85,0 x 61,0 Electrical connection Voltage - Overall power - FuseInformation on the electrical connection is given on the rating plate on the inner edge of the dishwasher’s door. Water supply pressureMinimum - Maximum (MPa)0,05 - 0,8 Capacityplace settings12 Max. weightkg40,5 Noise leveldB(A)49 Consumption values Consumption values ProgrammeProgramme du- ration (in mi- nutes)Energy con- sumption (in kWh)Water (litres) Intensive85-951,8-2,022-25 Normal105-1151,5-1,723-25 Quick 30300,99 ECO (Test pro- gramme for Test Institutes)1401,0518 Rinse and Hold120,15 The consumption values are inten- ded as a guide and depends on thepressure and the temperature of the water and also by the variations of the power supply and the amount of dishes.technical data electrolux 29
Hints for test institutes Testing in accordance with EN 60704 must be carried out with appliance fully loaded and using the test programme (see Consumption values). Test in accordance with EN 50242 must be carried out when the salt containerand rinse aid dispenser have been filled with salt and rinse aid respectively and using the test programme (see Consumption values). Full load: 12 standard place settings Amount of detergent required5 g + 25 g (Type B) Rinse aid settingposition 4 (Type III) Lower basket Cutlery basket 30 electrolux hints for test institutes