Electrolux Esf 63020 X Manual

Water hardnessAdjusting the water
hardness settingUse of salt
°dH°THmmol/lmanuallyelectronic
ally
< 4< 7< 0,71level 1no
Setting manually
The dishwasher is factory set at po-
sition 2.
1. Open the dishwasher door.
2. Remove the lower basket from the
dishwasher.
3. Turn the water hardness dial to po-
sition 1 or 2 (see table).
4. Replace the lower basket.
Setting electronically
The dishwasher is factory set at
level 5.
1. The dishwasher must be switched
off.
Keep the start/cancel button
pressed and turn...

if the current level is 10, by pressing
start/cancel button once, level 1 is
selected.5. To memorize the operation, switch
off the dishwasher by returning the
programme knob to the Off position.
Filling with dishwasher salt
Only use salt specifically designed for
use in dishwashers. All other types of salt
not specifically designed for use in a
dishwasher, especially table salt, will
damage the water softener. Only fill with
salt just before starting one of the com-
plete washing programmes. This will...

The salt indicator light on the control
panel can remain illuminated for 2-6
hours after the salt has beenreplenished, assuming the
dishwasher remains switched on. If
you are using salts that take longer
to dissolve then this can take longer.
The function of the machine is not
affected.
Use of rinse aid
Only use branded rinse aid for dish-
washers.
Never fill the rinse aid dispenser with
any other substances (e.g.
dishwasher cleaning agent, liquid
detergent). This would damage the
appliance.
Rinse aid...

The dispenser holds about 110 ml of
rinse aid, which is sufficient for be-
tween 16 and 40 dishwashing cy-
cles, depending upon the dosage
setting.
3. Ensure that the lid is closed after ev-
ery refill.
Clean up any rinse aid spilt during
filling with an absorbent cloth to
avoid excess foaming during the
next wash.
Adjusting the dosage of rinse aid
According to the finish and drying
results obtained, adjust the dose of
rinse aid by means of the 6 position
selector (position 1 minimum dos-
age, position 6...

Loading cutlery and dishes
Sponges, household cloths and any ob-
ject that can absorb water may not be
washed in the dishwasher.
• Before loading the dishes, you should:
– Remove all left over food and deb-
ris.
– Soften remnants of burnt food in
pans
• When loading the dishes and cutlery,
please note:
– Dishes and cutlery must not impede
the rotation of the spray arms.
– Load hollow items such as cups,
glasses, pans, etc. with the opening
downwards so that water cannot
collect in the container or a...

The lower basket
The lower basket is designed to take
saucepan, lids, plates, salad bowls, cut-
lery ect.
Service dishes and large lids should be
arranged around the edge of the basket,
ensuring that the spray arms can turn
freely.
The cutlery basket
Long bladed knives stored in an up-
right position are a potential hazard.
Long and/or sharp items of cutlery
such as carving knives must be
positioned horizontally in the upper
basket. Take care when loading orunloading sharp items such as kni-
ves.
Forks...

The upper basket
The upper basket is designed for plates
(dessert plates, saucers, dinner plates of
up to 24 cm in diameter), salad bowls,
cups and glasses
Arrange items on and underneath the
cup racks so that water can reach all
surfaces.
Glasses with long stems can be placed
upside down in the cup racks.
For taller items, the cup racks can be
folded upwards.
Before closing the door, ensured
that the spray arms can rotate
freely.
Adjusting the height of the upper
basket
If washing very large plates you...

2. Refit the basket in the higher position
and replace the stops (A) in their
original position.
When the upper basket is raised you
will not be able to use the cup racks.
After loading your machine always
close the door, as an open door can
be a hazard.
Use of detergent
Only use detergents specifically de-
signed for use in dishwashers.
Please observe the manufacturer’s
dosing and storage recommenda-
tions as stated on the detergent
packaging.
Using no more than the correct
amount of detergent...

1
2
3. All programmes with prewash need
an additional detergent dose (5/10 g)
that must be placed in the prewash
detergent chamber (2).
This detergent will take effect during
the prewash phase.
When using detergent tablets; place
the tablet in compartment (1)
4. Close the lid and press until it locks
in place.
Detergent tabletsDetergent tablets from different
manufactures dissolve at different
rates. For this reason, some deter-
gent tablets do not attain their full
cleaning power during short wash-
ing...

If the drying results are not
satisfactory we recommend that
you:
1. Fill up the rinse aid dispenser
with rinse aid.
2. Set the rinse aid dosage to posi-
tion 2.
If you decide to turn back to the use
of the standard detergent system
we advise that you:1. Fill up the dispensers for salt and
rinse aid again.
2. Adjust the water hardness setting to
the highest setting and perform
washing programme without loading
any dishes.
3. Adjust the water hardness setting
according to the hardness of the wa-
ter in...