Eiki Projector EK-610U User Manual

— 6 — 
DLP Projector — Owner’s Manual
Bottom View
241.2mm
105.8mm
216.2mm130.8mm
160mm9 5.4mm95mm
125.4mm
2
2
2
2
11
1
ItemLabeLDescrIptIonsee page
1Adjustable FeetRaise or lower the feet to level the projector.13
2Ceiling support 
holes
Contact your dealer for information on mounting the projector on 
a ceiling.
viii-ix
Note: 
•	When installing, ensure that you use only UL Listed ceiling mounts. 
•	For ceiling installations, use approved mounting hardware and M6 x 4 scr\
ews with a maximum 
screw depth...

— 7 — 
DLP Projector — Owner’s Manual
Remote Control Parts 
ONOFF
213
546
879
GammaBrightCont.PIP
0InfoMode
AutoSource
MenuExit
Hot KeyShutter(AV Mute)Patter n
FocusLens H
Lens V
Keystone  H
Keystone  V
Zoom
Enter
1
3
4
7
14
15
10
11
12
13
8
9
6
5
2
16
17
18
19
24
22
23
20
21
Important:
1.	Avoid	using	the	projector	with	bright	fluorescent	lighting	turned	on.	Certain	high-frequency	
fluorescent	lights	can	disrupt	remote	control	operation.
2. Be sure nothing obstructs the path between the remote control...

— 8 — 
DLP Projector — Owner’s Manual
ItemLabeLDescrIptIonsee page
1Power onTurn projector ON.12
2Number KeysEnter a number (such as PIN code) or source hotkey.
Source Hotkey Key:
1: VGA
2: HDMI
3: Component
4: HDBaseT
5: Video
6: DVI-D
-
3InfoDisplay source image information.-
4AutoAutomatically optimize image.-
5Enter• Select a highlighted menu item.
• Change or accept a value.
19
6Arrow Keys• Adjust a setting UP or DOWN.
• Navigate within a menu.
19
7MenuDisplay menus.19
8GammaAdjust mid-range...

— 9 — 
DLP Projector — Owner’s Manual
Remote Control Operating Range  
The remote control uses infrared transmission to control the projector. It is not necessary to point the 
remote directly at the projector. Provided you are not holding the remote perpendicular to the sides or \
the rear of the projector, the remote will function well within a radius of about 7 meters (23 f\
eet) and 15 
degrees above or below the projector level. If the projector does not re\
spond to the remote control, move 
a...

— 10 — 
DLP Projector — Owner’s Manual
Setup and OperatiOn 
Installing the Projection Lens
Before setting up the projector, install the projection lens on the projector.
Important: 
•	Before installation, check where the projector is used and prepare a sui\
table lens.
•	For details, contact the sales dealer where you purchased the projector.
1. Turn the projector off. Allow the projector to cool down into standby mode.
2. Rotate the lens ring counter-clockwise and then 
remove it from the projector. 
3....

— 11 — 
DLP Projector — Owner’s Manual
5. While pulling the rejection pin, rotate the lens clockwise 
to lock the lens in place. Then release the rejection pin.  
6. Replace the lens ring.    

— 12 — 
DLP Projector — Owner’s Manual
Starting and Shutting down the Projector
Turn the Projector On
1. Connect the power cord to the projector. Then connect the other end to a wall outlet.  
The Power button on the built in keypad is illuminated.
Important: 
Make sure that the Power switch is in the ON position.
2. Turn on the connected devices.
3. Turn on the projector by pressing “” on the remote control  
or press “” on the built-in keypad. The Power LED is  
Blue with steady light. 
The projector...

— 13 — 
DLP Projector — Owner’s Manual
Adjusting the Projector Level
Take note of the following when setting up the projector:
• The projector table or stand should be level and sturdy.
• Position the projector so that it is perpendicular to the screen.
• Ensure the cables are in a safe location. You could trip over them.
B
A
1. To raise the level of the projector, lift the projector A.
2. Locate the adjustable foot you wish to modify on the underside of the pr\
ojector.
3. Rotate the adjustable foot...

— 14 — 
DLP Projector — Owner’s Manual
Adjusting the Zoom, Focus, and Keystone
1. Use the Zoom button to resize the projected  
image and screen size B.
2. Use the Focus button to sharpen the  
projected image A.
3. Use the Keystone H buttons (on the remote control) to adjust the keystone  
horizontally and make a squarer image. Use the Keystone V buttons (on the  
remote control) to adjust keystone vertically and make a squarer image.
A
B
Hot KeyShutter(AV Mute)Pattern
FocusLens H
Lens V
Keystone H...

— 15 — 
DLP Projector — Owner’s Manual
Adjusting the Projecting image’s Position
To determine where to position the projector, consider the size and shape of your screen, the location of 
your power outlets, and the distance between the projector and the rest \
of your equipment.
HH
H0
V
V
V0
project
Ion Lens:  n /a
p
LatformH V
0.7” XGA 15%50%
0.67” WUXGA 15%50%
projectIon Lens:  n /a
p
LatformH V
0.7” XGA 15%35%
0.67” WUXGA 15%50%