Eiki Eip-1 Multimedia Projector Owners Instruction Manual

20
5.4 Display (Video mode) 
 
 
 
 
Submenu   Purpose   Using 
Keystone  To modify the biased 
image resulting from the 
improper angle of 
projector. Press 

21  
User Blue 
To adjust the Blue color.Press 

22
5.5 Audio 
 
 
 
Submenu    Purpose or Using 
Vo l u m e   Press 

23
5.6 Management 
 
 
Submenu   Purpose   Using 
OSD Location To display the position of menu on 
the screen. Press 

24 Lamp Reset To recount hours after replacing   
the lamp. Press the right key. The 
message “Press Enter key 
to confirm lamp reset 
operation!” appears. Please 
check if the user has 
replaced the new lamp. If 
yes, press Enter key. If not, 
press Menu key or Esc key 
on the remote controller to 
quit. 
Auto Adjust For end users to fix the brightness 
and contrast settings. This function 
only works in the VGA mode. Choose Ye s. The values of brightness and contrast vary 
each time when pressing...

25
6.1 Replacing the lamp 
30 hours before the end of the lamp’s life time, the warning message “Lamp life 
time is up! Replacement suggested!” will display on the screen. Please replace the 
lamp immediately. 
 
Steps: 
1. Power off the projector. 
2. Unplug the power cord. 
3. Cool down projector for at least 30 minutes. 
4. Use a screwdriver to remove the shell and screws on the lamp. 
5. Remove lamp. 
6. Gently process the new lamp module into the lamp bay, then replaces the lamp 
module retaining...

26
7. Appendix 
7.1 Common problems and trouble-shooting 
If you are having a problem with your projector, please check the following: 
If you still cannot solve the problem, please contact your local distributor or our 
service center. 
 
Q.: No image on the screen at all? 

27 Q.: Image becomes blurred 

28
7.2 Specifications  
 
 
 
 Model No. 
EIP-1 
Resolution  XGA (1024*768) 
Size  229 x 193 x 69 mm 
We i g ht   3.5 lbs 
Lamp  150W VIP 
Brightness 1400 Lumens 
Projection distance 1.45m ~10m 
Throw Ratio 1.34:1 ~ 1.6:1 (Distance: Diagonal) 
Zoom Ratio 1.2:1 (Manual Zoom/Focus) 
Uniformity 85% 
Aspect Ratio 4:3 / 16:9 screen selectable 
Contrast Ratio 900:1 
Horizontal Frequency31.5 - 80 kHz 
Vertical Scan Rate 56 - 85 Hz 
Video compatibility 
NTSC / PAL 
VGA compatibility RGB/DVD 480P, HDTV...

29  
Input Terminal   
y DVI (M1DA) y USB y RGB (M1DA-D-Sub 15 pin)
y RS232 (M1DA) y YPbPr (M1DA,VGA)y S-Video Mini DIN 4 pin 
y Audio: RCA Jacky 3.5mm Mini Jack y Composite Video (RCA Jack)
 
Output Terminal   
y 1 watt speaker 
 
* All specifications are subject to change without notice. 
 
 
 
This device complies with Part 15 of the FCC Rules. Operation is subject to the 
following two conditions: (1) the device may not cause harmful interference, and 
(2) this device must accept any interference...