Dyson Dc 3 Manual

DYSON CUSTOMER HELPLINE
0990 275104
DCO3 Operating Manual
8am to 8pm, 7 DAYS A WEEK 

Wand 
ShroudAdaptive 
Brush
ControlCover cap/
storage hook
Cable winder
Hose
Blockage removal
cassette  Bin release catch
Fit tools to hose
for car cleaning
Push button to release
or replace wand
On/off 
switch
Tool location
Lower cable winder
Wand 
release catch
Post-motor filterTwist ring
Quick release
window Bin innerCyclone 
assemblyCyclone 
release catch
Blockage removal
cassette catch
DCO3 quick reference page
Carrying handle
brush 
OFF
for use on delicate rugs and floors.    
Manually...

Filters and blockages
Rotate twist ring to the left to release
filter case.
Remove filter case from machine body.
1
2
1
2
34
34
Lift out pre-filter using handle
(replace at least every 12 months).Remove wand from hose and look
down the wand to check for daylight.
Locate blockage removal cassette catch
at base of hose location.2
Pull back catch, remove cassette and
check for blockage. To replace, position
at 45
0 and click catch back into place.
Remove Cyclone assembly to check
Cyclone entry and duct.
2...

Bin emptying and brushbar
If ratchet warning noise continues, stop
vacuuming, turn off the machine and
unplug. To free the brushbar, lie the
machine on its front to reveal the soleplate.
1
2
3
4
Using a coin, undo the three yellow
fasteners.Push bin release catch forward to free
the bin.
Wrap a plastic bag firmly around the
rim of the clear bin and empty (wait
ten seconds to allow dust to settle).To clean bin, wash in warm water. Do
not remove bin inner and seals, and
ensure bin is dry before...

DYSON CUSTOMER CARE
If you call before 11.00 am (monday to friday), your cleaner will be collected after 12 noon that day. Our aim is to courier your
cleaner back to the Dyson factory and return it to you repaired and tested within 48 hours. The service may take a little longer
in some areas, such as the Highlands and Islands.todayIf you have any questions about your Dyson, we do not want you to be put out in any
way. All you have to do is call the Dyson Customer Helpline on 0990 275104from
8am to 8pm,...

Check that your supply corresponds to that shown on the rating plate. The
appliance must only be used as rated, and it should be fitted with an approved 
fuse to BS1362. This appliance is supplied with a moulded three pin mains plug 
for your safety and convenience. A 13 amp fuse is fitted in this plug. Should the
fuse need to be replaced, please ensure that the replacement fuse has a rating 
of 13 amps and that it is approved by ASTA or BSI to BS1362. Check for the ASTA
mark or the BSI mark on the body...