Dukane Imagepro 9135 Portable Lcd Projector Users Manual
Here you can view all the pages of manual Dukane Imagepro 9135 Portable Lcd Projector Users Manual. The Dukane manuals for Projector are available online for free. You can easily download all the documents as PDF.
Page 51
![Page 51
49
Projector
9135
9135
Users Manual - Operating Guide
Users Manual - Operating Guide
TECHNICAL
Dimensions
Dimensions
210
420
85.5 (at the bottom of lens position) to 92.99 (at the top of lens po\
sition)
160150 320
73
[unit: mm]
IN TE RIN P
U TM1
-
DRGBBNG
S -VIDEOST
ANDBY /
O NT
E MPVIDE
OCOMPO N
EN
TLA
MPKEYST ONESEA
RCHRE
SETME
N
UFOCUSLE N
S SHIF TZO O
M](http://img.usermanuals.tech/thumb/5762/88802/w300_dukane-imagepro-9135-manual_d-50.png "Page 51
49
Projector
9135
9135
Users Manual - Operating Guide
Users Manual - Operating Guide
TECHNICAL
Dimensions
Dimensions
210
420
85.5 (at the bottom of lens position) to 92.99 (at the top of lens po\
sition)
160150 320
73
[unit: mm]
IN TE RIN P
U TM1
-
DRGBBNG
S -VIDEOST
ANDBY /
O NT
E MPVIDE
OCOMPO N
EN
TLA
MPKEYST ONESEA
RCHRE
SETME
N
UFOCUSLE N
S SHIF TZO O
M")
49 Projector 9135 9135 Users Manual - Operating Guide Users Manual - Operating Guide TECHNICAL Dimensions Dimensions 210 420 85.5 (at the bottom of lens position) to 92.99 (at the top of lens po\ sition) 160150 320 73 [unit: mm] IN TE RIN P U TM1 - DRGBBNG S -VIDEOST ANDBY / O NT E MPVIDE OCOMPO N EN TLA MPKEYST ONESEA RCHRE SETME N UFOCUSLE N S SHIF TZO O M
Page 52
![Page 52
50•
Be sure to check jack type, signal level, timing and resolution before
connecting this projector to a computer.
•Some computers may hove multiple display screen modes. Use of some of th\
ese
modes will not be possible with this projector.
•Depending on the input signal, full-size display may not be possible in \
some cases.
Refer to the number of display pixels above.
•Although the projector can display signals with resolution up to UXGA (\
1600 x 1200),
the signal will be converted to the...](http://img.usermanuals.tech/thumb/5762/88802/w300_dukane-imagepro-9135-manual_d-51.png "Page 52
50•
Be sure to check jack type, signal level, timing and resolution before
connecting this projector to a computer.
•Some computers may hove multiple display screen modes. Use of some of th\
ese
modes will not be possible with this projector.
•Depending on the input signal, full-size display may not be possible in \
some cases.
Refer to the number of display pixels above.
•Although the projector can display signals with resolution up to UXGA (\
1600 x 1200),
the signal will be converted to the...")
50• Be sure to check jack type, signal level, timing and resolution before connecting this projector to a computer. •Some computers may hove multiple display screen modes. Use of some of th\ ese modes will not be possible with this projector. •Depending on the input signal, full-size display may not be possible in \ some cases. Refer to the number of display pixels above. •Although the projector can display signals with resolution up to UXGA (\ 1600 x 1200), the signal will be converted to the...
Page 53
![Page 53
51
Initial Set Signals
Initial Set Signals
The following signals are used for the initial settings. The signal timi\
ng of some computer
models may be different. In such case, adjust the items V POSITION and H\
POSITION in
the PICTURE-2 menu.
DATA
H. Sync.V. Sync.
DATADisplay interval c
Back porch b
Sync. a Front porch d
Display interval c
Back porch b
Sync. a Front porch d
Computer /
SignalHorizontal signal timing (µs)
abcd
TEXT2.03.020.31.0
VGA (60Hz)3.81.925.40.6
Mac 13mode2.13.221.22.1
VGA...](http://img.usermanuals.tech/thumb/5762/88802/w300_dukane-imagepro-9135-manual_d-52.png "Page 53
51
Initial Set Signals
Initial Set Signals
The following signals are used for the initial settings. The signal timi\
ng of some computer
models may be different. In such case, adjust the items V POSITION and H\
POSITION in
the PICTURE-2 menu.
DATA
H. Sync.V. Sync.
DATADisplay interval c
Back porch b
Sync. a Front porch d
Display interval c
Back porch b
Sync. a Front porch d
Computer /
SignalHorizontal signal timing (µs)
abcd
TEXT2.03.020.31.0
VGA (60Hz)3.81.925.40.6
Mac 13mode2.13.221.22.1
VGA...")
51 Initial Set Signals Initial Set Signals The following signals are used for the initial settings. The signal timi\ ng of some computer models may be different. In such case, adjust the items V POSITION and H\ POSITION in the PICTURE-2 menu. DATA H. Sync.V. Sync. DATADisplay interval c Back porch b Sync. a Front porch d Display interval c Back porch b Sync. a Front porch d Computer / SignalHorizontal signal timing (µs) abcd TEXT2.03.020.31.0 VGA (60Hz)3.81.925.40.6 Mac 13mode2.13.221.22.1 VGA...
Page 54
52 • Video signal: RGB separate, Analog, 0.7 Vp-p, 75 Ω terminator (positive) • H./V. sync. Signal: TTL level (positive/negative) • Composite sync. Signal: TTL level D-Sub 15 pin shrink jack Connection T Connection T o The Ports o The Ports PinSignalPinSignalPinSignal1Video input Red6Ground Red--2Video input Green7Ground Green=SDA (DDC)3Video input Blue8Ground BlueqH./Composite sync.4-9-wV. sync.5Ground0GroundeSCL (DDC) A RGB 54321 67890 ewq=- • Type: T.M.D.S. • Amplitude differential: DC 150-1200 mV /...
Page 55
53 Connection T Connection T o The Ports (continued) o The Ports (continued) • Video signal: RGB separate, Analog, 0.7 Vp-p, 75 Ω terminator (positive) • H./V. sync. Signal: TTL level (positive/negative) • Composite sync. Signal: TTL level D-Sub 15 pin shrink jack PinSignalPinSignalPinSignal1Video output Red6Ground Red--2Video output Green7Ground Green=-3Video output Blue8Ground BlueqH./Composite sync.4-9-wV. sync.5Ground0Grounde- L RGB OUT 54321 67890 ewq=- Mini Din 4 pin jack 12 34 I VIDEO IN • RCA...
Page 56
54 Connection T Connection T o The Ports (continued) o The Ports (continued) VIDEOR-AUDIO IN-L S-VIDEOBNC RGB AUDIO IN1 AUDIO IN2 RGB OUTAUDI O OUT R/C R/PRG/Y B/CB/PBHV Y CONTROL NETWORK CR/PR Ca/Pa REMOTE CONTROL GF D-Sub 9 pin plug CONTROL port FCONTROL G NETWORK • RJ-45 (10BASE-T) jack 123456789 Computer side D-Sub 9 pin jack 543219876 123456789 RD- TD - - GND - CTS RTS123456789 CD RD TD DTR GND DSR RTS DTS RI D-Sub 9 pin jack 543219876 D-Sub 9 pin plug RS-232C port 123456789...
Page 57
![Page 57
55
RS-232C Communication
RS-232C Communication
Connecting The Cable
Turn off the projector and the computer power supplies.
Connect the CONTROL port of the projector with a RS-232C port of the com\
puter by
a RS-232C cable. Use the cable that fulfills the specification shown in \
the previous
page. Turn on the computer power supply and after the computer has started up,\
turn on
the projector power supply.1
2
3
19200bps, 8N1
1. Protocol
Consist of header (7 bytes) + command data (6 bytes).
2. Header
BE...](http://img.usermanuals.tech/thumb/5762/88802/w300_dukane-imagepro-9135-manual_d-56.png "Page 57
55
RS-232C Communication
RS-232C Communication
Connecting The Cable
Turn off the projector and the computer power supplies.
Connect the CONTROL port of the projector with a RS-232C port of the com\
puter by
a RS-232C cable. Use the cable that fulfills the specification shown in \
the previous
page. Turn on the computer power supply and after the computer has started up,\
turn on
the projector power supply.1
2
3
19200bps, 8N1
1. Protocol
Consist of header (7 bytes) + command data (6 bytes).
2. Header
BE...")
55 RS-232C Communication RS-232C Communication Connecting The Cable Turn off the projector and the computer power supplies. Connect the CONTROL port of the projector with a RS-232C port of the com\ puter by a RS-232C cable. Use the cable that fulfills the specification shown in \ the previous page. Turn on the computer power supply and after the computer has started up,\ turn on the projector power supply.1 2 3 19200bps, 8N1 1. Protocol Consist of header (7 bytes) + command data (6 bytes). 2. Header BE...
Page 58
![Page 58
56
RS-232C Communication (continued)
RS-232C Communication (continued)
Requesting projector status (Get command)(1) Send the request code Header + Command data (‘02H’+‘00H’+ t\
ype (2
bytes)+‘00H’+‘00H’) from the computer to the projector.
(2) The projector returns the response code ‘1DH’+ data (2 byte\
s) to the computer.
Changing the projector settings (Set command)(1) Send the setting code Header + Command data (‘01H’+‘00H’+ t\
ype (2 bytes) + setting code (2 bytes)) from the computer to the...](http://img.usermanuals.tech/thumb/5762/88802/w300_dukane-imagepro-9135-manual_d-57.png "Page 58
56
RS-232C Communication (continued)
RS-232C Communication (continued)
Requesting projector status (Get command)(1) Send the request code Header + Command data (‘02H’+‘00H’+ t\
ype (2
bytes)+‘00H’+‘00H’) from the computer to the projector.
(2) The projector returns the response code ‘1DH’+ data (2 byte\
s) to the computer.
Changing the projector settings (Set command)(1) Send the setting code Header + Command data (‘01H’+‘00H’+ t\
ype (2 bytes) + setting code (2 bytes)) from the computer to the...")
56 RS-232C Communication (continued) RS-232C Communication (continued) Requesting projector status (Get command)(1) Send the request code Header + Command data (‘02H’+‘00H’+ t\ ype (2 bytes)+‘00H’+‘00H’) from the computer to the projector. (2) The projector returns the response code ‘1DH’+ data (2 byte\ s) to the computer. Changing the projector settings (Set command)(1) Send the setting code Header + Command data (‘01H’+‘00H’+ t\ ype (2 bytes) + setting code (2 bytes)) from the computer to the...
Page 59
57 RS-232C Communication (continued) RS-232C Communication (continued) Command Data Chart NamesOperation typeHeaderCommand data CRCActionTypeSetting code Keystone V GetBE EF0306 00B9 D302 0007 2000 00 IncrementBE EF0306 00DF D304 0007 2000 00 DecrementBE EF0306 000E D205 0007 2000 00 Keystone V ResetExecuteBE EF0306 0008 D006 000C 7000 00 Keystone H GetBE EF0306 00E9 D002 000B 2000 00 IncrementBE EF0306 008F D004 000B 2000 00 DecrementBE EF0306 005E D105 000B 2000 00 Keystone H ResetExecuteBE EF0306...
Page 60
58 RS-232C Communication (continued) RS-232C Communication (continued) Command Data Chart (continued) NamesOperation typeHeaderCommand data CRCActionTypeSetting code LanguageSet ENGLISHBE EF0306 00F7 D301 0005 3000 00 FRANÇAISBE EF0306 0067 D201 0005 3001 00 DEUTSCHBE EF0306 0097 D201 0005 3002 00 ESPAÑOLBE EF0306 0007 D301 0005 3003 00 ITALIANOBE EF0306 0037 D101 0005 3004 00 NORSKBE EF0306 00A7 D001 0005 3005 00 NEDERLANDSBE EF0306 0057 D001 0005 3006 00 PORTUGUÊSBE EF0306 00C7 D101 0005 3007 00 \fÔŠ...