Dukane Imagepro 8979wu Users Manual

10
Adjusting the projector’s elevator
When the place to put the projector is slightly uneven to 
the left or right, use the elevator feet to place the projector 
horizontally. Using the feet can also tilt the projector 
in order to project at a suitable angle to the screen, 
elevating the front side of the projector within 9 degrees.
This projector has 2 elevator feet and 2 elevator buttons. 
An elevator foot is adjustable while pushing the elevator 
button on the same side as it.
1. 
Holding the...

11
ENGLISH
CAUTION  ►If you wish to have a blank screen while the projector's lamp is 
on, use the lens shade or AV MUTE function (see User’s Manual - Operating 
Guide ). Taking any other action may cause the damage on the projector.
NOTE  •  The ASPECT button does not work when no proper signal is inputted.
•  There may be some noise and/or the screen may fl icker for a moment when an 
operation is made. This is not a malfunction.
• For the details of how to adjust the picture, please see  User’s...

12
Turning off  the power
1. Press the STANDBY/ON button on the 
projector or the STANDBY button on 
the remote control. 
The message “Power off?” will appear   
on the screen for about 5 seconds.
2. Press the STANDBY/ON or STANDBY 
button again while the message 
appears. 
The projector lamp will go off, and the 
POWER indicator will begin blinking in 
orange. Then the  POWER indicator will 
stop blinking and light in steady orange 
when the lamp cooling is complete.
3. Attach the lens cover, after the...

13
ENGLISH
Replacing the lamp
A lamp has finite product life. Using the lamp for long periods of time could cause 
the pictures darker or the color tone poor. Note that each lamp has a different 
lifetime, and some may burst or burn out soon after you start using them\
. 
Preparation of a new lamp and early replacement are recommended. To prepare 
a new lamp, make contact with your dealer and tell the lamp type number.
Type number : 
1. Turn the projector off, and unplug the power cord. Allow the...

14
 HIGH VOLTAGE HIGH TEMPERATURE HIGH PRESSURE
WARNING  ►The projector uses a high-pressure mercury glass lamp. The 
lamp can break with a loud bang, or burn out, if jolted or scratched, ha\
ndled 
while hot, or worn over time. Note that each lamp has a different lifetime, and 
some may burst or burn out soon after you start using them. In addition,\
 if the 
bulb bursts, it is possible for shards of glass to fly into the lamp housing, and 
for gas containing mercury and dust containing fine particles...

15
ENGLISH
Please check and clean the air filter periodically. When the indicators or a 
message prompts you to clean the air filter, comply with it as soon as possible.
The filter unit with 2 sheets of filters is inside of the filter cover. In addition, the extra 
air filter is attached to inner side of the filter cover. If one of the filters is damaged 
or heavily soiled, replace whole filter set with a new one.
Request for a filter set with the following type number from your dealer when 
purchasing a...

16
NOTE  • Please reset the filter time only when you have cleaned or replaced 
the air filter, for a suitable indication about the air filter.
• The projector may display the message such as the “CHECK THE AIR 
FLOW” or turn off the projector, to prevent the internal heat level rising.
WARNING   ► Before taking care of the air filter, make sure the power 
cable is not plugged in, then allow the projector to cool sufficiently .
►Use only the air filter of the specified type. Do not use the projector...

17
ENGLISH
Using the CD manual
The other manuals for this product are written into the included CD-ROM \
titled 
“User’s Manual (detailed)”. Before using the CD-ROM, please read the following 
to ensure the proper use. 
 System requirements
The system for using the CD-ROM requires the following. 
  Windows®:  OS:Windows® XP, Windows Vista®, Windows® 7 or later
  Macintosh®: OS:Mac OS® 10.2 or later
  CD-ROM/DVD-ROM drive
  Applications:
   Microsoft® Internet Explorer®6.0 and
 Adobe® Acrobat® Reader® 8.0...

18
ItemSpecification
Product name Liquid crystal projector
Liquid Crystal 
Panel 
:
  
786,432 pixels (1024 horizontal x 768 vertical)
::
  
1,024,000 pixels (1280 horizontal x 800 vertical)
:8
:   
2,304,000 pixels (1920 horizontal x 1200 vertical)
Lamp 365W UHP
Power supply, 
Rated current AC100-120 V: 5.1 
A, AC220-240 V: 2.5 

A
Power 
consumption AC100-120 V: 500 W, AC220-240 V: 480 W
Temperature 
range 0 ~ 45 °C (Operating)
* When the projector is used at high altitudes, the service...

19
ENGLISH
ItemSpecification
Ports COMPUTER IN1 
 ..........................
 D-sub 15 pin mini jack x1
COMPUTER IN2 (H, V, G/Y, B/Cb/Pb, R/Cr/Pr)  ... BNC jack x5
HDMI 1  ...................................................  HDMI connector x1
HDMI 2 
 ...................................................  HDMI connector x1
MONITOR OUT 
 .............................  D-sub 15 pin mini jack x1
COMPONENT (Y, Cb/Pb, Cr/Pr) 
 .......................  RCA jack x3
S-VIDEO...