Dukane Imagepro 8038 User Guide

 20LCD Projector User Guide
Troubleshooting
Power Indicator
The power indicator on the keypad provides you with information about the
condition of the projector.
      Light Status                                  Condition
Lamp is off but live power cord is connected to
the projector.
Projector is in standby mode.
OR
Lamp is off and fan is running.
Projector is cooling down.
Lamp is on and fan is running.
Projector is ready.
Scaling chip is malfunctioning.
RAM is malfunctioning.
I2C bus is...

 21Image Quality
Problem
Color or text is not being
projected.
Some text or fonts are not
sharp with a computer as
an image source.
Image isn’t centered on the
screen.
Image is out of focus.
Image and menus are
upside down.
Image and menus are
reversed from left to right.
Image appears flat with no
contrast
Image appears washed out
or darkSolution
Adjust the brightness up or down until the text is
visible.
For optimal results, set the computer’s resolu-
tion to 800 x 600. (Refer to your computer user...

 22LCD Projector User Guide
Problem
Image is “noisy” or
streaked.
Image is wider at the
top or bottom of the
screen.
Image is wider at one
side than the other
Projected colors
don’t match the
computer or video
source colors.Solution
• From the Setup tab in the menus, adjust the frequency
and tracking manually to find an optimal setting.
• Try connecting to another computer. The problem
could be with your computer’s video card.
This keystoning effect is caused by the projection angle
not being...

 23Remote Control
Problem
Projector responds poorly
or not at all to the remote
control.Cause and Solution
• Make sure that the total distance from the
remote to the projector is no more than 32 feet
(10 m).
• Point the remote control at the screen or at the
front of the projector.
• Make sure nothing is blocking the infrared
sensor on the front of the projector.
• Darken the room. The lighting might be
effecting the remote control.
• Replace the remote control batteries.Lamp
Problem
No light is coming...

 24LCD Projector User Guide
  Image Source
Problem
The S-Video image source
does not appear.
Only the start-up screen
appears and not the image
from the image source.
The image source is
connected but a No Signal
message appears.
MFG Mode screen appears
instead of the image.Cause and Solution
Some inexpensive cables are not compatible with
the projector. Be sure to use the cable that came
with your projector.
• Verify that the cables are connected correctly.
See “Connecting the Projector” on page 7.
•...

 25Safety
These safety precautions include information to prevent personal injury and
damage to the projector.
Safety Definitions
Warning: Statements identify conditions or practices that could result in
personal injury.
Caution: Statements identify conditions or practices that could result in
damage to your equipment.
                 Warning: For information about use of a feature, please refer to
                 this  User Guide.
                Warning: Hot surface. Do not touch.
Projector Safety...

 26LCD Projector User Guide
Caution: Never operate your projector without the lamp module or lamp
module door. Doing so may damage the projector.
Caution: Proper ventilation is important. Don’t block ventilation openings.
Never operate this projector in an enclosed area. Do not place the projector on
a tablecloth or other soft covering that may block the vents. With ceiling
installations, use approved mounting hardware. Do not put the projector near
heat ducts, air cleaners, transformers or other...

 27Specifications
Specification
Weight in lbs. (kg)
Dimensions (inches) (WxDxH)
Dimensions (mm) (WxDxH)
Color Palette
Resolution
XGA compression(1024 x 768)
Three 0.9” panel
polysilicone LCD
Projection lamp
Lamp life
User-replaceable lamp
Brightness (ANSI lumens -
based on industry
specification practices)
Contrast ratio (Full On/Off)
Projection Distances/
Image Sizes
Projection Lens
Zoom Factor
Aspect Ratio
Audio (built in)
Video Compatibility –
NTSC/NTSC 4.43
PAL B/D/G/H/I/K/L/N/M
SECAM B/D/G/H/K/L...

 28LCD Projector User Guide
Fixed lens model
Yes
Yes
Yes
Yes
100-240
50-60
Yes
195
0-35º C
-20-70º C
10-95%
0 - 10,000 ft
0 - 3,048 m
0 - 40,000 ft
0 - 12,192 mZoom lens model
Yes
Yes
Yes
Yes
100-240
50-60
Yes
195
0-35º C
-20-70º C
10-95%
0 - 10,000 ft
0 - 3,048 m
0 - 40,000 ft
0 - 12,192 mSpecification
Connections on projector
Analog RGB (15 Pin HD)
Composite video (RCA)
Stereo Audio (1/8” mini-plug)
S-video
Power Supply
Voltage (AC RMS)
Frequency (Hz)
Auto Sense
Typical Power Consumption (watts)...

 29