Digital Projection Titan Wuxga 3d , Dual 3d, Titan Wuxga 330, 660 User Manual

Rev A  April 2011 Page 7.13
Digital Projection TITAN WUXGA 3D, Dual 3D, 330. 660 User Manual 7. Appendix
8. DVI-D Single/Dual/Twin input
24 way D-type connector
1 TMDS Data 2-
2 TMDS Data 2+
3 TMDS Data 2/4 Shield
4 TMDS Data 4-
5 TMDS Data 4+
6 DDC Clock
7 DDC Data
8 unused
9 TMDS Data 1-
10 TMDS Data 1+
11 TMDS Data 1/3 Shield
12 TMDS Data 3-
13 TMDS Data 3+
14 +5 V Power
15 Ground
16 Hot Plug Detect*
17 TMDS Data 0-
18 TMDS Data 0+
19 TMDS Data 0/5 Shield
20 TMDS Data 5 -
21 TMDS Data 5+
22 TMDS Clock...

Page 7.14 Rev A  April 2011
7. Appendix Digital Projection TITAN WUXGA 3D, Dual 3D, 330. 660 User Manual
Control connections
Wired Remote control connection
3.5mm mini jack
Tip  Power
Ring Signal
Sleeve Ground
LAN connection
TCP Port number 
10001
Wireless 
802.11b/g 
10BaseT Unshielded Twisted Pair cable
The standard wire colours as as follows:
1  White / Orange stripe
2 Orange
3 White / Green stripe
4 Blue
5 White / Blue stripe
6 Green
7 White / Brown stripe
8 Brown
Crossed cable
(used to connect...

Rev A  April 2011 Page 7.15
Digital Projection TITAN WUXGA 3D, Dual 3D, 330. 660 User Manual 7. Appendix
3D sync
1 unused
2 Sync OUT
3 GND
4 GND
5 GND
6 unused
7 unused
8 unused
9 Sync IN
Serial control input
1 unused
2 Received Data (RX)
3 Transmitted Data (TX)
4 unused
5 Signal Ground
6 unused
7 unused
8 unused
9 unused
Null-modem cable
(used to connect the projector to a computer)
RX  2 --- 3 TX
TX 3 --- 2 RX
GND 5 --- 5 GND
Serial port settings
Baud rate  19,200 bps
Data length 8 bits
Stop bits one...

Page 7.16 Rev A  April 2011
7. Appendix Digital Projection TITAN WUXGA 3D, Dual 3D, 330. 660 User Manual
Remote communications protocol
Version: Revision L 12/10/10
Introduction
This protocol document covers all projectors in the Titan series and also the 
Lightning integrated series.
Only one remote connection (RS232, LAN or Wireless LAN) should be used at any 
one time.
Following the transmission of a command, the control system must wait to receive 
the complete reply before sending a new command.
It...

Rev A  April 2011 Page 7.17
Digital Projection TITAN WUXGA 3D, Dual 3D, 330. 660 User Manual 7. Appendix
Operation Messages
Operation messages are constructed using the following format:
HeaderTypeSize CRCOper’n 
typeOperation
Reserved
2 bytes 1 byte2 bytes 2 bytes1 byte2 bytes 2 bytes
Data BEEF03190058580000000000
Byte # 123456789101112
Operation Target Operation ValueReserved
4 bytes 4 bytes4 bytes
Data 000000000000000000000000
Byte # 131415161718192021222324
Reserved Reserved
4 bytes 4 bytes
Data...

Page 7.18 Rev A  April 2011
7. Appendix Digital Projection TITAN WUXGA 3D, Dual 3D, 330. 660 User Manual
Notes
 The following pages contain 
examples of some basic 
Operation commands.
  For full details of all the For 
full details of all the Operation 
commands and Enhanced 
commands, contact Digital 
Projection and ask for a copy 
of the Titan Projector Series 
External Control Protocol.
Enhanced Messages
Enhanced messages are constructed using the following format:
Header TypeSize CRCData typeData...

Rev A  April 2011 Page 7.19
Digital Projection TITAN WUXGA 3D, Dual 3D, 330. 660 User Manual 7. Appendix
Operation Command examples
All operation commands are located at bytes 9 &10.
All values are located at bytes 17 & 18 unless otherwise indicated
Power  (0102)
Projector On or Standby
   Value
On   00h
Standby   04h
Examples
Set Projector (On)
BEEF  03   1900  5858  01  0102   0000  00000000  00000000  00000000  00000000  00000000
Response
1E  BEEF  03  1900  5858  01  0102   0000  00000000  00000000...

Page 7.20 Rev A  April 2011
7. Appendix Digital Projection TITAN WUXGA 3D, Dual 3D, 330. 660 User Manual
Source  (3702)
Projector source select
          Value
Input 1.RGB1   00h
Input 2. RGB2   01h
Input 3. DVI   02h
Input 4. SDI   03h (supported models only)
Input 5. Composite 04h
Input 6. SVideo   05h
Input 7. Component 06h
Input 8. DVI   07h (supported models only)
Examples
Set Source  (DVI)
BEEF  03  1900  5858  01  3702   0000  00000000  02000000  00000000  00000000  00000000
Response   
1E  BEEF...

Rev A  April 2011 Page 7.21
Digital Projection TITAN WUXGA 3D, Dual 3D, 330. 660 User Manual 7. Appendix
Brightness (E502)
Adjusts Brightness
Range:    -128 — +127 (00h - FFh)
Centre (0): 128 (80h)
 For information about Brightness, Presets and Input 8: 
see  Section 4, Overview .
Examples
Set Brightness  97    (128 + 97 = 225  =  E1h)
BEEF  03  1900  5858  01  E502   0000  00000000  E1000000  00000000  00000000  00000000
Response
1E  BEEF  03  1900  5858  01  E502   0000  00000000  E1000000  00000000...

Page 7.22 Rev A  April 2011
7. Appendix Digital Projection TITAN WUXGA 3D, Dual 3D, 330. 660 User Manual
Contrast (E602)
Adjusts Contrast
Range:    -128 — +127 (00h - FFh)
Centre (0): 128 (80h)
 For information about Contrast, Presets and Input 8: 
see  Section 4, Overview .
Examples
Set Contrast  97    (128 + 97 = 225  =   E1h)
BEEF  03  1900  5858  01  E602   0000  00000000  E1000000  00000000  00000000  00000000
Response
1E  BEEF  03  1900  5858  01  E602   0000  00000000  E1000000  00000000  00000000...