Digital Projection Projector IVision50-series User Manual

21
4.9 Lens planarity (Scheimpflug adjustment)
This adjustment is rarely needed, do not apply it unless it is required.
Certain applications require fine adjustment of the lens planarity in order to obtain an image 
that is focused. The projector is fitted with three adjustment screws (Allen key 3mm/5mm) 
around the bayonet mount that facilitate such adjustment, a so called Sche\
impflug adjust-
ment. Do not attempt adjusting without the required technical competence and refer to the 
service manual...

22iVision50-series  
User Manualal - Introduction
4.11 Making the connections
The projector is equipped with multiple signal and control interfaces to support various video 
and data sources (see connector panel below), as well as different control systems.
 
Always make sure that the projector is powered off before connecting any signal and/
or control cables.
Long cables may cause distorted or even failing signal quality. Always make sure best 
quality cables are used, and take into consideration the...

23
4.15 Image sizes
Lens types and specifications may change without prior notice.  
For correct lens information please refer to our website.
2560 x 1600 (WQXGA)
Ultra Wide Fixed (EN53)  0.79  (0.8 - 3.3m)
Wide Angle Fixed (EN52) 1.00 : 1 (1.0 -  10m)
Long Throw Zoom (EN54) 2.68 - 4.18 : 1 (5 – 25 m)Super Wide Zoom (EN55) 2.5 - 2.72  (0.8 - 5.0m)
Standard Zoom (EN51) 1.71 - 2.37 : 1 (1.5 - 10m)Wide Zoom (EN56) 2.5 -3.05 (1.3 - 7m)
Projection distance
Image width
 
Screen diagonal
15.00
13.75
12.50...

24iVision50-series  
User Manualal - IntroductioniVision50-series   
User Manual - Installation
english   

25
5 Overview
 
Figure 5-10. Projector front
Figure 5-11.  Projector rear
Figure 5-12.  Projector top
    
Remote Control ReceiverInterchangeable Projection Lens
Projection Lens Release Button
Mains Power Connector
Hot Air Exhaust
 
Signal and Control Connector Panel Remote Control Receiver
Keypad
english   

26User Manual - Introduction
Figure 5-13.  Mounting features
 
Figure 5-14. Projector left and right hand side
iVision50-series  
User Manual - Overview
Lamp Door Air Inlet
Ceiling/Rig Mounting Features
Accessory Mounting Features
english   

27
5.1 Keypad and indicator
Figure 5-15. Projector top key pad
KEYVALUE
POWER Power on or power off (standby)
MENU Activate or deactivate on-screen menu system
UP, DOWN, LEFT, RIGHT Select source when not in Shift or Menu mode Shift lens when not in Menu and after SHIFT/OK pressed
Navigate when in Menu system
SHIFT/OK Shift lens when not in menu system
Shift option when in menu system
AUTO Automatic set-up
STATUSCOLOR
On (active)Blue
Wait on Blue flashing
Standby (off)Yellow
Wait Yellow flashing
Lamp...

28User Manual - Introduction
5.2  Wireless remote control
Figure 5-16. Remote control
BUTTON FUNCTION
POWER Turns projector ON/OFF
INFOShows Status menu; info on numbers & versions, lamp info
*Activates the projector auto settings
SHIFT Activates lens shift function
#Reserved for future use
OK/ARROWS Confirms the selection / Directional navigation tools
BACK Returns to previous alternative
MENU Activates the projector menu
SOURCE Toggles between available sources (forward/backwards arrows)
SOURCE POWER...

29
5.3 Connectors
Figure 5-17. Connector panel (see technical data for details)
5.3.1 Signal connectors
CONNECTOR 
NAMECONNECTOR 
TYPEFUNCTION
HDBaseT RJ45
Video over twisted pair
DVI DVI-I*) dual link Digital video (dual-link)
HDMI HDMI type A Digital video
DP (Display Port) DP Digital video (2)
VGA 9 pin mini DSUB Analog RGBHV video
3G-SDI BNC 75 Ω Digital Video
*) the DVI connection is digital-only, although it uses the DVI-I physical connector for convenience
5.3.2 Contr ol connectors
CONNECTOR 
NAME...

30User Manual - Introduction
5.4 Menu system
The various projector-settings can be controlled via the on-screen menu system. The menu 
system is accessed by the keypad on the projector or using the wireless remote control.
Press the MENU key to enter or leave the menu system. Navigate the options\
 using the 
arrow-keys. Select option with the OK key.
The menu-system will be referenced throughout the user guide. Please familiarize yourself 
with the menus and the rich functionality provided.
5.4.1 Top...