Digital Projection Projector HIGHlite 740 Series User Manual

page 142
Reference Guide
APPENDIX F: GLOSSARY OF TERMS
SPDIF
Sony/Philips Digital Interface. A digital audio interface standard.
Synchronization
A timing signal used to coordinate an action.
TheaterScope
An aspect ratio used in conjunction with a special anamorphic lens to display 2.35:1 images packed into a 16:9 frame.
Throw distance
The distance between the screen and the projector.
Throw ratio
The ratio of the throw distance to the screen width.
TRC (Throw ratio correction)
A special number used in...

page 143
Reference Guide
APPENDIX F: GLOSSARY OF TERMS
Vertical Scan Rate
The rate at which the frames of the incoming signal are refreshed. The rate is set by the vertical synchronization from the source and 
measured in Hertz.
Vignetting
Optical cropping of the image caused by the components in the projection\
 lens.  This can happen if too much offset is applied when 
positioning the image using the lens mount.
Vista
An aspect ratio of 1.66:1.
Warp
A set of projector functions that allow you to...

page 144
Reference Guide
TECHNICAL SPECIFICATIONS
Technical Specifications
Digital Projection reserves the right to change product specifications without prior notice.
Models
The specifications on these pages refer to the following projectors:
Series name(s)ResolutionPart numberLumensContrast ratio
HIGHlite 740 
WUXGA
WUXGA114-6909,0002,000:1
HIGHlite 740 
1080p
1080p113-90110,0002,000:1
Color system:  3-chip DLP®
Display type:  3 x 0.67” DarkChip™ DMD™ (WUXGA)
    3 x 0.65” DarkChip™ DMD™ (1080p)
DMD...

page 145
Reference Guide
TECHNICAL SPECIFICATIONS
Inputs and outputs
TypeConnectorQtyTypeConnectorQty
Video & ComputerCommunication & Control
DVI-D / DVI-ADVI-I13D Sync OutBNC1
HDMI 1.3HDMI13D Sync InBNC1
3G-SDIBNC1LANRJ451
VGA / Analog RGB15-pin D-Sub1RS2329-pin D-Sub1
Component Video4 x BNC1Wired Remote In3.5 mm Stereo Jack1
S-Video4-pin Mini DIN1Wired Remote Out3.5 mm Stereo Jack1
Composite VideoRCA1Service PortUSB Type B1
Composite VideoBNC1
Audio
SPDIF Digital OutputRCA1
Bandwidth
• 170 MHz on...

page 146
Reference Guide
TECHNICAL SPECIFICATIONS
Lamps
Lamp typePart numberTypical lamp life 
(full power)
Typical lamp life 
(Eco mode)
2 x 370 W 
High Intensity Discharge114-303
1500 hours
Up to 3000 hours in 
lamp sequential mode
2000 hours
Up to 4000 hours in 
lamp sequential mode
Lenses
Detailed information about available lenses can be found in Appendix A: Lens Part Numbers.
Further information about lens offsets can be found in Positioning The Image > Maximum offset range.
Lens mount
• Motorised...

page 147
Reference Guide
TECHNICAL SPECIFICATIONS
Electrical and physical specifications
• Power requirements90-240 VAC, 50-60 Hz (single phase)
• Power Consumption950 W
• Thermal Dissipation3241 BTU/hr
• Fan Noise39 dBA
• Operating Temperature0°C to 40°C (32 to 104 F)
• Storage Temperature-20°C to 60°C (-4 to 140 F)
• Operating Humidity20% to 90% non-condensing
• Weight27 kg (60 lb)
• DimensionsL: 66.5 cm W: 50 cm H: 22 cm 
(L: 26.2 in. W: 19.7 in. H: 8.7 in.)
Safety & EMC regulations
• CE, FCC Class A...

Digital Projection Limited
Greenside Way, Middleton Manchester M24 1XX, UK
Registered in England No. 2207264 Registered Office: as above
Tel (+44) 161 947 3300 Fax (+44) 161 684 7674
[email protected] [email protected]
www.digitalprojection.co.uk
Digital Projection Inc.
55 Chastain Road, Suite 115 Kennesaw, GA 30144, USA
Tel (+1) 770 420 1350 Fax (+1) 770 420 1360
[email protected] www.digitalprojection.com
Digital Projection China
中国 北京市  朝阳区 芍药居北里101号...