DiBoss Lt 32hlfh Instruction Manual

TFT / LCD TV 
ENGLISH
Instruction Manual
LT-26HLFH/32HLFH
 

Warnings
WARNING : To prevent fire or shock hazard, do not expose the set to rain or moisture. Do not rub
or strike the Active Matrix LCD with anything hard as this may scratch, mar, or
damage the Active Matrix LCD permanently.
CAUTION:Unauthorised tampering with the inside of the TV invalidates the warranty.
The manufacturer shall not warrant for any damage caused by improper maintenance
and repair work by third parties.
Power(LT-26HLFH) Use only the AC-DC adaptor supplied with the set and never apply...

ENGLISH
223
ServiceNever remove the back cover of the TV, this can expose you to high voltage and
other hazards. If the TV does not operate properly, unplug it and call your dealer.
Connect the antenna cable to the connection marked Ant. (on the rear). For best
reception, use an outdoor antenna.
LocationPosition your TV so that no bright light or sunlight will shine directly on the screen. Do
not expose the TV to vibration, moisture, dust or heat. Also ensure that the TV is
placed in a position that...

Warnings2~3
Contents4
Supplied Accessories5
Installation6
Controls7~9
Controller of panel  7
Remote controller  8~9
Basic Operation 10
Turning the TV On and Off   10
Programme selection    10
Volume adjustment  10
Q.View   10
Sound mute function    10
On screen Language selection    10
On Screen Menus and Displays 11
Setting up TV Programme 12~15
Auto Programme    12
Manual Programme   13
Programme Edit  14
Picture Control 15
Manual picture control   15
Auto picture control  15
Sound Control 16~17
Other...

ENGLISH
5
Supplied Accessories
LMake Sure the following accessories are provided with Product.
1. AC/DC adaptor(LT-26HLFH)
3. Remote controller
5. Instruction manual 6. VGA cable 
7. PC Audio IN cable 4. Batteries (type AAA) 2. AC Cord
Model:LT
-26HLFH/32HLFH
Owner’s Manual
26 /32 WIDE LCD TV/MONITOR
 

6
Installation
Installation Options* You can install the TV on a wall or place it on a table-like surface.
* To eliminate any risk of injury from the TV falling, it should be mounted securely.
1. Wall InstallationCaution: Do not install the TV on a
weak wall surface, like plaster etc. 
When the TV is placed into a cupboard
the distance between the TV and the
wall have to leave minimum 60mm
square as below.
When the TV is mounted on the wall.,
the distance between the TV and the
wall have to leave minimum...

ENGLISH
227
Controls
1. DC IN(LT-26HLFH)
2. HDMI (High Definition Multimedia Interface) IN
Connect to the HDMI jack for device with HDMI output.
3. H/P (Headphone out)Connect a headphone to this socket.
4. PC AUDIO IN
Connect the audio cable from the PC to the PC AUDIO INof the set.
5. SVC portConnector for service only.
6. PC ANALOG IN (D-SUB)
7. S-VIDEO IN
Connect the output of the S -VIDEO on the VCR to the S-VIDEO input.
Connect the audio outputs of the S-VIDEO on the VCR to the Audio IN (L(MONO),...

228
Controls
All the functions can be controlled with the remote controller. Some functions can
also be adjusted with the buttons on the side panel of the set.  
Remote controllerBefore you use the remote controller, please install the batteries.  
1. POWERTurns the TV on from standby or off to standby mode.
2. MUTETurns the sound on and off.
3. NUMBER buttonsSelects programme numbers.
4. TV/AVSelects TV, SCART1,SCART2, S-VIDEO, 
RADIO(Only when the set is Radio On.), 
COMPONENT, PC ANALOG, HDMI mode....

ENGLISH
229
Controls
→→
Battery installation
uInserting batteries
1. Remove the battery cover by pulling it 
upward in the direction shown by the arrow.2. Insert the batteries with correct polarity 
3. Replace the battery compartment cover.
-Install two high-quality 1.5V AAA alkaline batteries. Dont mix old batteries with   
new batteries.
- Remove batteries when you wont use the remote controller for a long time. Liquid     
leakage from old batteries may cause operation failure.
uNotes for using remote...

2210
Turning the TV On and OffStandby Setup: The AC-DC adapter and the AC power cord
must be set up and connected to have the TV in standby mode
ready to be turned on. Press the ON/OFFbutton on the side
panel of the TV to go into standby mode.
1. If the TV is in standby mode, press the POWERbutton
on the remote controller or the TV itself to turn the TV on.
2. Press the Power button again on the remote controller or
the ON/OFFbutton the TV itself to turn the TV off.
Note: If the TV is on and the...