Home > Dell > Powervault > Dell Powervault Lto-3 Manual

Dell Powervault Lto-3 Manual

Add to Favourites

Download as PDF

View the Dell Powervault Lto-3 Manual for free. All the Dell manuals and user’s guides are available for free view without any registration. You can also download the manual as PDF to your computer.

Overview View all the pages Comments

Page 1 - 3 Autoloader Users Guide

Introduction
Installing the Autoloader
Operating the Autoloader
Remote Management Unit
Front Panel Administration
Diagnostics
Troubleshooting
Technical Specifications
Getting Help
Notes, Notices, and Cautions
Information in this document is subject to change without notice.
2005 - 2007 Dell Inc. All rights reserved.
Reproduction in any manner whatsoever without the written permission of Dell Inc. is strictly forbidden.
Trademarks used in this...

Page 2 Back to Contents Page
- 3 Autoloader Users Guide

When you first power on the Dell PowerVault 124T LTO - 3 autoloader, it automatically runs a Power - On Self - Test (POST). During the POST, the left (green) LED
flashes. After the POST, the left (green) and right (amber) LED flash alternately back and forth. Do one of the following:
l If the autoloader powers on successfully, continue configuring the autoloader (see Configuring the Autoloader ).

l If the autoloader does not power on...

Page 3
To configure the Dell PowerVault 124T LTO - 3 autoloader, you must verify the setup of the following:
l SCSI ID(s). For the autoloader, there is a single SCSI ID.
l Magazine(s).
l Ethernet IP address (if you are not using DHCP).
l SNMP server IP address — only if SNMP is being used.
l Time server IP address (or the time zone, date, and time, if configuring manually) — only if a time server is being used.
l Control mode.
l Security option.

Setting the SCSI ID
Each SCSI device...

Page 4 l An IP gateway (optional)
l A Simple Network Management Protocol (SNMP) server (optional)
l A time server, or set the time and time zone manually (optional)

Setting the IP Address
An IP address is the address of any device attached to a network. Each device must have a unique IP address. IP addresses are written as four sets of
numbers separated by periods ranging from 0.0.0.0 up to and including 255.255.255.255.
IP addresses are either permanent or dynamically assigned. A permanent, or...

Start reading Dell Powervault Lto-3 Manual
All Dell manuals