Dell P2010h Users Guide

							 
    Display Settings   Use the Display Settings to adjust image.   
     
						

							Back to Contents Page   
Setting Up Your Monitor   
 
Setting the display resolution to  1600x900 ( maximum)  
For optimal display performance while using the Microsoft ®
  Windows ®
  operating systems, set the display resolution to 1600 x 900 pixels by performing the 
following steps:  
1. Right - click on the desktop and click  Properties .  
2. Select the  Settings  tab.  
3. Move the slider - bar to the right by pressing and holding left - mouse button and adjust the screen resolution to  1600 X900 .  
4. Click  OK .  
    If you do not see  1600x900  as an option, you may need to update your graphics driver. Please choose the scenario below that best describes the 
computer system you are using, and follow the provided directions:  
1:   
2:   
Back to Contents Page     
						

							 
Information in this document is subject to change without notice.  
   
Reproduction of these materials in any manner whatsoever without the written permission of Dell Inc. is strictly forbidden.  
Trademarks used in this text:  Dell  and the  DELL  logo are trademarks of Dell Inc;  Microsoft  and  Windows  are either trademarks or registered trademarks of Microsoft Corporation in 
the United States and/or other countries.ENERGY STAR is a registered trademark of the U.S. Environmental Protection Agency. As an ENERGY STAR partner, Dell Inc. has 
determined that this product meets the ENERGY STAR guidelines for energy efficiency.   
Other trademarks and trade names may be used in this document to refer to either the entities claiming the marks and names or their products. Dell Inc. disclaims any 
proprietary interest in trademarks and trade names other than its own.   
Model P2010Ht   
   
   User Guide  
 
Setting the display resolution to 1600x900(maximum)     
						

							Back to Contents Page    
 
Setting Up the Monitor   
 
   Attaching the Stand  
   Connecting the Monitor  
   Organizing Your Cables  
   Attaching the Soundbar (optional)  
   Removing the Stand    
   Wall Mounting (Optional)  
Attaching the Stand  
 
To attach the monitor stand:  
1. Remove the cover and place the monitor on it.   
2. Fit the two tabs on the upper part of the stand to the groove on the back of the monitor.   
3. Press the stand till it snaps into its place.   
Connecting Your Monitor  
To connect your monitor to the computer:  
1. Turn off your computer and disconnect the power cable.   
 NOTE:  The stand is detached when the monitor is shipped from the factory.
 WARNING:  Before you begin any of the procedures in this section, follow the  Safety Instructions .  
Connect the blue (VGA) cable from your monitor to your computer.
 
NOTE:  If your computer supports a white DVI connector, unscrew and detach the blue (VGA) cable from the monitor and then 
connect the White DVI cable to the monitor and the white DVI connector on your computer.   
						

							2. Connect the white (digital DVI - D) or the blue (analog VGA) or the black (DisplayPort) display connector cable to the corresponding video port on the back 
of your computer. Do not use the three cables on the same computer.  Use all the  cables only when they are connected to three different computers with 
appropriate video systems.   
Connecting the white DVI cable  
 
Connecting the blue VGA cable  
 
   
Connecting the black DisplayPort cable  
     
NOTE:  Do not connect the blue VGA , the White DVI and the black DisplayPort cables to the computer at the same time. All monitors 
ship with the VGA (blue) cable attached by default.