Dell Mini 9 Service Manual

6. Slide the battery into the battery bay, until it clicks in place and slide the battery - lock latch towards the lock position.   
 
Back to Contents Page  
     

Back to Contents Page    
 Speaker   
 
   Removing the Speaker   
   Replacing the Speaker   
 
   
Removing the Speaker   
   
1. Follow the instructions in  Before You Begin .   
 
     
2. Remove the module cover (see  Removing the Module Cover ).   
 
     
3. Remove the keyboard (see  Removing the Keyboard ).   
 
     
4. Remove the palm rest (see  Removing the Palm Rest ).   
 
     
5. Remove the display assembly (see  Display Assembly ).   
 
     
6. Remove the display bezel (see  Display...

 
     
8. Slide the battery into the battery bay, until it clicks in place and slide the battery - lock latch towards the lock position.   
 
Back to Contents Page  
     

Back to Contents Page    
 Solid - state Drive   
 
   Removing the Solid - state Drive   
   Replacing the Solid - state Drive   
 
   
   
Removing the Solid - state Drive   
   
1. Follow the instructions in  Before You Begin .   
 
     
2. Remove the module cover (see  Removing the Module Cover ).   
 
 
   
   
3. Remove the two screws that secure the solid - state drive.   
 
     
4. Lift the solid - state drive out of its system board connector.   
 
Replacing the Solid - state Drive   
   
1....

   
6. Install the operating system for your computer, as needed (see Restoring Your Operating System in your computer  Setup Guide  or  Ubuntu Quick Start 
Guide ).   
 
     
7. Install the drivers and utilities for your computer, as needed (see Reinstalling Drivers and Utilities in your computer  Setup Guide ).   
 
Back to Contents Page  
      NOTICE:  Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may result in 
damage...

Back to Contents Page    
 System Board   
 
   Removing the System Board   
   Replacing the System Board   
   Setting the Keyboard Matrix   
 
   
The system boards BIOS chip contains the service tag, which is also visible on a barcode label at the bottom of the computer.  
Follow these instructions to enter the service tag  -  
Manually:  
   
1. Ensure that the AC adapter is plugged in and that the main battery is installed properly.   
 
     
2. Press  during POST to enter the system setup...

   
8. Disconnect the microphone cable and AC adapter cable from the respective system board connectors.   
 
     
9. Remove the two screws that secure the system board to the computer base.   
 
     
10. Lift the system board at an angle towards the side of the computer and out of the computer base.   
 
Replacing the System Board   
   
1. Remove the centrifugal paper of the thermal pads that shipped with your new system board and paste it on the processor, North Bridge, and South 
Bridge....

 
  Korea:   
 
     
4. Connect the AC adapter to the computer and then plug it into a wall outlet or surge protector.   
 
     
5. Release the key combination.   
 
Back to Contents Page