dell latitude cpt vcpt s series series User Manual

14 Dell Latitude CPt V/CPt S Series and CPx H/CPx J Series Service Manual
2. Align the memory module’s edge connector with the slot in the center of 
the memory module socket. With the module at a 45-degree angle, press 
the memory module’s edge connector firmly into the memory module 
socket. 
3. Pivot the memory module down until it clicks into place. If you do not hear 
a click as each end of the memory module snaps into the tabs, remove the 
memory module and reinstall it.
4. Replace the memory...

support.dell.comDell Latitude CPt V/CPt S Series and CPx H/CPx J Series Service Manual 15
3. Remove the seven 10-mm screws, labeled with a “circle K,” that secure 
the keyboard to the computer (see Figure 9).
4. Turn the computer right-side up and open the display. 

$

$%



#

#


#

 /

#


#$%

 
5. Release the keyboard from the palmrest assembly by inserting a small    
flat-blade...

16 Dell Latitude CPt V/CPt S Series and CPx H/CPx J Series Service Manual
	
?+/#&	&/
9. Disconnect the keyboard cable from the connector on the system board.
The keyboard cable is the wide, flexible cable.
10. Carefully disconnect the track stick cable from the ZIF connector on the 
palmrest’s flexible printed circuit board.
11. Remove the keyboard assembly.
	
&$#

$
1. Place the keyboard on the left side of the computer with the keys...

support.dell.comDell Latitude CPt V/CPt S Series and CPx H/CPx J Series Service Manual 17

.


$$
$%


%






%

 
4. Carefully turn the keyboard over and fit the keyboard into place.
Ensure that the track stick and keyboard cables are not twisted as you 
lower the keyboard into the palmrest.
5. To push the keyboard down, press on the blank key located below the right 
 key.
6. Check that the keyboard is...

18 Dell Latitude CPt V/CPt S Series and CPx H/CPx J Series Service Manual
	 

	
)	 

	
%	

%






##%





%
%


 
1. Remove the main battery and secondary battery (if present).
2. Remove the keyboard assembly.





#















#
%...

support.dell.comDell Latitude CPt V/CPt S Series and CPx H/CPx J Series Service Manual 19
NOTE: The microprocessor shield brace may not be present on your system, if 
the brace is not present continue with step 6. 
5. Remove the 4-mm screw that secures the microprocessor shield brace 
(see Figure 12).
6. Remove the microprocessor shield.
7. Rotate the arm of the thermal cooling assembly up and away from the 
microprocessor module.

,
#






#...

20 Dell Latitude CPt V/CPt S Series and CPx H/CPx J Series Service Manual

	 +4/+
	
.
	 +4/+
 
	
	
$#

$






##%





%
%


 

	



%



 
1. Remove the main battery and secondary battery (if present).
2. Remove the keyboard.
3. Close the display and remove the three 4-mm screws, labeled with a 
“circle D,” from the...

support.dell.comDell Latitude CPt V/CPt S Series and CPx H/CPx J Series Service Manual 21
230
	 +4/+*1




	
2230
	 +4/+*1
	
()!
	
$#

$
*
1. Use a scribe to carefully pry the four rubber screw covers out of the four 
screw holes located at the top of the bezel on the front of the display 
assembly.
2. Remove the four 4-mm screws located at the top of the bezel on the front 
of the display assembly (see Figure 14).
LCD...

22 Dell Latitude CPt V/CPt S Series and CPx H/CPx J Series Service Manual
3. Use a scribe to carefully pry the two plastic screw covers out of the two 
screw holes located at the bottom of the bezel on the front of the display 
assembly.
4. Remove the two 4-mm screws from the bottom of the bezel.

%9
%

# 5
%9




%
$#

%
 
5. Separate the bezel from the display-assembly top cover.
The bezel is secured by three plastic tabs on...

support.dell.comDell Latitude CPt V/CPt S Series and CPx H/CPx J Series Service Manual 23
	
()!
+-
1. Find the manufacturer’s name, either Samsung or IBM/Hitachi,  on the 
back of the replacement LCD panel. 
2.
If your replacement LCD panel is a Samsung — Install the display bezel clip 
(if one is not present) by placing the bezel slot over the hinge tab and 
pressing gently until it snaps (see Figure 15).
If your replacement LCD panel is an IBM/Hitachi — Remove the display...