dell latitude c600 c500 series User Manual

Removing and Replacing Parts : Dell Latitude C600/C500 Series Service Ma\
nual 
 
Removing the 14.1-Inch Display Assembly Bezel 
NOTICE: Disconnect the computer and any attached devices from electrical outlets\
, and remove 
any installed batteries. 
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by tou\
ching an 
unpainted metal surface on the computer. 
NOTICE: Read Preparing to Work Inside the Computer before performing the following 
procedure....

Removing and Replacing Parts : Dell Latitude C600/C500 Series Service Ma\
nual 
1.  Remove the hard drive. 
2.  Remove the 
display assembly. 
3.  Use the scribe to pry the six rubber screw covers out of the screw h\
oles located on the bezel on the  front of the display assembly. 
4.  Remove the six M2.5 x 5-mm screws located on the bezel on the front \
of the display assembly. 
NOTICE: To avoid damage to the bezel, do not bend the bezel while separating it \
from the display-
assembly top cover. 
5....

Removing and Replacing Parts : Dell Latitude C600/C500 Series Service Ma\
nual 
Replacing the 14.1-Inch Display Panel 
1.  Place the bottom edge of the display panel in the bottom of the disp\
lay-assembly top cover and elevate the top of the panel with your hand. 
2.  Place the display panel in the display-assembly top cover. 
3.  Reinstall the five M2 x 4-mm screws that secure the display panel to\
 the display-assembly top  cover. 
Removing the Display-Feed Flex Cable (14.1-Inch Display 
Panel)...

Removing and Replacing Parts : Dell Latitude C600/C500 Series Service Ma\
nual 
1.  Remove the hard drive. 
2.  Remove the 
display assembly. 
3.  Remove the 
display assembly bezel. 
4.  Remove the tape that covers the display panel connector. 
5.  Pull the top flex cable connector down and away to remove it from th\
e display panel connector. 
12.1-Inch Display Assembly Bezel and Panel 
file:///F|/Service%20Manuals/Dell/Latitude/c500-600/remove.htm (17 of 4\
0) [2/28/2004 7:53:33 AM] 

Removing and Replacing Parts : Dell Latitude C600/C500 Series Service Ma\
nual 
 
Removing the 12.1-Inch Display Assembly Bezel 
NOTICE: Disconnect the computer and any attached devices from electrical outlets\
, and remove 
any installed batteries. 
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by tou\
ching an 
unpainted metal surface on the computer. 
NOTICE: Read Preparing to Work Inside the Computer before performing the following 
procedure. 
1.  Remove the 
hard drive....

Removing and Replacing Parts : Dell Latitude C600/C500 Series Service Ma\
nual 
6.  Remove the M2 x 4-mm screw that secures the display-feed flex cable \
to the display assembly through the black plastic flex cable retention bracket (see 
12.1-Inch Display Assembly Bezel and 
Panel). 
7.  Lift up the right side of the display panel, and pull the panel out \
of the display-assembly top cover  at an angle. 
Replacing the Display-Assembly Top Cover 
If you are replacing the display-assembly top cover,...

Removing and Replacing Parts : Dell Latitude C600/C500 Series Service Ma\
nual 
 
NOTICE: Disconnect the computer and any attached devices from electrical outlets\
, and remove 
any installed batteries. 
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by tou\
ching an 
unpainted metal surface on the computer. 
NOTICE: Read Preparing to Work Inside the Computer before performing the following 
procedure. 
1.  Remove the 
hard drive. 
2.  Remove the 
display assembly. 
3.  Remove...

Removing and Replacing Parts : Dell Latitude C600/C500 Series Service Ma\
nual 
Display Assembly Latch 
NOTICE: Disconnect the computer and any attached devices from electrical outlets\
, and remove 
any installed batteries. 
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by tou\
ching an 
unpainted metal surface on the computer. 
Display Assembly Latch for 14.1-Inch XGA Display Panels 
 
Removing the Display Assembly Latch 
1.  Remove the hard drive. 
2.  Remove the 
display...

Removing and Replacing Parts : Dell Latitude C600/C500 Series Service Ma\
nual 
 
NOTICE: Do not remove the display assembly latch from 14.1-inch SXGA+ and 12.1-i\
nch display 
panels. If the latch is damaged, replace the 
display-assembly top cover. 
Hinge Covers 
Removing the Hinge Covers 
Removing the Hinge Covers 
file:///F|/Service%20Manuals/Dell/Latitude/c500-600/remove.htm (22 of 4\
0) [2/28/2004 7:53:33 AM] 

Removing and Replacing Parts : Dell Latitude C600/C500 Series Service Ma\
nual 
 
1.  Remove the 
display assembly. 
2.  Rotate the hinges forward at an angle of approximately 90 degrees to\
 the front of the display  assembly. 
3.  To remove the hinge covers, slide them off of the hinges. 
Replacing the Hinge Covers 
Hinge Covers 
file:///F|/Service%20Manuals/Dell/Latitude/c500-600/remove.htm (23 of 4\
0) [2/28/2004 7:53:33 AM]