DELL inspiron 4100 User Manual

Display, Display Assembly, Display Latch, and Hinge Covers: Dell Inspiro\
n 4150 
 
1 display panel connector
2 top flex-cable connector
3 pull-tab
4 bottom flex-cable 
connector
5 inverter connector
9.  Remove the tape that secures the display panel connector and the tap\
e that  secures the middle of the display-feed flex cable to the display panel. \
10.  Pull the top flex-cable connector down and away to remove it from t\
he display  panel connector....

Display, Display Assembly, Display Latch, and Hinge Covers: Dell Inspiro\
n 4150 
Replacing the Display Panel 
1.  Reconnect the top flex-cable connector to the display panel connecto\
r. 
2.  Reconnect the bottom flex-cable connector to the inverter connector.\
 
3.  Replace the tape that secures the display panel connector and the ta\
pe that secures the middle of the display-feed flex cable to the display panel. \
4.  Place the bottom edge of the display panel in the bottom of the top \
cover and...

Display, Display Assembly, Display Latch, and Hinge Covers: Dell Inspiro\
n 4150 
(XGA panel shown) 
 
1 M1.7 x 3.5-mm screws (2)
2 M2.5 x 5-mm screws (2)
3 display latch
4 bracket
Replacing the Display Latch 
1.  On XGA panels, place the display latch on top of its screw holes, and then place 
the bracket on top of the display latch, aligning the bracket and displa\
y latch 
screw holes. 
On SXGA+ and UXGA panels, align the screw holes and place the display latch 
and attached bracket in the top cover....

Display, Display Assembly, Display Latch, and Hinge Covers: Dell Inspiro\
n 4150 
2.  Replace the two M2.5 x 5-mm screws and the two M1.7 x 3.5-mm screws \
that secure the display latch and bracket to the top cover. 
Hinge Covers
Removing the Hinge Covers 
1.  Remove the display. 
2.  Rotate the hinges forward at an angle of approximately 90 degrees to\
 the front  of the display. 
3.  To remove the hinge covers, slide them off the hinges. 
 
file:///F|/Service%20Manuals/Dell/Inspiron/4150/display.htm...

Display, Display Assembly, Display Latch, and Hinge Covers: Dell Inspiro\
n 4150 
Replacing the Hinge Covers 
1.  Attach the display to the bottom case. 
2.  Close the display. 
3.  Snap the hinge covers in place over the hinges. 
HINT: The right plastic hinge-cover label includes an R, and the left plasti\
c 
hinge-cover label includes an L. The hinge-cover labels face the back \
of the 
computer. 
file:///F|/Service%20Manuals/Dell/Inspiron/4150/display.htm (12 of 13)\
 [2/28/2004 7:29:44 AM] 

Display, Display Assembly, Display Latch, and Hinge Covers: Dell Inspiro\
n 4150 
 
1 right hinge cover
2 left hinge cover
Back to Contents Page
 
file:///F|/Service%20Manuals/Dell/Inspiron/4150/display.htm (13 of 13)\
 [2/28/2004 7:29:44 AM] 

Palm Rest: Dell Inspiron 4150 
Back to Contents Page 
Palm Rest 
Dell™ Inspiron™ 4150 
NOTICE: Disconnect the computer and any attached devices from electrical 
outlets, and remove any installed batteries. 
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by 
touching an unpainted metal surface on the computer. 
NOTICE: Read Preparing to Work Inside the Computer before performing the 
following procedure. 
1.  Remove the 
hard drive. 
2.  Remove the 
keyboard. 
NOTICE: You must...

Palm Rest: Dell Inspiron 4150 
 
1 M2.5 x 12-mm screws 
(3)
2 M2 x 3-mm screws (2)
3 hard drive door
5.  Remove the two M2 x 3-mm screws that are located in the hard drive door \
 labeled circle P. 
6.  Turn the computer over, and remove the three M2 x 3-mm screws that secur\
e  the palm rest to the bottom case: 
a.  Remove the two M2 x 3-mm screws that are located on the back edge of  the bottom case, underneath the display. 
b.  Remove the M2 x 3-mm screw located underneath the keyboard, on the  right...

Palm Rest: Dell Inspiron 4150 
 
1 M2 x 3-mm screws (3)
2 palm rest
3 palm-rest flex cable
4 bottom case
5 touch pad connector
6 back center of the palm 
rest
file:///F|/Service%20Manuals/Dell/Inspiron/4150/palmrest.htm (3 of 4) \
[2/28/2004 7:29:45 AM] 

Palm Rest: Dell Inspiron 4150 
NOTICE: Carefully separate the palm rest from the bottom case to avoid 
damage to the palm rest. 
8.  Starting at the back center of the palm rest, use your fingers to separa\
te the  palm rest from the bottom case by lifting the inside of the palm rest wh\
ile 
pushing in on the outside. 
Back to Contents Page
 
file:///F|/Service%20Manuals/Dell/Inspiron/4150/palmrest.htm (4 of 4) \
[2/28/2004 7:29:45 AM]