Dell Inspiron 3000 Service Manual
Here you can view all the pages of manual Dell Inspiron 3000 Service Manual. The Dell manuals for Notebook are available online for free. You can easily download all the documents as PDF.
Page 91
Removing and Replacing Parts 4-55 Latch Assembly Figure 4-38. Latch Assembly Removal To remove the latch assembly, follow these steps: 1. Remove the latch assembly from the base assembly. Use the fingers of one hand and lift the assembly from its recess in the base assembly. The latch assembly is held in place only by pressure. 2. Remove the spring from the latch. Be careful not to lose the small spring that is part of the latch assembly. latch spring
Page 92
4-56 Dell Inspiron 3000 Series Service Manual Kensington Lock Plate Figure 4-39. Kensington Lock Plate Removal Use a screwdriver to lift the Kensington lock plate from its recess in the base assembly. The plate is held in place only by pressure. Kensingtonlock plate base assembly
Page 93
Removing and Replacing Parts 4-57 12.1-Inch LCD Components The 12.1-inch LCD assembly consists of the following components: •Front bezel •LCD panel •Inverter board and cable •Hinges •Bracket •Back cover •LCD flex cable The following subsections provide removal and replacement procedures for these components and assumes that the 12.1-inch LCD assembly has been removed from the computer. See “LCD Assembly” found earlier in this chapter. 12.1-Inch LCD Front Bezel Figure 4-40. 12.1-Inch LCD Front Bezel...
Page 94
4-58 Dell Inspiron 3000 Series Service Manual 3. Remove front bezel screws F1, F2, F3, and F4. 4. Separate the front bezel from the back cover. With the bottom of the LCD assembly facing you (cables end), insert your fingertips between the LCD panel and the front bezel. Start in the center of the bezel and work out to the corners. With a peel-back-and-push motion, separate the front bezel from the hidden tabs on the back cover. Do not put pressure on the LCD panel with your knuckles; microscopic...
Page 95
Removing and Replacing Parts 4-59 12.1-Inch LCD Panel . Figure 4-41. 12.1-Inch LCD Panel Removal To remove the 12.1-inch LCD panel, follow these steps: 1. Remove the front bezel. See the previous subsection, “12.1-Inch LCD Front Bezel.” 2. Remove LCD panel screws LC1, LC2, LC3, and LC4. 3. Remove the LCD Panel. NOTE: Be careful when removing any part of the LCD flex cable. Lift u p the LCD panel, and disconnect the LCD-to-inverter cable from con- nector CN1 at the to p of the inverter board....
Page 96
4-60 Dell Inspiron 3000 Series Service Manual 12.1-Inch LCD Inverter Board . Figure 4-42. 12.1-Inch Inverter Board Removal To remove the 12.1-inch inverter board, follow these steps: 1. Remove the front bezel. See “12.1-Inch LCD Front Bezel” found earlier in this section. 2. Remove the LCD panel. See the previous subsection, “12.1-Inch LCD Panel.” You may not want to remove this panel if you are replacing only the inverter board. 3. Disconnect the inverter cable from connector CN2 at the bottom of...
Page 97
Removing and Replacing Parts 4-61 12.1-Inch LCD Hinges Figure 4-43. 12.1-Inch LCD Hinges Removal To remove the 12.1-inch LCD hinges, follow these steps: 1. Remove the front bezel. See “12.1-Inch LCD Front Bezel” found earlier in this section. 2. Place the back cover down on a work surface. 3. Remove the hinge screws H6, H7, H9, and H10. You may need to loosen screws H5 and H8 to free the hinges. 4. Remove the hinges from the back cover. The bracket does not have to be taken off to remove the hinges....
Page 98
4-62 Dell Inspiron 3000 Series Service Manual 12.1-Inch LCD Bracket Figure 4-44. 12.1-Inch LCD Bracket Removal To remove the 12.1-inch LCD bracket, follow these steps: 1. Remove the front bezel. See “12.1-Inch LCD Front Bezel” found earlier in this section. 2. Remove the LCD panel. See “12.1-Inch LCD Panel” found earlier in this section. 3. Remove the hinges. See the previous subsection, “12.1-Inch LCD Hinges.” 4. Remove bracket screws H5 and H8. 5. Remove the bracket from the back cover. With your...
Page 99
Removing and Replacing Parts 4-63 13.3-Inch LCD Components The 13.3-inch LCD assembly consists of the following components: •Front bezel •LCD panel •Inverter board and cable •Hinges •Bracket •Back cover •LCD wiring harness The following procedures provide removal and replacement procedures for these components, and assume that the 13.3-inch LCD assembly has been removed from the computer. See “LCD Assembly” found earlier in this chapter. 13.3-Inch LCD Front Bezel Figure 4-45. 13.3-Inch LCD Front Bezel...
Page 100
4-64 Dell Inspiron 3000 Series Service Manual 4. Separate the front bezel from the back cover. With the bottom of the LCD assembly facing you (cables end), insert your fingertips between the LCD panel and the front bezel. Start in the center of the bezel and work out to the corners. With a peel-back-and-push motion, separate the front bezel from the hidden tabs on the back cover. Do not put pressure on the LCD panel with your knuckles; microscopic fractures in the panel could result. Separate the...