Home > Dell > Notebook > Dell Inspiron 15r Manual

Dell Inspiron 15r Manual

    Download as PDF Print this page Share this page

    Have a look at the manual Dell Inspiron 15r Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 327 Dell manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.

    							Hard Drive  |  21
    8
    Hard Drive
     WARNING:  Before working inside your computer, read the safety information 
    that shipped with your computer and follow the steps in "Before You Begin" on 
    page 7. For additional safety best practices information, see the Regulatory 
    Compliance Homepage at dell.com/regulatory_compliance.
     CAUTION: To avoid data loss, do not remove the hard drive while the computer is 
    On or in Sleep state.
     CAUTION: Hard drives are extremely fragile. Exercise care when handling the 
    hard drive.
    Removing the Hard Drive
    Prerequisites
    1Remove the battery. See "Removing the Battery" on page 13.
    2Remove the base cover. See "Removing the Base Cover" on page 17.
    book.book  Page 21  Thursday, April 12, 2012  10:14 AM 
    						
    							22  |  Hard Drive
    Procedure
    1Remove the screws that secure the hard -drive assembly to the computer base.
    2 Using the pull-tab, slide the hard-drive as sembly toward the back of the computer 
    to disconnect the hard-drive assembly  from the connector on the system board.
    3 Lift the hard-drive assembly out of the computer base.
    1pull-tab 2screws (4)
    3 hard-drive assembly
    3
    2
    1
    book.book  Page 22  Thursday
    , April 12, 2012  10:14 AM 
    						
    							Hard Drive  |  23
    4Remove the screws that secure the ha rd-drive bracket to the hard drive.
    5 Lift the hard drive off the hard-drive bracket.
    Replacing the Hard Drive
    Procedure
    1Remove the new hard drive from its packaging.  
    Save the original packaging for st oring or shipping the hard drive.
    2 Align the screw holes on the hard drive-b racket with the screw holes on the hard 
    drive.
    3 Replace the screws that secure the hard-drive bracket to the  
    hard drive.
    4 Place the hard-drive assembly on the computer base.
    5 Using the pull-tab, slide the hard-drive as sembly toward the front of the computer, 
    to connect the hard-drive assembly to  the connector on the system board.
    6 Replace the screws that secure the hard-drive assembly to the computer base.
    1screws (4) 2 hard drive
    3 hard-drive bracket
    1
    2 3
    book.book  Page 23  Thursday
    , April 12, 2012  10:14 AM 
    						
    							24  |  Hard Drive
    Postrequisites
    1Replace the base cover. See "Replacing the Base Cover" on page 18.
    2Replace the battery. See "Replacing the Battery" on page 13.
    3Follow the instructions in "After Working Inside Your Computer" on page 9.
    book.book  Page 24  Thursday, April 12, 2012  10:14 AM 
    						
    							Optical Drive  |  25
    9
    Optical Drive
     WARNING:  Before working inside your  computer, read the safety information 
    that shipped with your computer and foll ow the steps in "Before You Begin" on 
    page 7. For additional safety best practices information, see the Regulatory 
    Compliance Homepage at dell.com/regulatory_compliance.
    Removing the Optical Drive
    Prerequisites
    1 Remove the battery. See "Removing the Battery" on page 13.
    2 Remove the base cover. See "Removing the Base Cover" on page 17.
    Procedure
    1Remove the screw that secures the optica l-drive assembly to the computer base.
    2 Using your fingertips, slide the optical-dr ive assembly out of the optical-drive bay.
    1 optical-drive assembly 2 screw
    2
    1
    book.book  Page 25  Thursday , April 12, 2012  10:14 AM 
    						
    							26  |  Optical Drive
    3
    Carefully pry the optical-drive bezel and re move it from the optical-drive assembly.
    4 Remove the screws that secure the optical-drive bracket to the optical drive.
    5 Remove the optical-drive bracket.
    Replacing the Optical Drive
    Procedure
    1Align the screw holes on the optical-drive bracket with the screw holes on the 
    optical drive.
    2 Replace the screws that secure the optical-drive bracket to the optical drive.
    3 Align the tabs on the optical-drive beze l with the slots on the optical-drive 
    assembly and snap the optical-drive bezel into place.
    4 Slide the optical-drive assembly into the optical-drive bay until it is fully seated.
    5 Replace the screw that secures the optical-drive assembly to the computer base.
    Postrequisites
    1Replace the base cover. See "Replacing the Base Cover" on page 18.
    2 Replace the battery. See "Replaci ng the Battery" on page 13.
    3 Follow the instructions in "After Work ing Inside Your Computer" on page 9.
    1 optical-drive bezel
    2 optical drive
    3 optical-drive bracket 4 screws (2)
    1
    24
    3
    book.book  Page 26  Thursday
    , April 12, 2012  10:14 AM 
    						
    							Palm Rest  |  27
    10
    Palm Rest
     WARNING:  Before working inside your  computer, read the safety information 
    that shipped with your computer and foll ow the steps in "Before You Begin" on 
    page 7. For additional safety best practices information, see the Regulatory 
    Compliance Homepage at dell.com/regulatory_compliance.
    Removing the Palm Rest
    Prerequisites
    1 Remove the battery. See "Removing the Battery" on page 13.
    2 Remove the keyboard. See "Removing the Keyboard" on page 15.
    3 Remove the base cover. See "Removing the Base Cover" on page 17.
    Procedure
    1Remove the screws that secure the  palm rest to the computer base.
    book.book  Page 27  Thursday, April 12, 2012  10:14 AM 
    						
    							28  |  Palm Rest
    2
    Turn the computer over.
    3 Lift the connector latches and pull the pull-tabs to disconnect the power-button 
    board cable, touchpad cable, and hot-ke y board cable from the connectors on the 
    system board.
    1 power-button board cable 2 pull-tab
    3 connector latch 4 touchpad cable
    5 hot-key board cable
    1 2
    35
    4
    book.book  Page 28  Thursday
    , April 12, 2012  10:14 AM 
    						
    							Palm Rest  |  29
    4Remove the screws that secure the  palm rest to the computer base.
    5 Using your fingertips, pry out the palm rest from the computer base.
      CAUTION: Carefully separate the palm re st from the display assembly to avoid 
    damage to the display assembly.
    1 screws (6) 2 palm rest
    1
    2
    book.book  Page 29  Thursday , April 12, 2012  10:14 AM 
    						
    							30  |  Palm Rest
    6
    Without pulling hard on the palm-rest asse mbly, place it away from the display as 
    shown in the illustration below.
    7 Lift the connector latch and pull the pull-tab to disconnect the status-lights cable 
    from the connector on the system board.
    8 Lift the palm-rest assembly off the computer base.
    1 connector latch 2 pull-tab
    3 status-lights cable
    12 3
    book.book  Page 30  Thursday , April 12, 2012  10:14 AM 
    						
    All Dell manuals Comments (0)

    Related Manuals for Dell Inspiron 15r Manual