Dell E198fp Users Guide

   
Product Specific Problems  Shaky/Jittery Video Wavy picture or fine movement l Push Auto Adjust button   
l Adjust Phase and Clock controls via OSD   
l Perform monitor reset   
l Check environmental factors   
l Relocate and test in  another  room   
Missing Pixels LCD screen has spots l Cycle power on - off   
l These are pixels that are permanently off and is a natural defect 
that occurs in LCD technology   
Stuck - on Pixels LCD screen has bright spots l Cycle power on - off   
l These are...

Back to Contents Page   l The OSD Lock is On. Press the menu button 
for 15 seconds to unlock the OSD menu.   
The monitor will not go into 
power saving mode. No picture, the LED light is green. When press +, 
 -  or Menu key, the message  No input signal  
will appear. l Move mouse or hit any key on the 
keyboard on the computer or  activate 
video player,  then access the OSD to set 
both Audio/Video to  off  state.   
No Input Signal when user 
controls pressed No picture, the LED light is green....

Back to Contents Page    
 
 
Using Your Monitor Stand   
 
   Attaching the Stand  
   Organizing Your Cables  
   Using the Tilt  
   Removing the Stand   
   
Attaching the Stand  
  
 
   
1. Place the s tand  on a flat surface.  
2. Fit the groove on the back of the monitor onto the   two teeth of upper stand.   
3. Lower the monitor so that the monitor mounting area snaps on/locks to stand.  
    
Organizing Your Cables  
  NOTE:   Stand is detached when the monitor is shipped from the factory.    

   
After attaching all necessary cables to your monitor and computer, (See  Connecting Your Monitor  for cable attachment,) use the cable holder to 
neatly organize all cables as shown above.  
Using the Tilt  
With the built - in pedestal, you can tilt the monitor to best suit your viewing needs.  
 
Removing the Stand  
  After placing the monitor panel on a soft cloth or cushion, press and hold the LCD removal button, and then remove the stand.     

 
   
Back to Contents Page  
    NOTE:   To prevent scratches on the LCD screen while removing the stand,  ensure that the monitor is placed on a clean surface.