Dell 2407wfp Users Guide

Back to Contents Page  
 
- HC Flat Panel Monitor   
   Changing the Rotation of Your Monitor  
   Rotating Your Operating System  
Changing the Rotation of Your Monitor   
Before you rotate the monitor, your monitor should be fully vertically extended ( Vertical Extension ) and fully tilted ( Tilt ) up to avoid hitting the bottom edge of 
the monitor.  
   
Rotating Your Operating System  
After you have rotated your monitor, you need to complete the procedure below to rotate your operating system.  
1....

Back to Contents Page   
Setting Up Your Monitor   
- HC Flat Panel Monitor   
   Connecting Your Monitor  
   Using the Front Panel Buttons  
   Using the OSD  
   Using the Dell™ Soundbar (Optionalyf  
   
Connecting Your Monitor  
 CAUTION:  Before you begin any of the procedures in this section, follow the  Safety Instructions .    

To connect your monitor to the computer perform the following steps/instructions.  
l Turn off your computer and disconnect the power cable.   
l Connect either the white (digital DVI - D) or the blue (analog VGA) display connector cable to the corresponding video port on the back of your 
computer. Do not use both cables on the same computer.   The only case in which both cables can be used is if they are connected to two different 
computers with appropriate video systems. (Graphics are for...

   
Using the OSD  
Accessing the Menu System  
1.  Push the MENU button to launch the OSD menu and display the main menu.   
Main Menu for Analog (VGA) Input  
Or  
Main Menu for non Analog (non VGA) Input     
B
 
   
PIP / PBP Select  
    Use this button to activate PIP (Picture - in - Picture) / PBP (Picture - by - PictureyfPRGHVDGMXVWPHQW.
Pressing this button continually cycles the  monitor through the following modes : OFF -- >PIP -- >PBP. You will see the following 
messages corresponding to...

 
2.   Push the   and   buttons to move between the setting options. As you move from one icon to another, the option name is highlighted. See the table 
for a    
      complete list of all the options available for the monitor.   
3.   Push the MENU button once to activate the highlighted option.    
4.   Push   and   button to select the desired parameter.   
5.   Push MENU to enter the slide bar and then use the    and   buttons, according to the indicators on the menu, to make your changes.   
6....

 
 
 
 
 
 
 
  
Back  
VGA  
DVI - D
S - Video
Composite
Component
Scan for Sources  
Exit Menu   Push   to go back to the main menu.
Select VGA input when you are using the analog (VGA) connector. Push  to select the VGA input source.
Select DVI - D input when you are using the Digital (DVI) connector. Push  to select the DVI input source.
Select S - Video input when you are using S - Video connector. Push   to select the S - Video input source. 
Select Composite input when you are using composite...

 
 
 
 
 
     
Color Format  
(Video/DVI - HD)  
Color Reset  
Exit Menu   PC Custom: Use the plus and minus buttons to increase or decrease each of the three colors (R, G, B) independently, in single digit increments, from 0 to 100.
NOTE:  Color temperature is a measure of the warmth of the image colors (red/green/blue). The two available presets (Blue and Red) favor blue and red 
accordingly. Select each one to see how each range suits your eye....or utilize the Custom Color option to customize the...

    
   
    Sports Mode  
Nature Mode  
Exit Menu  
   Mode suitable for sports scenes.
Mode suitable for nature scenes.
Push    to exit the OSD main menu.
  DISPLAY  
SETTINGS  
 
Back  
Wide Mode  
H Position  
V Position  
Sharpness  
Zoom  
Horizontal Pan  
 
   
Pixel Clock  
Phase  
Audio Option  
Display Info  
Display  Reset   Push   to go back to the main menu.
Adjust the image ratio as 1:1, aspect or full screen.  
   
  NOTE:  Wide Mode adjustment is not required at optimal preset resolution...

   
 
 
 Exit Menu  
   Push    to exit the OSD main menu.
 
   
   
   
   
    MENU  
SETTINGS  
 
Back  
Language  
Menu Horizontal  
 
 
Menu Vertical Position  
Menu Timer  
Transparency  
Menu Rotation  
Menu Lock  
Factory Reset  
DDC/CI  
Exit Menu    
Push   to go back to the main menu.
Language option to set the OSD display to one of five languages (English, Espanol, Francais, Deutsch, Japanese).
and    buttons move OSD left and right.  
and    buttons move OSD up and down.  
OSD Hold Time:...

   
OSD Warning Messages     
   
   
   
   
   
   
   
   
   
   
   
   
     
  
  
Back  
Mode  
When  PIP/PBP activated
PIP/PBP Source  
PIP Position  
PIP  Size  
PIP /PBP  Contrast  
PIP /PBP  Hue/Tint  
PIP /PBP  Saturation  
Exit Menu        
PIP /PBP submenu when PIP/PBP ON - PIP/PBP submenu when PIP/PBP ON
     
  NOTE:   When using DVI source, the contrast adjustment is not available.
Push     to go back to the main menu.
There is  two modes: PIP (Picture in Picture)  and PBP (Picture By...