Dell 1110 User Guide

 
 
 
 
2. If you cannot see the paper in the output tray or the paper does not move when pulled,  stop pulling and open the top cover and the inner cover.  
 
 
 
 
 
3. Loosen the paper if it is caught in the heat roller. Then remove the paper by gently pulling it out.  
 
   
 
 
 
4. Close the inner cover( 1 ) and the top  cover( 2 ). Printing resumes automatically.    
 
 
 
 
    NOTE:  Failed pages will not reprint. Reprint the failed pages.
  CAUTION:  The top and inner cover themselves may also...

Fuser Area Jam  
1. Open the front cover.  
 
   
 
 
2. Gently pull the toner cartridge out, being careful not to scratch against the printer, and lift it up and away from the printer.  
 
   
 
 
3. Remove the paper by gently pulling it toward you.  
 
   
 
4. Check that there is no other paper in the printer.   
 
5. Reinstall the toner cartridge and close the front cover. Your printer resumes printing the document from failed pages.    
   
Tips for Avoiding Paper Jams  
   
By selecting the correct...

l Do not mix paper types in the paper tray.  
 
     
l Use only recommended print materials. See  Paper Specifications .  
 
     
l Ensure that the recommended print side of print materials is facing up in the paper tray.    
   
Understanding the Operator Panel LEDs  
The operator panel LEDs signify different things, depending on their sequences. LEDs that are off, on, and/or blinking indicate printer conditions such as 
printer status, intervention (for example, out of paper and jammed paper), or...

   
Solving General Printing Problems  
For problems with the operation of your printer, refer to the table for suggested solutions.  the power switch.   
Make sure that    is on.    In Ready mode,    lights green.  If   lights or blinks green,  go to  Understanding the Operator Panel LEDs .   
Press and hold    to print a 
demo page.   • If a demo page does not print,  check the paper supply in the paper input tray.
• If the paper jams in the printer,  go to  Clearing Jams in the Paper Tray . 
Check the...

   
Solving Print Quality Problems  
 
Print Quality Checklist  
   
Print quality problems can be resolved by following the checklist below.  
   
l Redistribute toner in the toner cartridge (see  Redistributing Toner ).  
 
     
l Clean the inside of the printer (see  Cleaning the Interior ).  
 
     
l Adjust the print resolution from the printer properties window (see  Graphics Tab ).  
 
     
l Ensure that the Toner Save mode is off (see  Graphics Tab ).  
 
     
l Clear general printing...

    • A single sheet of paper may be defective. Try reprinting the job.
• The moisture content of the paper is uneven or the paper has moist spots on its 
surface. Try a different brand of paper. See  Paper Specifications .
• The paper lot is bad. The manufacturing process can cause some areas to reject toner. 
Try a different kind or brand of paper.
• The toner cartridge may be defective. See  Vertical repetitive defects .
• If these steps do not correct the problems,   contact a service...

    • Check the paper type and quality. See  Paper Specifications .
• Turn over the stack of paper in the paper tray. Also try rotating the paper 180  in the 
paper tray.
Back of printouts are dirty  
    • Check for leaks in the toner. Clean the inside of the printer. See  Cleaning the Interior .
• The transfer roller may be dirty. See  Cleaning the Interior .
Black pages  
    • The toner cartridge may not be installed properly. Remove the cartridge and reinsert.
• The toner cartridge may be defective...