Daewoo Erf 396 Service Manual

							8. PCB CIRCUIT DIAGRAMS108.1- ERF-XX6A 
						

							8.2- ERF-XX6N11 
						

							9. COMPONENTS DISASSEMBLY PICTURES
1- FRONT PCB (FULL AUTOMATIC TYPE)
- Input a cutter sleeve between
Window FCP and Panel F control. 
Important: Input carefully cutter in 
the area that picture shows (down 
right).
- Lift Window FCP up.
* Remark: Input cutter deeply and
carefully in order to lift up easily
and avoid paint damages and
scratches.
- Unscrew Panel F Control. 12 
						

							- Unscrew the two fixing screws of
F-PCB
as.
2- SWITCH DOOR - Force switch door to the left side
and input a thin driver in the rigth
part as picture shows.
After this operation, lift switch up.
* Remark: Input driver carefully in 
order to lift up easily and avoid 
paint damages and scratches.- move switch to left side.
- Take out switch and disconnect
housing. 13 
						

							3- M-PCB
- Unscrew the two fixing screws of
cover PCBbox.
- Disconnect all housings 
connectors from M-pcb, and force
plastic locker of pcb box in order
to take out the pcb. 
* Remark: In ERF-xx6N models
forced defrost button is located 
in M-PCB, so pcb box cover must
be disassembled
4- RELAY BOX COVER - Press relay box cover stopper 
sleeve with a minus driver like   
picture shows. 14 
						

							5- MULTI DUCT
- Take out window r pulling
the top part sleeve.
- Unscrew all fixing screws
- To disassemble V-PCB force
left plastic stopper and lift pcb up.
- To disassemble R-sensor lift
it up from the wires carefully. 15 
						

							6- LOUVERS:
- Unscrew the two fixing screw
for disassembly louver A and B
- Disconnect fan motor housing
- Unscrew the fixing screw in order
to disassemble Louver A. 16 TO DIASEMBLE IT IS
NECESSARY A STAR
DRIVER WITH A 
MINIMAL LENGHT OF
10 CM 
						

							- When louvers are disassembled
is very important check Knob F
louver position.
Default position is M
7-CHANGE DOOR OPEN SIDE - Unscrew cover T hinge
- Before changing door open side,
disconnect door housing 
connector.
Follow next sheets instructions to
change door open side 17L POSITION H POSITIONL POSITION 
						

							Follow  to remove
1. Remove“ COVER HINGE” and “
HINGE T”
2. Remove“ R” door.
3. Remove“ HINGE M”
4. Remove“ F” door
5. Remove“COVER BRACKET”
6. Remove“ HINGE U”
7. Reverse the position of“ COVER
BUSHING”
8. Move“ R DOOR HANDLE” to“ F
DOOR”
9. Reverse the position of“ CAP DR
BUSHING”
10. Move“ F DOOR HANDLE” to“
R DOOR”
STEP 1 : Remove door
STEP 2 : Change door handle1810. DOOR POSITION CHANGE PROCESS
 
						

							11. Attach the“ HINGE U” on the left.
12. Attach the“ F DOOR”
13. Reverse the position of “ HINGE
M” and
“ CAP SCREW HOLE”
1.Attach the“ R DOOR”
15. Attach the“ HINGE T” on the left
of cabinet
after  assembling to“R DOOR”
16. Reverse the position of “ COVER
HINGE”
and“ COVER CAB HARNESS”
STEP 3 : Change the position of door19door open side