D-Link Dir655 B1 Manual

37D-Link DIR-655 User Manual
Section 3 - Configuration
DHCP Server Settings
DHCP stands for Dynamic Host Control Protocol. The DIR-655 has a built-in DHCP server. The DHCP Server will automatically assign an IP address 
to the computers on the LAN/private network. Be sure to set your computers to be DHCP clients by setting their TCP/IP settings to “Obtain an IP 
Address Automatically.” When you turn your computers on, they will automatically load the proper TCP/IP settings provided by the DIR-655. The...

38D-Link DIR-655 User Manual
Section 3 - Configuration
DHCP Reservation
If you want a computer or device to always have the same IP address assigned, you can create a DHCP reservation. The router will assign the IP 
address only to that computer or device. 
Note: This IP address must be within the DHCP IP Address Range.
Check this box to enable the reservation.
Enter the computer name or select from the drop-down menu 
and click 

39D-Link DIR-655 User Manual
Section 3 - Configuration
USB Settings
Use this section to configure your USB port. There are two configurations to choose from: Network USB and WCN Configuration.
Note: If using the Network USB option, users will need to install the Network USB Utility into the computers to share the USB device through the router.
Choose  bet ween  these  t wo  configuration: 
Network USB and WCN Configuration.
Please  set  the  Network  USB  Detection  interval 
time. 
USB Settings:
Network...

40D-Link DIR-655 User Manual
Section 3 - Configuration
IPV6
On this page, the user can configure the IPv6 Connection type. There are two ways to set up the IPv6 Internet connection. You 
can use the Web-based IPv6 Internet Connection Setup Wizard, or you can manually configure the connection.
For  the  beginner  user  that  has  not  configured  a  router  before, 
click  on  the IPv6  Internet  Connection  Setup  Wizard button 
and the router will guide you through a few simple steps to get 
your...

41D-Link DIR-655 User Manual
Section 3 - Configuration
IPv6 Internet Connection Setup Wizard
On this page, the user can configure the IPv6 Connection type using the IPv6 Internet Connection Setup Wizard.
Click  the IPv6  Internet  Connection  Setup  Wizard  button  and 
the router will guide you through a few simple steps to get your 
network up and running.
Click Next to  continue  to  the  next  page.  Click Cancel  to  discard 
the changes made and return to the main page.
The  router  will  try  to...

42D-Link DIR-655 User Manual
Section 3 - Configuration
There  are  several  connection  types  to  choose  from.  If  you  are 
unsure  of  your  connection  method,  please  contact  your  IPv6 
Internet Service Provider. 
Note: If  using  the  PPPoE  option,  you  will  need  to  ensure  that 
any PPPoE client software on your computers has been removed 
or  disabled.  The  3  options  available  on  this  page  are  IPv6 
over  PPPoE,  Static  IPv6  address  and  Route,  and Tunneling 
Connection....

43D-Link DIR-655 User Manual
Section 3 - Configuration
IPv6 over PPPoE
After selecting the IPv6 over PPPoE option, the user will be able to configure the IPv6 Internet connection that requires a username and password 
to get online. Most DSL modems use this type of connection.
The following parameters will be available for configuration:
PPPoE Session:Select  the  PPPoE  Session  value  used  here.  This 
option  will  state  that  this  connection  shares  it’s 
information  with  the  already...

44D-Link DIR-655 User Manual
Section 3 - Configuration
Static IPv6 Address Connection
This mode is used when your ISP provides you with a set IPv6 addresses that does not change. The IPv6 information is manually entered in your 
IPv6  configuration  settings. You  must  enter  the  IPv6  address,  Subnet  Prefix  Length,  Default  Gateway,  Primary  DNS  Server,  and  Secondary  DNS 
Server. Your ISP provides you with all this information.
Use Link-Local 
Address:
IPv6 Address:
Subnet Prefix 
Length:...

45D-Link DIR-655 User Manual
Section 3 - Configuration
The following parameters will be available for configuration:
6rd IPv6 Prefix:Enter the 6rd IPv6 address and prefix value used 
here.
IPv4 Address:Enter the IPv4 address used here.
Mask Length:Enter the IPv4 mask length used here.
Assigned IPv6 Prefix:Displays the IPv6 assigned prefix value here.
6rd Border Relay IPv4 
Address:
Enter the 6rd border relay IPv4 address used here.
IPv6 DNS Server:Enter the primary DNS Server address used here.
The IPv6...

46D-Link DIR-655 User Manual
Section 3 - Configuration
There are several connection types to choose from: Auto Detection, Static IPv6, Autoconfiguration (SLAAC/DHCPv6), PPPoE, IPv6 in IPv4 Tunnel, 
6to4, 6rd, and Link-local. If you are unsure of your connection method, please contact your IPv6 Internet Service Provider. 
Note: If using the PPPoE option, you will need to ensure that any PPPoE client software on your computers has been removed or disabled.
Auto Detection
Select Auto Detection to have the...