Home > Craftsman > Garage Door Opener > Craftsman Garage Door Opener 34 Manual

Craftsman Garage Door Opener 34 Manual

Add to Favourites
    Download as PDF

    View the Craftsman Garage Door Opener 34 Manual for free. All the Craftsman manuals and user’s guides are available for free view without any registration. You can also download the manual as PDF to your computer.

    Overview View all the pages Comments
    Page 1 GARAGE DOOR OPENER Model 3595 3/4 HP For Residential Use Install on Sectional Doors ONLY THIS OPERATOR IS INTENDED FOR USE ONLY WITH I-BEAM RAILS. Owner’s Manual ■Please read this manual and the enclosed safety materials carefully! ■Fasten the manual near the garage door after installation. ■The door WILL NOT CLOSE unless the Protector System®is connected and properly aligned. ■Periodic checks of the opener are required to ensure safe operation. ■The model number label is located under the light lens on...
    Page 2 INTRODUCTION Safety Symbol and Signal Word Review This garage door opener has been designed and tested to offer safe service provided it is installed, operated, maintained and tested in strict accordance with the instructions and war\ nings contained in this manual. 2 When you see these Safety Symbols and Signal Words on the following pages, they will alert you to the possibility of serious injury or deathif you do not comply with the warnings that accompany them. The hazard may come from something...
    Page 3 3 To prevent damage to garage door and opener: • ALWAYS disable locks BEFORE installing and operating theopener. • ONLY operate garage door opener at 120V, 60 Hz to avoid malfunction and damage. To prevent possible SERIOUS INJURY OR DEATH: • ALWAYS call a trained door systems technician if garagedoor binds, sticks, or is out of balance. An unbalanced garage door may not reverse when required. • NEVER try to loosen, move or adjust garage door, door springs, cables, pulleys, brackets or their hardware,...
    Page 4 Safety Reversing SensorSupport bracket & fastening hardware is required. See page 11. — — — — — — — — Header Wall FINISHED CEILING Torsion Spring Extension Spring OR Safety Reversing Sensor Gap between floor and bottom of door must not exceed 1/4 (6 mm) Access Door Wall- mounted Door Control Horizontal and vertical reinforcement is needed for lightweight garage doors (fiberglass, steel, aluminum, door with glass panels, etc.). See page 18 for details. Motor Unit Slack in chain...
    Start reading Craftsman Garage Door Opener 34 Manual

    Related Manuals for Craftsman Garage Door Opener 34 Manual

    All Craftsman manuals