Compaq IPAQ Microportable Projector MP1200 Users Guide

8–6Compaq iPAQ Microportable Projector MP1200 User’s Guide
Troubleshooting
Lamp shuts off. 1. If the Standby LED flashes green, 
the projector has overheated and 
will automatically shut down. Wait 
five to ten minutes until the LED 
stops flashing and the 
Power/Standby button turns amber 
before restarting the projector again.
2. A minor power surge may cause the 
lamp to shut off. Wait a few minutes, 
then turn it back on.
3. When the lamp has reached the end 
of its life, the system will...

Troubleshooting
Compaq iPAQ Microportable Projector MP1200 User’s Guide8–7
Projector suddenly shuts down and 
the power button LED blinks 
rapidly.An over-temperature event has been 
detected. This usually occurs when 
either the airflow to the unit has been 
obstructed or a fan has failed. If airflow 
is obstructed, remove the obstruction, 
unplug the projector, re-plug the 
projector, and restart. If a fan has failed 
or an over-temperature event occurs a 
second time, have the projector 
serviced or...

8–8Compaq iPAQ Microportable Projector MP1200 User’s Guide
Troubleshooting
Image size is too small or too large.1. Adjust the digital zoom or move 
the camera until the image is the 
desired size.
2. The projector may be set to display 
in the center of the display area 
without any expansion. To change 
the setting, access the on-screen 
display menu, select A/V & HDTV 
Control, select HDTV/Video, then 
select how the image should be 
shown in the display area. Refer to 
Chapter 3, “Using the On-Screen...

Compaq iPAQ Microportable Projector MP1200 User’s GuideAppendix–1
Appendix
Agency Regulatory Notices
Federal Communications Commission 
Notice
This equipment has been tested and found to comply with the 
limits for a Class B digital device, pursuant to Part 15 of the 
FCC Rules. These limits are designed to provide reasonable 
protection against harmful interference in a residential 
installation. This equipment generates, uses, and can radiate radio 
frequency energy and, if not installed and used in...

Appendix–2Compaq iPAQ Microportable Projector MP1200 User’s Guide
Agency Regulatory Notices
Modifications
The FCC requires the user to be notified that if any changes or 
modifications are made to this device, not expressly approved by 
Compaq Computer Corporation, this may void the user’s 
authority to operate the equipment.
Cables
Connections to this device must be made with shielded cables 
with metallic RFI/EMI connector hoods to maintain compliance 
with FCC Rules and Regulations.
Declaration of...

Agency Regulatory Notices
Compaq iPAQ Microportable Projector MP1200 User’s GuideAppendix–3
Canadian Notice
This Class B digital apparatus meets all requirements of the 
Canadian Interference-Causing Equipment Regulations.
Avis Canadien
Cet appareil numérique de la classe B respecte toutes les 
exigences du Règlement sur le matériel brouilleur du Canada.
European Union Notice
Products bearing the CE Marking comply with the 
EMC Directive (89/336/EEC) and the Low Voltage Directive 
(73/23/EEC) issued by...

Appendix–4Compaq iPAQ Microportable Projector MP1200 User’s Guide
Agency Regulatory Notices
Japanese Notice
Power Cords
The power cord set (flexible cord or wall plug) received with the 
projector meets the requirements for use in the country where you 
purchased the equipment.
If you need to obtain a power cord for a different country, you 
should purchase a power cord that is approved for use in that 
country.
The power cord must be rated for the product and for the voltage 
and current marked on the...