Cisco Prime Nerk 43 User Guide

  
27-227
Cisco Prime Network 4.3.2 User Guide
EDCS-1524415
Chapter 27      Managing Mobile Networks
  Monitoring the Mobility Management Entity
Table 27-142 Policy Configuration Details
Field Description
IMEI Query type The type of IMEI query use for attaching the user equipment and tracking 
area update procedure, which can be any one of the following:
imei (International Mobile Equipment Identity)
imei-sv (International Mobile Equipment Identity-Software Version)
Set UE Time Indicates whether the MME...

  
27-228
Cisco Prime Network 4.3.2 User Guide
EDCS-1524415
Chapter 27      Managing Mobile Networks
  Monitoring the Mobility Management Entity
MME Policy Configuration Commands
The following MME policy configuration commands can be launched from the logical inventory by 
right-clicking a MME policy and choosing Commands > Configuration. Your permissions determine 
whether you can run these commands (see Permissions Required to Perform Tasks Using the 
Prime Network Clients). To find out if a device...

  
27-229
Cisco Prime Network 4.3.2 User Guide
EDCS-1524415
Chapter 27      Managing Mobile Networks
  Monitoring the Mobility Management Entity
Table 27-144 S1 Interface Configuration Details
Field Description
Primary IP Address The IP address (IPv4 or IPv6) of the interface configured as an S1-MME 
interface.
Secondary IP Address The optional IP address (IPv4 or IPv6) of the interface configured as an 
S1-MME interface.
SCTP Port The source SCTP port used for binding the SCTP socket to communicate...

  
27-230
Cisco Prime Network 4.3.2 User Guide
EDCS-1524415
Chapter 27      Managing Mobile Networks
  Viewing the Stream Control Transmission Protocol
S1 MME Interface Commands
The following S1 MME interface commands can be launched from the logical inventory by 
right-clicking an S1 MME interface and choosing Commands > Configuration. Your permissions 
determine whether you can run these commands (see Permissions Required to Perform Tasks Using the 
Prime Network Clients). To find out if a device...

  
27-231
Cisco Prime Network 4.3.2 User Guide
EDCS-1524415
Chapter 27      Managing Mobile Networks
  Viewing the Stream Control Transmission Protocol
designated as the primary address to receive data. A single port number is used across the entire 
address list at an endpoint for a specific session. Heartbeat chunks are used to monitor availability 
of alternate paths with thresholds set to determine failure of alternate and primary paths.
NoteAn “association here refers to the connection between two...

  
27-232
Cisco Prime Network 4.3.2 User Guide
EDCS-1524415
Chapter 27      Managing Mobile Networks
  Viewing the Stream Control Transmission Protocol
Table 27-146 describes the SCTP Template details.
Table 27-146 SCTP Template Details
Field Description
Template Name The unique name of the SCTP template.
NoteEach template can be configured with different values and 
associated to different services such as the MME service, diameter 
endpoint and so on.
RTO Alpha The Retransmission Timeout (RTO) alpha...

  
27-233
Cisco Prime Network 4.3.2 User Guide
EDCS-1524415
Chapter 27      Managing Mobile Networks
  Viewing the Stream Control Transmission Protocol
SACK Frequency The frequency of the Selective Acknowledgment (SACK) of the SCTP 
packets.
SACK Period The period (in milliseconds) of selective acknowledgment of the SCTP 
packets.
Heart Beat Status Indicates whether the option to send traffic over an alternate path, in case of 
a path failure, is enabled.
NoteThe Heartbeat message is sent to a peer...

  
27-234
Cisco Prime Network 4.3.2 User Guide
EDCS-1524415
Chapter 27      Managing Mobile Networks
  Viewing the Stream Control Transmission Protocol 

CH A P T E R
 
28-1
Cisco Prime Network 4.3.2 User Guide
28
Managing Data Center Networks
Data Center is a centralized repository, either physical or virtual for the storage, management, 
dissemination of data and information organized around a particular manner. In other words, it is a 
facility used to house computer systems and associated components, such as telecommunications and 
storage systems. It generally includes redundant or backup power supplies, redundant data 
communication connections,...

 
28-2
Cisco Prime Network 4.3.2 User Guide
Chapter 28      Managing Data Center Networks
  Viewing Virtual Port Channel (vPC) Configurations
Figure 28-1 vPC Architecture
A vPC consists of the following components:
Two vPC peer switches, among which one is primary and one is secondary. The system formed by 
the two peer switches is referred to as a vPC domain. 
A peer link, also known as multichassis EtherChannel trunk (MCT), which connects the vPC peer 
switches. A peer link is a redundant 10 Gigabit...