Christie Projector Mirage S+14k User Manual

INSTALLATION & SETUP 
  Roadster / Mirage S+ User’s Manual 2-5 
 
Figure 2.7. NEVER
 Use Handles for Hoisting or as Safety Points 
This procedure applies to one or more projectors. To hoist a stack, first stack 2 or 3 
projectors according to the stacking procedure included in this manual. Never stack 
or hoist more than 3 projectors together. 
Remove lens (recommended) 
To prevent possible lens damage during hoisting, remove the lens. See 4.4, Replacing 
the Lamp and Filter. 
Retract feet 
Retract the...

INSTALLATION & SETUP 
2-6 
Roadster / Mirage S+ User’s Manual 
Attach rigging hardware 
Secure your 
rigging 
components to the 
appropriate rigging 
points—8 sliding 
points are provided 
on the bottom. 
Tighten the nut at 
each required 
location (Figure 
2.9) to prevent 
sliding.  
NOTE: 1) Use at 
least 4 rigging 
points for all 
hoisting. 2) Use 
straps, clamps or 
cabling with load 
capacity adequate 
for the total 
projector weight. 
See Section 6. 3) 
Do not join the 
rigging straps or 
cables to...

INSTALLATION & SETUP 
  Roadster / Mirage S+ User’s Manual 2-7 
Position the projectors 
Place the projectors to be 
stacked on a secure table or 
cart. 
• Place one projector on its 
side to access its 
adjustable feet and 
stacking legs (Figure 
2.10). 
• Orient the other projector 
in either upright or 
inverted position as 
required (remember, 
each projector in a stack 
must be in the same 
orientation). 
 
Fully retract the (4) adjustable feet  
Retract each foot as far as possible by turning it...

INSTALLATION & SETUP 
2-8 
Roadster / Mirage S+ User’s Manual 
 
Figure 2.12. Loosen 2 Nuts 
• If upright – release on top projector. 
• If inverted – release on bottom projector. 
Release and remove (3) safety pins 
The safety pins must be removed from the 
stacking mounts so that the stacking legs can fit 
into the mounts (Figure 2.13).  
• If upright – remove the pins from the mounts 
on the bottom projector. 
• If inverted – remove the pins from the 
mounts on the top projector. 
 
 
 
 
 
Place top...

INSTALLATION & SETUP 
  Roadster / Mirage S+ User’s Manual 2-9 
 
Figure 2.14. Align Holes in Mounts and Legs, and LOCK with Pin 
Insert (3) safety pins and LOCK all 
 WARNING  
Critical Safety Procedure. 
At each of the (3) stacking points, insert the safety pin fully through the holes in the 
stacking mounts and stacking legs (Figure 2.14). Ensure that each pin is fully inserted to 
engage the safety lock and secure the projectors together. Failure to engage the safety 
lock could cause the projectors...

INSTALLATION & SETUP 
2-10 
Roadster / Mirage S+ User’s Manual 
Before You Begin 

INSTALLATION & SETUP 
  Roadster / Mirage S+ User’s Manual 2-11 
IF THE CENTER LINES ARE PARALLEL BUT MISALIGNED:  
• If centerlines are out by the same amount from top 
and bottom – use offsets (on top projector) to bring 
the centerlines into alignment. 
 
 
• If centerlines are parallel but 
others are not, turn the front 
stacking mount wheel to bring 
the centerlines into alignment. 
 
 
 
 
Align the edges of the grid 
With center lines aligned, adjust zoom (top projector) to align the edges of its...

INSTALLATION & SETUP 
2-12 
Roadster / Mirage S+ User’s Manual 
Rear Screen, Floor Mount Installation 
ADVANTAGES CONSIDERATIONS 
• Projector is completely hidden 
• Projector is easily accessed 
• Usually good ambient light rejection • Requires separate room 
• Requires rear projection screen 
 
Rear Screen, Inverted Mount (ceiling) Installation 
ADVANTAGES CONSIDERATIONS 
• Projector is completely hidden 
• Usually good ambient light rejection • Requires separate room 
• Installation cost is usually...

INSTALLATION & SETUP 
  Roadster / Mirage S+ User’s Manual 2-13 
To summarize, optical screens are better suited for brightly lit rooms where the 
audience is situated within the viewing cone. Diffused screens may be better suited 
when a wide viewing angle is required but there is low ambient room lighting. 
Screen size may vary from 4 feet (122 cm) to 45 feet (1372cm) diagonal, depending 
on the lens you are using. For instance, a 0.73:1 lens can produce a 5 foot (150 cm) to 
a 14 foot (548 cm) image...

INSTALLATION & SETUP 
2-14 
Roadster / Mirage S+ User’s Manual 
• Keep the projector away from devices which radiate electromagnetic energy such 
as motors and transformers. Common sources of these include slide projectors, 
speakers, power amplifiers, elevators, etc. 
• Choose the best screen size for the application. Since more magnification reduces 
brightness, use a screen size appropriate for the venue but not larger than 
required. Installing a large screen in a small room is similar to watching...