Christie Projector Mirage 5000 User Manual

7+52: ,67$1&(
(
0LUDJH 8VHU·V 0DQXDO 

7+52: ,67$1&(
0LUDJH 8VHU·V 0DQXDO( 

7+52: ,67$1&(
(
0LUDJH 8VHU·V 0DQXDO 

7+52: ,67$1&(
0LUDJH 8VHU·V 0DQXDO( 

7+52: ,67$1&(
(
0LUDJH 8VHU·V 0DQXDO 


&	
!
0LUDJH 8VHU·V 0DQXDO)
There are many optional input modules and accessories currently available for this projector. Contact your dealer for a
complete and up-to-date listing.
The Marquee Signal Switcher is a rack-mountable signal selector which can greatly
increase the number of analog sources (inputs) available to the projector. Connected
to 
,1387 , a single switcher provides up to 9 more sources to the projector.
Additional Marquee Signal Switchers can be...

237,21$/ ,1387 028/(6
)
0LUDJH 8VHU·V 0DQXDO
5*% )HDWXUHV
¡ accepts 3, 4, or 5 wire RGB video (sync-on-green, composite sync, or
separate horizontal and vertical sync), up to 500 MHz bandwidth
¡ BNC connectors for RGB signal inputs
NOTE: The audio connectors are not functional.
The RGB400 Buffered Amplifier Input Module may be installed in this projector, a
Marquee Signal Switcher or a Marquee Case/Power Supply. Connect three-, four-, or
five-wire RGB video signals of up to 400 MHz...

237,21$/ ,1387 028/(6
0LUDJH 8VHU·V 0DQXDO)
The Composite/S-Video Input Module may be installed in this projector, a Marquee
Signal Switcher or a Marquee Case/Power Supply. The module receives either
composite video or S-video input signals from tape or disk players (do not connect
both types of signals simultaneously). Video inputs are 75
6  terminated. Video
outputs are provided for buffered loop-through to another display device.
&RPSRVLWH6YLGHR )HDWXUHV
¡ BNC connectors for composite RGB...

237,21$/ ,1387 028/(6
)
0LUDJH 8VHU·V 0DQXDO
The DVI/DFP Input Module can be installed in the projector to display digital video
input signals conforming to the DVI (Digital Visual Interface) standard (single-
channel) or the DFP (Digital Flat Panel Port) specification.
)HDWXUHV
¡ Supports Digital Visual Interface (DVI) single-channel and Digital Flat
Panel Port (DFP) standards
¡ Supports VESA
“ Extended Display Identification Data (EDID
•)
¡ Provides an active-loop-through using a 20-pin MDR...

237,21$/ ,1387 028/(6
0LUDJH 8VHU·V 0DQXDO)
The Serial Digital Input Module (SDI) can be installed in the projector at ,1387 ,
where it accepts a serial digital 4:2:2 component video signal (YCbCr) via a single
6(5,$/ ,1 BNC connector. The signal can loop through the 6(5,$/ 287 BNC out to
another device (such as another projector). Inputs are 75
6  terminated.
6, )HDWXUHV
¡ accepts serial digital 4:2:2 component video (YCbCr)
¡ provides both a 
6(5,$/ ,1 and a 6(5,$/ 287BNC connector
¡...