Christie Projector DUW350S User Manual

							Section 2: iNTRodUCTioN
11
Control Panel2.2.2 
1324
5
8
7 6
9
Ind.Part Name
1 Power LED
2 Enter
3 Temp LED
4 Lamp LED
5 Menu
6 Input
7 Four Directional Select keys
8 Power/Standby button
9 IR Receiver
CAPTIVA DUW350S/CAPTIVA DHD400S User Manual020-000816-01  Rev. 1 (07-2015)                                   
						

							Section 2: iNTRodUCTioN
12
Output Connections2.2.3 
7
1 4
10 14 5
11 1 2 16
8 6
91 31517
23
Ind.Connector Name
Ind.Connector Name
1 VGA1-In/YPbPr Connector  
(PC Analog Signal/Component 
Video Input/HDTV/YPbPr)  10
RS-232 Connector (9-pin DCE type)
2 HDMI2 Input Connector  11Composite Video Input Connector
3 HDMI1 Input Connector  12Composite Audio Input (right) 
Connector 
4 USB Connector (Connect PC for 
firmware	upgrade	or	interactive)13 Composite Audio Input (left) 
Connector 
5 RJ45 connector 14Audio Output Connector (3.5mm 
mini jack) 
6 USB Type A Connector 15Audio Input Connector (3.5mm mini 
jack) 
7 Power Socket 16Audio Input Connector (microphone) 
8 Interactive Connector (3.5 mm mini 
jack) 17
KensingtonTM Lock Port
9 VGA-Out/VGA2-In Connector
NOTE:
Monitor loop through only support in VGA1-In/YPbPr. ™
CAPTIVA DUW350S/CAPTIVA DHD400S User Manual020-000816-01  Rev. 1 (07-2015) 
						

							Section 2: iNTRodUCTioN
13
Remote Control2.2.4 
1
2
5
6
9
10
14 15
16
18 20 3
4
7
8
11
12
13
1719
21
2223Ind.Part Name
1 Infrared transmitter
2 LED Indicator
3 Power On/Off
4 Enter
5 Four Directional Select keys
6 Menu
7 Exit
8 Zoom in
9 Reset
10 Auto
11 Input
12 Zoom out
13 Volume +/-
14 Keystone +/-
15 Image
16 Picture mute
17 Aspect ratio
18 VGA1
19 HDMI1
20 VGA2
21 HDMI2 
22 Video
23 Screen freeze
CAPTIVA DUW350S/CAPTIVA DHD400S User Manual020-000816-01  Rev. 1 (07-2015) 
						

							Section 3: iNSTallaTioN
14
INSTALLATION3. 
Connecting the Projector3.1 
Connect to Computer/Notebook3.1.1 
E62405SPR
MOLEX
1
5
109
Ind.Connector NameInd.Connector Name
1 RS232 Cable 7Power Cord
2 VGA Cable 8VGA Output Cable
3 HDMI Cable 9DC to DC Cable
4 USB Cable 10Audio Output Cable
5 Audio Cable/RCA 11Audio Input Cable
6 RJ45 Cable
Router/Network switch
Audio Output Microphone
External Display
CAPTIVA DUW350S/CAPTIVA DHD400S User Manual020-000816-01  Rev. 1 (07-2015) 
						

							Section 3: iNSTallaTioN
15
Connect to Video Sources3.1.2 
E62405SP
R
Ind.Connector NameInd.Connector Name
1 15-Pin to 3 RCA Component/HDTV 
Adaptor 5
Power Cord
2 HDMI Cable 6Composite Video Cable
3 Audio Cable 7Audio Cable/RCA
4 Audio Cable/RCA 8Audio Input Cable
Composite Video Output DVD Player, Set-top Box, 
HDTV receiver
MicrophoneAudio Output
1
5
6
4
7
3
2
8
CAPTIVA DUW350S/CAPTIVA DHD400S User Manual020-000816-01  Rev. 1 (07-2015) 
						

							Section 3: iNSTallaTioN
16
Powering the Projector On/Off3.2 
Powering On the Projector3.2.1 
Securely connect the power cord and signal cable. When connected, 
1. 
the POWER/STANDBY LED turns Orange.
Turn on the projector by pressing 
2
. “” button either on the projector 
or on the remote. At this moment, the POWER/STANDBY LED turns 
Blue. 
The	startup	screen	will	display	in	approximately	5	seconds.	The	first	3. 
time you use the projector, you will be asked to select the preferred 
language and power saving mode. 
Turn on and connect the source that you want to display on the 
4
. 
screen (computer, notebook, video player, etc). The projector 
detects the source automatically. If not, push menu button and go to 
“OPTIONS”.   
Make sure that the “Source Lock” has been set to “Off”.
NOTE:
If you connect multiple sources at the same time, press the “INPUT”\
 button on the control panel  ™ or direct source keys on the remote control to switch between inputs.
When the power mode is in standby mode (power consumption < 0.5W), the\
 VGA output/input 
 ™and audio are deactivated when the projector is in standby.
POWER/STANDBY1
CAPTIVA DUW350S/CAPTIVA DHD400S User Manual020-000816-01  Rev. 1 (07-2015)  
						

							Section 3: iNSTallaTioN
17
Powering off the projector3.2.2 
Press the “
1. ” button on the remote control or on the control panel to 
turn off the projector. The following message will be displayed on the 
screen. 
Press	power	key	again	to	confirm
   Press the “”	button	again	to	confirm	otherwise	the	message	will	
disappear after 10 seconds. When you press the “” button for the 
second time, the fan will start cooling the system and will shut down.
The cooling fans continue to operate for about four seconds for 
2
. 
cooling	cycle	and	the	POWER/STANDBY	LED	will	flash	Orange.	
When the POWER/STANDBY LED lights solid Orange, the projector 
has entered standby mode.
  If you want to turn the projector back on, you must wait until the 
projector has completed the cooling cycle and has entered standby 
mode. Once in standby mode, press “
” button to restart the 
projector.
Disconnect the power cord from the electrical outlet and the projector.
3
. 
Warning Indicator3.2.3 
When the warning indicators (see below) come on, the projector will 
automatically shutdown:
“LAMP” LED indicator is lit red and if “POWER/STANDBY” indic\
ator 
 y
flashes	amber.
“TEMP” LED indicator is lit red, this indicates the projector has \
 y
overheated. Under normal conditions, the projector can be switched 
back on.
“TEMP”	LED	indicator	flashes	red	and	if	“POWER/STANDBY”	 y
indicator	flashes	amber.	 
Unplug the power cord from the projector, wait for 30 seconds and 
try again. If the warning indicator light up again, contact your service\
 
center for assistance. 
CAPTIVA DUW350S/CAPTIVA DHD400S User Manual020-000816-01  Rev. 1 (07-2015) 
						

							Section 3: iNSTallaTioN
18
Adjusting the Projected Image3.3 
Adjusting the Projector�s Height3.3.1 
The projector is equipped with elevator feet for adjusting the 
image height.
Locate the adjustable foot you want to modify on the underside of the 
1. 
projector. 
Rotate the adjustable ring clockwise to raise the projector or counter 
2
. 
clockwise to lower it. Repeat with the remaining feet as needed.
Tilt-Adjustment Feet
Tilt-Adjustment Ring
CAPTIVA DUW350S/CAPTIVA DHD400S User Manual020-000816-01  Rev. 1 (07-2015) 
						

							Section 3: iNSTallaTioN
19
Adjusting the Projector�s Focus3.3.2 
To focus the image, slide the focus switch to left/right until the 
image is clear.  
1080p series: The projector will focus at distances from 1.443 to 1.887  yfeet (0.437 to 0.572 meters).
Ultra Wide series: The projector will focus at distances from 1.413 to 
 y1.884 feet (0.428 to 0.571 meters).
Focus switch
CAPTIVA DUW350S/CAPTIVA DHD400S User Manual020-000816-01  Rev. 1 (07-2015)  
						

							Section 3: iNSTallaTioN
20
Adjusting Projection Image Size (Diagonal)3.3.3 
1080p series: Projection Image Size from 80” to 100” (2.03 to 2.5\
4  ymeters).
Ultra Wide series: Projection Image Size from 120” to 140” (3.05 to 3.56 
 ymeters).
Top View
Side View Projection Distance (D)
Screen
Screen (W)
Screen (H)
Wide
diagonal
Offset (Hd)
Screen
Projection Distance (D)
Height
DHD400S
Diagonal length (inch) size of  16:9 Screen Screen Size W x H
Projection Distance (D)
Offset (Hd)
(mm) (inch) (mm)(inch)
Width Height WidthHeight widetelewide tele(mm) (inch)
87 192.6 108.3  75.8 42.6 23.3  NA9.2  NA28.9  11.4 
90 199.2 112.1  78.4 44.1 24.9  NA9.8  NA29.6  11.7 
95 210.3 118.3  82.8 46.6 27.7  NA10.9  NA30.9  12.2 
100 221.4 124.5  87.2 49.0 30.5  NA12.0  NA32.2  12.7 
102 225.8 127.0  88.9 50.0 31.6  NA12.4  NA32.7  12.9 
CAPTIVA DUW350S/CAPTIVA DHD400S User Manual020-000816-01  Rev. 1 (07-2015)