Casio Exilim Ex S500 Users Guide

GETTING READY
31
 IMPORTANT! 
Be sure to keep the strap around your wrist when
using the camera to protect against accidentally
dropping it.
The supplied strap is intended for use with this
camera only. Do not use it for any other purpose.
Never swing the camera around by the strap.
Attaching the Strap
Attach the strap to the strap ring as shown in the
illustration.
 IMPORTANT! 
Pressing [] (DISP) will not change monitor screen
contents during standby or recording of an audio
snapshot.
You can use...

GETTING READY
32
2.While pulling the stopper in the direction
indicated by the arrow in the illustration, align
the arrow mark on the battery with the arrow
mark on the camera and slide the battery into
the camera.
NP-20
Push the bottom of the battery, and make sure that
the stopper securely locks the battery in place.
Stopper
Power Requirements
Your camera is powered by a rechargeable lithium ion
battery (NP-20).
Loading the Rechargeable Battery
1.Slide the battery cover in the direction
indicated by...

GETTING READY
33
To charge the battery
1.Connect the bundled AC adaptor to the [DC IN
5.3V] connector of the USB cradle, and then
plug it in to a household power outlet.
Note the shape of the AC adaptor depends on the
area where you purchased the camera.
AC Adaptor
[DC IN 5.3V]USB Cradle
AC power cord
3.Swing the battery cover closed, and then slide
it in the direction indicated by the arrow.
 IMPORTANT! 
Use only the special NP-20 rechargeable lithium ion
battery to power this camera. Use of any other...

GETTING READY
34
 NOTE 
The AC adaptor is designed for operation on power
ranging from 100V AC to 240V AC. Note, however,
that the shape of the power cord plug varies
according to country or geographic area. It is up to
you to find out if the shape of the AC adaptor power
cord plug is compatible with local power outlets when
traveling abroad.
Never use the AC adaptor with a voltage converter.
2.Turn off the camera.
3.Set the camera onto
the USB cradle.
Do not place the camera
onto the USB cradle
while...

GETTING READY
35
If the [CHARGE] lamp starts flashing red, it means
that an error occurs while charging. An error can be
caused by any of the following: a problem with the
USB cradle, a problem with the camera, or a problem
with the battery or how it is loaded. Remove the
camera from the USB cradle and see if it works
normally.
The only operations that can be performed while the
camera is on the USB cradle are: battery charging,
Photo Stand, image output to a TV, and USB data
communication.4.After...

GETTING READY
36

 Battery Life Guidelines
The battery life guideline values given below indicate the
amount of time under the conditions defined below the
table, until power automatically turns off due to battery
failure. They do not guarantee that the battery will provide
the amount of service indicated. Low temperatures and
continued use reduce battery life.
Apporoximate Battery Life
200 shots (100 minutes)
410 shots (100 minutes)
160 minutes
80 minutes
160 minutes
Operation
Number of Shots (CIPA...

GETTING READY
37
The above values are based on a new battery starting
from a full charge. Repeated charging shortens battery
life.
Battery life is greatly affected by how much you use flash,
zoom and auto focus, and how long you leave power
turned on.

 Tips to Make the Battery Last Longer
If you do not need the flash while recording, select (flash off) for the flash mode. See page 61 for more
information.
Enable the Auto Power Off and the Sleep features (page
44) to protect against wasting battery...

GETTING READY
38
To replace the battery
1.Open the battery cover.
2.Pull the stopper in the direction indicated by
the arrow.
This will cause the battery to come part way out of
the slot.
3.Release the stopper and pull the battery from
the camera.
Take care so you do not drop the battery.
4.Load a new battery into the camera (page 32).
Stopper

 Low Battery Indicator
The following shows how the battery capacity indicator on
the monitor screen changes as battery power is used. The
 indicator means that...

GETTING READY
39
Failure to observe any of the following precautions
while using the battery creates the risk of overheating,
fire, and explosion.
—Never use any other type of charger except the
optional charger specified for the battery.
—Never try to use the battery to power any device
other than this camera.
—Never use or leave the battery near open flame.
—Never place the battery in a microwave oven, throw
it into fire, or otherwise expose it to intense heat.
—Make sure the battery is oriented...

GETTING READY
40
PRECAUTIONS DURING USE
The battery is designed for use with this CASIO digital
camera only.
Use only the USB cradle that comes with the camera or
the specified optional charger to charge the battery.
Never use any other type of charger for charging.
Use of a battery in cold environments shortens the
operating time you can expect on a full charge. Charge
the battery in a location where the temperature is in the
range of 10°C to 35°C (50°F to 95°F). Charging outside
this temperature...