Casio Ex Fc200s Users Guide

161Other Settings (Set Up)
Procedure
[MENU] * Set Up Tab * Auto Power Off
Auto Power Off turns off the camera whenever no camera operation is performed for 
a preset amount of time.
Trigger Time Settings: 2 min, 5 min, 10 min (The trigger time is always 5 minutes in 
the PLAY mode.)
• Auto Power Off is disabled under any of the following conditions.
– While the camera is connected to a computer or other device
– During a slideshow
– During CS group playback
– During movie recording and playback...

162Other Settings (Set Up)
Procedure
[MENU] * Set Up Tab * USB
You can use the procedure below to select the USB communication protocol, which is 
used when exchanging data with a computer, printer, or other external device.
Procedure
[MENU] * Set Up Tab * Video Out
You can use the procedure in this section to select either NTSC or PAL as the video 
output system. You can also specify an aspect ratio of 4:3 or 16:9.
• Select the aspect ratio (4:3 or 16:9) that matches the type of TV you plan to use....

163Other Settings (Set Up)
Procedure
[MENU] * Set Up Tab * HDMI Output
• See page 112 for details.
Procedure
[MENU] * Set Up Tab * Startup
Display the image you want to use as your startup image and then select “On”.
• The startup image does not appear when you turn on the camera by pressing [p] 
(PLAY).
• You can specify a snapshot you recorded as the startup image, or you can use the 
special startup image provided in the camera’s built-in memory.
• Formatting built-in memory (page 164) will delete the...

164Other Settings (Set Up)
Procedure
[MENU] * Set Up Tab * Format
If a memory card is loaded in the camera, this operation will format the memory card. 
It will format built-in memory if no memory card is loaded.
• The format operation will delete all contents on the memory card or in built-in 
memory. It cannot be undone. Make sure you do not need any data currently on 
the card or in built-in memory before you format it.
• Formatting built-in memory will delete the following data.
– Protected images
–...

165Appendix
Appendix
.Avoid Use While In Motion
• Never use the camera to record or play back images while operating an automobile 
or other vehicle, or while walking. Looking at the monitor while in motion creates 
the risk of serious accident.
.Directly Viewing the Sun or Bright Light
• Never look at the sun or any other bright light through the cameras viewfinder. 
Doing so can damage your eyesight.
.Flash
• Never use the flash unit in areas where flammable or explosive gas may be 
present. Such...

166Appendix
.Smoke, abnormal odor, overheating, and other abnormalities
• Continued use of the camera while it is emitting smoke or strange odor, or while it 
is overheating creates the risk of fire and electric shock. Immediately perform the 
following steps whenever any of the above symptoms are present.
1. Turn off the camera.
2. Remove the battery from the camera, taking care to protect yourself against burn 
injury.
3. Contact your dealer or nearest CASIO authorized service center.
.Water and...

167Appendix
.Locations To Be Avoided
• Never leave the camera in any of the following types of locations. Doing so creates 
the risk of fire and electric shock.
– Areas subject to large amounts of humidity or dust
– Food preparation areas or other locations where oil smoke is present
– Near heaters, on a heated carpet, in areas exposed to direct sunlight, in a closed 
vehicle parked in the sun, or other areas subject to very high temperatures
• Never place the camera on an unstable surface, on a high...

168Appendix
• Should you ever notice leakage, strange odor, heat generation, discoloration, 
deformation, or any other abnormal condition while using, charging, or storing a 
battery, immediately remove it from the camera and keep it away from open flame.
• Do not use or leave the battery under direct sunlight, in an automobile parked in the 
sun, or in any other area subject to high temperatures. Doing so can damage the 
battery, and cause deterioration of its performance and loss of service life.
• If...

169Appendix
.Data Error Precautions
Your digital camera is manufactured using precision digital components. Any of the 
following creates the risk of corruption of data in camera memory.
– Removing the battery or memory card while the camera is performing some 
operation
– Removing the battery or memory card while the back lamp is flashing green after 
turning off the camera
– Disconnecting the USB cable while communication is in progress
– Using a battery that is low
– Other abnormal operations
Any of...

170Appendix
.Caring for your camera
• Never touch the lens or flash window with your fingers. Finger smudges, dirt, and 
other foreign matter on the lens or flash window can interfere with proper operation 
of the camera. Use a blower or other means to keep the lens and flash window free 
of dirt and dust, and wipe gently with a soft, dry cloth.
• To clean the camera, wipe it with a soft, dry cloth.
.Old Rechargeable Battery Handling Precautions
• Insulate the positive and negative terminals with tape,...