Home > Carrier > Thermostat > Carrier Tstatccnhp01 B Manual

Carrier Tstatccnhp01 B Manual

Add to Favourites
    Download as PDF

    View the Carrier Tstatccnhp01 B Manual for free. All the Carrier manuals and user’s guides are available for free view without any registration. You can also download the manual as PDF to your computer.

    Overview View all the pages Comments
    Page 1 Non-Programmable Thermostats Installation, Start-Up, and Operating Instructions NOTE:Read the entire instruction manual before starting the installation. This symbol®indicates a change since the last issue. SAFETY CONSIDERATIONS Read and follow manufacturer instructions carefully. Follow all local electrical codes during installation. All wiring must conform to local and national electrical codes. Improper wiring or installa- tion may damage thermostat. Recognize safety information. This is the...
    Page 2 Step 3ÐInstall Thermostat Before installing thermostat, turn off all power to unit. There may be more than 1 power disconnect. Electrical shock can cause personal injury or death. 1. Turn OFF all power to unit. 2. If an existing thermostat is being replaced: a. Remove existing thermostat from wall. b. Disconnect wires from existing thermostat, 1 at a time. Be careful not to allow wires to fall back into the wall. c. As each wire is disconnected, record wire color and terminal marking. d. Discard or...
    Page 3 compensate for current. There is also no droop with this thermo- stat, regardless of anticipator setting. This adjustment controls only sensitivity and cycle rate up to the maximum of 4 cycles per hr. TO ADJUST: 1. Enter configuration mode (if not already there). 2. Use up and down buttons to display 01. This selects Option 1. The SET icon should be off. 3. Press MODE button once. The SET icon will come on. The display now shows Option 1 setting. 4. Use up and down buttons to move between the available...
    Page 4 higher or lower value. The selected number is the number of degrees, plus or minus, which will be added to the actual temperature. The number can range between -5 and +5. Factory default is 0. This adjusted value will be used as actual temperature for both display and control action. For example, if 2 is selected, 72ÉF actual will read 74ÉF. If set point is 72, the room will control to an actual value of 70 which will be displayed and acted upon as if it were 72. The effect is that a positive number...
    Start reading Carrier Tstatccnhp01 B Manual

    Related Manuals for Carrier Tstatccnhp01 B Manual

    All Carrier manuals