Home > Carrier > Trailer Refrigeration > Carrier Microlink 3 Manual

Carrier Microlink 3 Manual

Add to Favourites

Download as PDF

View the Carrier Microlink 3 Manual for free. All the Carrier manuals and user’s guides are available for free view without any registration. You can also download the manual as PDF to your computer.

Overview View all the pages Comments

Page 1 Please circulate this newsletter to all of your support personnel
Carrier Transicold Division • P.O. Box 4805 • Syracuse, New York 13221 • +1 315-432-7688 • Fax +1 315-432-7698
AN EXCHANGE OF TECHNICAL INFORMATION
ABOUT CARRIER TRANSICOLD CONTAINER PRODUCTS VOLUME 9 NUMBER 1 1st Quarter 2004
Inside This Issue
Te c hTi p
Software Release Update
F3 Fuse / Economizer Solenoid Valve Coil
Te c hFact
Manual Defrost
High Pressure Switch
Selection of Oil Filter
Lower Vent Positioning Sensor...

Page 2 Feature Article
MicroLink 3
Carrier Transicold is proud to announce its latest
edition to the microprocessor family, the ML3
controller. This new controller will have all the
same capabilities as the previous ML2i controller,
as well as some new enhancements.
Some of these enhancements are listed below.
• Increased I/O; Additional internal relays
allows for the added I/O capacity and future
growth.
• Enhanced battery charging, this will shorten
the time required to charge the battery for
recording...

Page 3 Feature Article - MicroLink3 (cont)
Software Card
The ML3 controller will require a new type of
programming card. The new type is referred to as a
PCMCIA card. Although there are many versions of
cards available throughout the world, Carrier Transicold
has selected one that fits its application and is guaran-
teed to work properly. The new card part number is
12-00594-XX. Carrier Transicold only supports the use
of this card.
This card can hold the configuration and operation
software for all 5XX...

Page 4 To program Operational Software into the
controller:
1. Turn Power off
2. Insert software/programming PCMCIA card
containing the following (example) files:
•menuDDMM.ml3, this file allows the user
to chose which file/program to upload into
the controller.
•cfYYMMDD.ml3, multi-configuration file
•recp51XX.ml3, controller software program
for recip units.
•scrl53XX.ml3, controller software program
for scroll units.
3. Turn unit Power On. Displays will show:
ruN COnFG
4. Press the UP or DOWN...

Start reading Carrier Microlink 3 Manual
All Carrier manuals