Canon projector LE5W BK User Manual

11
Precautions for Use
As this section contains important safety-related information, be sure to read the following carefully 
beforehand in order to use your projector correctly and safely.
If the following situations occur, turn the power off, remove the power plug from the power outlet 
and contact the Canon Customer Support Center. Failure to do so could cause a fire or result in an 
electric shock. 
• If smoke is emitted
• If an unusual smell or noise is emitted
• If a loud noise is heard and the...

12
Pay attention to the following point to prevent the small parts from being accidentally swallowed 
by children.
• Small parts such as the remote control battery, battery holder and adjustable feet that were 
detached may be accidentally swallowed by small children, which may result in choking.  
Parents/Guardians should keep them out of reach of children. If swallowed, consult a doctor 
immediately.
Warning
Pay attention to the following points regarding the power source, power plug and handling of...

13
Precautions for Installation
Pay attention to the following points regarding installation and handling of the projector. Failure 
to do so may cause a fire, electric shock or personal injury.
• Do not use the projector in a bathroom or shower room.
• Do not use the projector in rain or snow, by the sea, or in close proximity to a body of water.
• Do not place containers containing a liquid on top of the projector.
• Do not place the projector in any location where it will be exposed to oily smoke or...

14
Pay attention to the following points regarding installation and handling of the projector.
• If the projector will not be used for a long period of time, be sure to remove the power plug 
from the power outlet to ensure safety. Failure to do so could cause a fire. 
•
The temperature of the cabinet around and above the exhaust vents can become hot during 
projector operation. 
Touching these areas during operation could cause burns to the hands.
Do not touch these areas. Doing so may cause burns. Pay...

15
Precautions for the remote control batteries
Caution for viewing 3D content
Pay attention to the following points regarding handling of batteries. Failure to do so could result 
in a fire or injury.
• Do not place the batteries in a fire or apply heat to, short circuit or disassemble the batteries.
• Do not attempt to recharge the batteries.
• Insert the batteries in the correct + / - positions.
• If any liquid leaks from the batteries and comes into contact with skin, wash off thoroughly 
with...

16
For Safe Use
Pay attention to the following points when carrying or transporting the projector.
• This projector is a precision instrument. Do not knock it over or subject it to impacts. Doing 
so may cause a malfunction.
Pay attention to the following points when installing or using the projector.
• Be sure to install the projector in a location where the air intake and exhaust vents are 
separated from the wall by more than 30 cm (1.0). Failure to do so could cause a malfunction.
• Do not install...

17 Introduction
Introduction 

Introduction 18
Contents of package
Carefully unpack and verify that you have all of the items shown below. If any of these 
items are missing, contact your place of purchase.
Projector Power  cord  (1.8  m) Computer cable (1.8 m) 
(5K.1VC09.501) 
Users Manual (CD-ROM) 
and Quick Start Guide Warranty card Carrying bag
Remote control
(Model number: LE-RC01)  
Battery (CR2025) 
(US)
(EU) 

19 Introduction
Projector part names
1. Air intake vent (P20) 
2. Air exhaust vent (P20) 
3. Control panel and indicators 
(P20) 
4. Internal speakers
5. Focus ring (P27
)
6. Front IR remote sensor (P22)
7. Projection lens
8. Lens shutter (P27, P31
)
9. AC power jack (P26) 
10. Anti-theft lock slot
11. SD card slot (P42
)
12. Type A USB jack (P43)
13. Mini-B USB jack (P36)
14. HDMI input jack (P36)
1
2
8
7
6
3
54
4
Front/upper side
19
20
19
9
1012 11131415161718
Rear/lower side15. PC input jack (P34,...

Introduction 20
•  Do not block the vents. Blocking the vents can cause your projector to 
overheat and may cause a malfunction.
•  Do not brush or rub the top surface of the projector The surface may be 
damaged.
Control panel and indicators
Caution
Air intake
Air 
intake
Air 
intake Air exhaustAir exhaustAir exhaust
Air 
exhaust
Speaker
Speaker
Air intake vent 
in the base
2. POWER button/POWER LED 
indicator
Lights up or flashes when the 
projector is operating. Turns the 
projector on or off.
3....