Canon printer PIXMA MG5720 User Manual

Please check and try again.
Click [Scanner Selection] if you want to select another
scanner.
Scanner driver will be closed.
152Running out of memory.
Increase available memory.
Scanner driver will be closed.

Mechanical Problems
Power Does Not Come On
Power Shuts Off By Itself
USB Connection Problems
Cannot Communicate with Machine via USB
LCD Is Off
LCD Shows Wrong Language
Print Head Holder Does Not Move to Replacement Position
Printer Status Monitor Not Displayed (Windows)
893 

Power Does Not Come On
Check1 Press ON button.
Check2
 Make sure power plug is securely connected to machine, and then turn it back
on.
Check3  Unplug machine, leave it for at least 3 minutes, and then plug it back in and
turn it on again.
If this does not solve the problem, contact your nearest Canon service center to request a repair.
894 

Power Shuts Off By Itself
Check If machine is set to turn off automatically after a certain time, disable this setting.
If you have set the machine to turn off automatically after a specified time, the power will shut off by itself once
that time has elapsed.

USB Connection Problems
Printing or Scanning Is Slow/Hi-Speed USB Connection Does Not
Work/"This device can perform faster" Message Appears (Windows)
If your system environment does not support Hi-Speed USB, the machine operates at the slower speed of USB 1.1. In this case, the machine works properly but printing or scanning speed may slow down due to
the communication speed.
Check  Check following to make sure your system environment supports Hi-Speed
USB connection.

Cannot Communicate with Machine via USB
Check1 Make sure machine is turned on.
Check2 Connect USB cable properly.
As the illustration below, the USB port is at the back of the machine.
Check3  Do not start IJ Network Tool while printing.
Check4 Do not print while IJ Network Tool is running.
Check5 Make sure  Enable bidirectional support  is selected in Ports sheet of
properties dialog box of printer driver. (Windows)
How to Open the Printer Driver Setup Window
897 

LCD Is Off

LCD Shows Wrong Language
Follow the instructions below to select your language.
1.
Press HOME  button and wait for about 5 seconds.
2.
Select  Setup  on HOME screen.
LCD and Operation Panel
3.
Select  Device settings  and press OK button.
4.
Press  button 4 times and press  OK button.
5.
Use  button to select a language for LCD and press  OK button.
899 

Print Head Holder Does Not Move to Replacement Position
Check1 Is POWER  lamp off?
Check if the  POWER lamp is lit.
The print head holder will not move unless the power is on. If the  POWER lamp is off, close the operation panel
and turn the machine on.
The  POWER  lamp flashes while the machine is initializing. Wait until the  POWER lamp stops flashing and
remains lit, and then open the operation panel again.
Check2  Is an error message displayed on LCD?
Close the operation panel, follow the support...