Canon printer PIXMA iP110 User Manual

Changing the WEP Detailed Settings
Note

2.Key Length:
Select either  64bit or 128bit .3.
Key Format:
Select either  ASCII or Hex .
4.
Key ID:
Select the Key ID (index) set to the access point.
5.
Authentication:
Select the authentication method to authenticate the printer's access to the access point. Normally, select  Auto. If you want to specify the method manually, select  Open System or
Shared Key  according to the setting of the access point.
7.
Click OK.
Important

Changing the WPA/WPA2 Detailed Settings
Note

8.
Enter the passphrase, then click Next>.
Enter the passphrase set to the access point. The passphrase should be a string of 8 to 63 alphanumeric
characters or a 64-digit hexadecimal value.
If you do not know the access point passphrase, refer to the instruction manual provided with the access point or contact its manufacturer.
The dynamic encryption method is selected from either TKIP (basic encryption) or AES (secure
encryption) automatically.
Important

Important

Changing the Settings in the Wired LAN Sheet
Note

Changing the Settings in the Admin Password Sheet
Note

Monitoring Wireless Network Status
Note

6.Check the status.
When the measurement is complete, the status is displayed.
When  is displayed in  Connection Performance between the Printer and the Access Point: , the
printer can communicate with the access point. Otherwise, refer to displayed comments and the following to improve the status of communication link, and click  Remeasurement.

If  still appears even if you have tried the above, finish the measurement, then restart the IJ Network
Tool to start over the measurement.7.
Click  Finish .
Note