Canon lens EF 200400mm f4L IS USM Extender 14X User Manual

							ENG-20
14. Case
Put the lens away as follows.
 Reverse the lens hood, slip it over the lens, 
and attach the lens cap. 
 Position the tripod mount towards you as 
shown  and place it in the case.
 Place so 

that the hood’s lock knob faces 
toward the front (handle) side of the case as 
shown in the illustration.
 Fold the 
 strap and fit it into the space near 
the case levers.
 Fasten the lens securely with the strap.
 Close the lid, and then push the lever while 
holding  the lid from above to lock.
●●Do not sit on top of the lens case.
●● Place the lens in the position intended for it.
Keyhole
Lock knob
Lid
Hinge
Lever
Strap
COPY  
						

							ENG-21
15.  Using the Tripod 
Mount
A tripod or monopod attaches to the tripod 
mount on the lens.
Adjusting the Tripod MountBy loosening the orientation locking knob on the 
tripod mount you can rotate the camera to set 
the image for any vertical or horizontal position.
Replacing the Tripod MountReplacement with the included monopod mount 
can be done at a Canon Service Center at cost.
Since the mount requires special fastening, as 
a safety precaution, do not replace the mount 
yourself.
16.  Security Slot
An attachment slot is provided for a wire-type 
security lock. The slot is located under the cover 
for the orientation locking knob.
A wire-type security lock can be purchased 
separately.
COPY  
						

							ENG-22
17. Drop-In Filters
A 52(WII)-series drop-in gelatin filter holder with 
a glass filter is included with the lens. The drop-
in filter holder can be used fitted with a gelatin 
filter (sold separately).
14mm14mm
47mm
47mm

To remove the drop-in filter, press in the left 
and right lock buttons and pull the filter holder 
straight up out of the slot.
To install the drop-in filter, push the filter holder 
straight down into the slot until it clicks into place.
●●The filter holder can be installed facing either 
forwards or backwards.The Drop-In Screw-Type Filter Holder 52(WII) and 
Drop-In Circular Polarizing Filter PL-C52(WII) are 
also available (sold separately).
Because the lens optics are designed to include a 
glass filter, you must always install the filter holder, 
even if no gelatin filter is fitted.
 Lift up the holder’s retaining plate.
 Cut the gelatin filter as shown and mount it in 
the 
holder.
 Return the retaining plate to its closed 
position.

COPY  
						

							ENG-23
18. Extenders (Sold Separately)
Lens specifications when using extender EF1.4x II/III or EF2x II/III are as follows.
When the internal extender is set at 1x
 Extender EF1.4x II/IIIExtender EF2x II/III
WIDE TELEWIDE TELE
Focal length (mm) 280560400800
Aperture f/5.6-45f/5.6-45 f/8-64f/8-64
Angle of view Diagonal
8°50′4°25′6°10′3°05′
Vertical 4°55′2°25′3°30′1°40′
Horizontal 7°20′3°40′5°10′2°35′
Maximum magnification (x) 0.150.220.210.31
When the internal extender is set at 1.4x
 Extender EF1.4x II/III Extender EF2x II/III
WIDE TELEWIDE TELE
Focal length (mm) 3927845601120
Aperture f/8-64f/8-64f/11-91 f/11-91
Angle of view Diagonal
6°20′3°10′4°25′2°10′
Vertical 3°30′1°45′2°25′1°15′
Horizontal 5°15′2°40′3°40′1°50′
Maximum magnification (x) 0.210.30.30.44
COPY  
						

							ENG-24
●●Attach the extender to the lens, and then attach the lens to the camera. To remove it, reverse the order. 
Errors may occur if you attach the extender to the camera first.
●● When using this lens when shooting with EOS A2/A2E/5, use –0.5 step exposure compensation when using 
extender EF1.4x II, and use –1 step exposure when using extender EF2x II.
●● Extenders cannot be used more than one at a time.
●● Please take note of the following when using an EOS-1D Mark II or a subsequently released camera able to 
use autofocus (AF) at an aperture value of f/8 (maximum aperture).
If using this lens with a 1.4x extender and then setting the internal extender to 1.4x, the aperture value will 
be f/8, meaning that the frame for AF shooting will be the central AF frame.
Even if the internal extender setting is returned to 1x, AF shooting will continue to use the central AF frame.
To use an AF frame other than the central AF frame, please select the AF frame manually.
When an extender is attached, the AF speed will become slower to retain proper control.
Extenders (Sold Separately)
COPY  
						

							ENG-25
19. Camera/Extender Compatibility Chart
●●EF1.4x III and EF2x III extenders are recommended for use with EOS Digital Cameras.
Internal Extender1x (Maximum aperture: f/4) 1.4x (Maximum aperture: f/5.6)
Extender Model 1.4x II 2x II 1.4x III 2x III 1.4x II 2x II 1.4x III 2x III Actual Aperture  f/5.6 f/8 f/5.6 f/8 f/8 f/11 f/8 f/11
Function AF IS AF IS AF IS AF IS AF IS AF IS AF IS AF IS
EOS-1D X, EOS 5D Mark III, EOS-1D Mark IV, 
EOS-1Ds Mark III, EOS-1D Mark III
AF* kMF*
kAF
kMF*
kMF*
kMF kMF*
kMF
k
EOS Digital Cameras
(cameras listed on the following page*
1)
AF*
AF AF* AF
EOS Digital Cameras
(not applicable to 1D X, 5D Mark III, 1D Mark IV, 1Ds Mark III, 
1D Mark III, or cameras listed under*1 on the following page)
MF MF
MF MF
SLR Film Camera (EOS-1V)
SLR Film Cameras 
(not applicable to EOS-1V or cameras 
listed under*
2 on the following page) Cannot be usedCannot be used
SLR Film Cameras
(cameras listed on the following page*
2) **
** **
AF Autofocusing (AF) is possible when shooting
AF* Autofocusing is possible when shooting. However, the AF function might not focus correctly.
Please fine tune the AF when using a camera equipped with an AF micro adjustment function.
Please use manual focus when the AF function is not performing correctly while shooting with a camera which is not 
equipped with an AF micro adjustment function.
• For information on AF operation and micro adjustments, please refer to the camera’s instruction manual.
MF AF cannot be used. Therefore, please use manual focus (MF).
MF* AF cannot be used. Therefore, please use manual focus (MF). 
However, AF can be used by updating your camera’s firmware. 
Please check the Canon website for information about firmware updates.
k
The Image Stabilizer function can be used.** The Image Stabilizer function cannot be used with the cameras*2 listed on the following page.
COPY  
						

							ENG-26
20.  Extension Tubes 
(Sold Separately)
You can attach extension tube EF12 II or EF25 
II for magnified shots. The shooting distance 
and magnification are shown below.
When the internal extender is set at 1x
When the internal extender is set at 1.4x
MF mode is recommended for accurate focusing.
Focusing Distance  Range (mm) Magnification (×)
Close 
distance Long 
distance Close 
distance Long 
distance
EF12 II WIDE 1350 3743 0.17 0.06
TELE 2057 12954 0.2 0.03
EF25 II WIDE 1029 1883 0.26 0.13
TELE 1783 6182 0.26 0.07
Focusing Distance 
Range (mm) Magnification (×)
Close 
distance Long 
distance Close 
distance Long 
distance
EF12 II WIDE 1601 7496 0.36 0.04
TELE 1795 26536 0.26 0.02
EF25 II WIDE 1354 3835 0.52 0.09
TELE 1634 13248 0.32 0.05
Camera/Extender Compatibility Chart
*1: EOS-1D Mark 
II, EOS-1Ds Mark II,  
EOS-1D Mark II N, EOS-1D, EOS-1Ds
*2:
 EOS650, EOS620, 

EOS750,  
EOS750 QD, EOS850, EOS850 QD, 
EOS700, EOS10S/10, EOS REBEL/1000,  
EOS REBEL S/1000 F,  
EOS REBEL S QD/1000 FN QD,  
EOS ELAN/100, EOS630/600, EOS RT, 
EOS-1, EOS REBEL II/1000 N, EOS A2/5
COPY  
						

							ENG-27
Specifications
●●The lens length is measured from the mount surface to the front end of the lens. Add approx. 26 mm 
when including the lens cap and dust cap.
●●The size and weight listed are for the lens only, except as indicated.
●● The Close-up Lenses 250D and 500D cannot be attached.
●● Aperture settings are specified on the camera.
●● All data listed is measured according to Canon standards.
●● Product specifications and appearance are subject to change without notice.
When the internal extender is set at 1xWhen the internal extender is set at 1.4xFocal Length/Aperture 200-400mm f/4.0280-560mm f/5.6
Lens Construction 20 groups, 25 elements 24 groups, 33 elements
Minimum Aperture f/32f/45
Angle of View Diagonal
12°- 6° 10′  8° 50′- 4° 25′
Vertical 7°- 3° 30′ 4° 55′- 2° 25′
Horizontal 10°- 5° 10′ 7° 20′- 3° 40′
Min. Focusing Distance 2 m/6.56 ft.
Max. Magnification 0.15x (at 400 mm)0.21x (at 560 mm)
Field of View Approx. 157 x 235 mm/
6.18 x 9.25 inch (at 2 m/6.56 ft.) Approx. 111 x 166 mm/
4.37 x 6.54 inch (at 2 m/6.56 ft.)
Filter Any 52(WII)-series drop-in filter
Max. Diameter and Length 128 x 366 mm/5.04 x 14.41 inch
Weight Approx. 3620 g/127.7 oz
Hood ET-120(WII)
Lens Cap E-145C
Case Lens case 200-400
COPY  
						

							CT1-8578-003	 0613Ni	 ©	CANON	INC.	2013 
COPY