Canon lens CNE15547mm T28 L SP User Manual

1011
ž«·±æ”	
ÇZ
GO
omm
S» Ó¢EFÚ¢ïÄ£
SP» Ó¢PLÚ¢ïÄ£
ªž“7
Ñ¥”§µÅå Òªž ¶”ÜÅå Òªžž æµÅå Òªž
Ã
: 133 111 111
Þ´á”ç 0.8 0.80.8
P .C.D. 106.4 mm 88.8 mm88.8 mm

â^¯ 300°
93.5°
55° 

1011
“7
CN-E15.5-47mm T2.8 L SCN-E15.5-47mm  T2.8 L SP
Ú¢ïÄ» Ó ©àÊï EFÚ¢ïÄ PL Ú¢ïÄ
	¯:‘m 15.5 ™ 47 mm
T ÆïÌ” T2.8¢f=15.5™47£
Ü“Ë•
: 11

þØ Super 35mm 
 Ý”´±”«ç—

+ x 
(Ú¢1.781£ Φ
27.5 mm —
24.0 x 13.5 mm
¿¯zh¯¢
+—
(Ú£ 75.5°
 — 47.1 °
lzh¯¢
+—
(Ú£ 28.6Ã — 16.3 °

þØ EOS C300 
 Ý”´±”«ç—

+ x 
(Ú¢1.781£ Φ
28.2 mm —
24.6 x 13.8 mm
¿¯zh¯¢
+—
(Ú£ 76.9Ã — 48.0 °
lzh¯¢
+—
(Ú£ 29.3Ã —...

12
€ß	ØC
Šèï¶xˆhqè;ÑçÚÇážçèï¶pb{
• Š èï¶xéh
M^›	t‰
C^•z éh;t°
`$s§å”Ìåïµ›ËloM‡b{  

i ­hqè›,Šqb” EF  èï¶q
z±b”q†	í¯›3|h	í6qtsloM‡bwpz  
† èﶛ;b”Mxz 
žAt a§å”ÌåïµwÐ
T¢ ×ë ÄÌåïµw	Ú`sr£
›îª`oXi^M{
•  Ü “‰L
ÇÙS‘|Ù‘mw
ƒø.pxz °
`t
ƒø„
SU
™Xz ÐïÄwùO
c“UÊ
od‡Xs“‡b{‡hz 	¯...

ENGLISH
ENGLISH
The English version is the operation manual for counties other than Japan.
 GENER AL SAFETY INFORMATION ......4
Product Configuration  ....................................... 6
Names of Parts  ................................................. 7
F.B. (Back Focus) Adjustment  ...........................8
Available Accessories  ..................................... 10
Dimensions of Parts  ........................................ 12
Specifications...

2
ENGLISH
3
FCC REGULATIONS
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two 
conditions: (1) This device may not cause harmful interference, and (2) this device must accept 
any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital 
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable 
protection...

23
European Union (and EEA) only.This  symbol  indicates  that  this  product  is  not  to  be  disposed  of  with  your 
household  waste,  according  to  the  WEEE  Directive  (2002/96/EC)  and  your 
national  law.  This  product  should  be  handed  over  to  a  designated  collection 
point,  e.g.,  on  an  authorized  one-for-one  basis  when  you  buy  a  new  similar 
product  or  to  an  authorized  collection  site  for  recycling  waste  electrical  and 
electronic  equipment  (EEE).  Improper...

45
GENERAL SAFETY 
INFORMATION
The safety warnings and cautions provided on 
the product or in this operation manual must 
be observed.
Failure to observe these warnings and 
cautions provided to guard against hazards 
may result in injury or accident.
Read this operation manual carefully to 
familiarize yourself with its contents and 
ensure that you can operate the product 
properly.
Also, store this manual in a safe place where 
it can easily be referenced whenever required.
This operation manual uses...

45
TO THE CUSTOMER
1. Canon shall bear no responsibility for 
damage resulting from improper operation 
of this product by the customer.
2.  Canon shall make no guarantees about 
the product quality, functions, or operation 
manual and its marketability and suitability 
for the customer’s purpose. 
Moreover, Canon shall bear no 
responsibility for any damage, direct or 
incidental, that results from usage for the 
customer’s purpose.
3.  Canon shall make no guarantees about the 
results obtained using...

67
Lens capReference Guide
Operation ManualLens body
Zoom/focus lever (short)
Zoom/focus lever (long) Rear lens cap*
* The shape of the rear lens cap for the SP type differs from the figure above.
Product Configuration
Two types of the CN-E15.5-47mm T2.8 L are available for the positive lock mount (S type) 
and the Canon EF mount (SP type). Figures in this manual are for the S type lens unless 
otherwise mentioned.
Lens body 
................................................... 1
Zoom/focus lever (short)...

67
Names of Parts
Focus drive gear
Number of teeth: 133
Module: 0.8 metric module
P.C.D.: 106.4 mm
Angular rotation: 300°Zoom drive gear
Number of teeth: 111
Module: 0.8 metric module
P.C.D.: 88.8 mm
Angular rotation: 93.5°Iris drive gear
Number of teeth: 111
Module: 0.8 metric module
P.C.D.: 88.8 mm
Angular rotation: 55°
Lens holder
Attachment holder F.B. adjuster 
cover
EF mount (S type)
Zoom/focus levers PL mount (SP type)