Candy Go F 662 Manual

							Washing machine                          Instructions for use 
						

							Introduction
Please read these instructions for use carefully and all other information enclosed with the
washing machine.
Keep all documentation in a safe place for future reference or for any future owners.
Note: this machine is solely for domestic use. 
Notes on disposal
All packaging material used is environmentally-friendly and recyclable. Please help dispose of
the packaging via environmentally-friendly means.
Your supplier or local council will be able to give you
details of current means of disposal. 
Valuable materials can be salvaged from an old appliance via scrap reprocessing.
Note: pull out the mains plug from any old appliance.
Cut the power cable and dispose of it, together with the
plug.
When disposing of an old washing machine, please ensure that the door lock is rendered
inoperable to prevent children shutting themselves in the appliance.
2 
						

							Contents Page
Introduction 2
General delivery notes 4
Safety notes 4
Quick start5
Description of controls 6
Programme Table 12
Programme selector 14
Detergent drawer  17
Detergents, washing aids and amounts to use 18
Useful advice for the user 20
The main wash 21
Cleaning and routine maintenance 23
Investigating malfunctions 25
Technical data 27
Setting up +  installation28
BEFORE SWITCHING ON THE APPLIANCE MAKE SURE
IT IS CORRECTLY INSTALLED AND THAT THE TRANSIT
SCREWS ARE REMOVED AS SHOWN IN PAGE 28.
3 
						

							4
General delivery notes
Please check that the following items are delivered with the appliance:
-   Instruction manual
-   Certificate of guarantee
-   Inlet hose
Check that no damage has occurred during transit, and if so, call your nearest Authorised
Technical Support Service agent.
Safety notes.
Note:
for cleaning or maintenance of the washing machine.
A) Pull out the plug
B) Turn off the tap
C) Candyequips all its appliances with earthing. Ensure that the mains supply is earthed,
and if it is not, seek assistance from a qualified person.
D)  Do not touch the appliance when hands or feet are wet or damp. Do not use the appliance
with bare feet.
E)  The use of adapters, multiple connectors and/or extensions is not recommended.
Note:
water temperature can reach 90°C during the wash cycle.
F)  Check there is no water left in the drum before opening the door.
G) This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
H) Do not pull the power cable or the appliance itself to remove the plug from the socket.
I)  The appliance must not be exposed to weather conditions (rain, direct sun, etc...)
L)  When moving the appliance never lift it by the controls or by the detergent drawer.
When in transit never rest the door against the trolley or transport the appliance without
the polystyrene base. 
						

							M) N.B!
If the appliance is installed on a carpeted floor ensure that the ventilation holes on the
base of the appliance are not obstructed.
N)  If the appliance is not running properly or breaks down, switch it off, turn off the tap and do
not tamper with the appliance.
Consult only the Authorised Technical Support Service for possible repair and ask them to 
use original spare parts.
Failure to comply with the above can compromise the safety of the appliance.
O)  If the appliance’s power cable should ever need replacing, consult the Authorised 
Technical Support Service  
Quick start
Washing
-  Open the door by using the handle “A” (Fig. 1, page 6)
-  Select laundry and put it in the machine
-  Close the door
-  Put detergent in the compartments as indicated in the programme guide in this instruction
manual
- Select programme
-  Wait that a “SPIN” indicator light will go on.
Press additional function buttons (if required)
-  Press the “Start/Pause” button (page 7)
-  After few seconds the appliance starts working.
After washing
-     All the wash stage indicator lights will illuminate. 
-     Wait for the door lock to be released 
(about 2 minutes after the programme has finished).
The “Door Security” indicator light will go out.
-  Switch off the washing machine by turning the 
selector to “OFF” position.
-     Open the door and remove the laundry.
Ensure that the machine is correctly installed in line with the instructions found on page 28.
5 
						

							6
Description of controls
Door handle A
Door Security indicator light B
Start/Pause button  C
Cold wash button D
Allergy Care button E
Delay Start button F
Spin Selection button  G
Spin speed indicator light H
Wash stage indicator lights L
Buttons indicator lights M
Programme selector with OFF position N
Detergent drawer P
A P
N
E CHG
M
D
F  L
B M 
Fig. 1 
						

							Door handle
Press the finger-bar inside the door handle to open the door.
A
7
DOOR SECURITY indicator light 
The “Door Security” indicator light is illuminated when the door is fully closed and the machine is ON.
When "Start/Pause" is pressed on the machine with the door closed the indicator will flash
momentarily and then illuminate. 
If the door is not closed the indicator will continue to flash.
Aspecial safety device prevents the door from being opened immediately after the end of the cycle.
Wait for 2 minutes after the wash cycle has finished and the “Door Security” light has gone out
before opening the door. At the end of the cycle turn the programme selector to "OFF" .
B
NOTE: When the Start/Pause button has been pressed,
the appliance can take few seconds before it starts
working.
START/PAUSE button 
After selecting a programme wait that a  “Spin” indicator
light is illuminate before pressing the START button.
Press to start the selected cycle (according to the selected cycle one wash stage indicator
lights will illuminate).
Changing the settings after the programmes has started (PAUSE)
The programme may be paused at any time during the wash cycle by holding down the
“START/PAUSE” button for about 4 seconds.
When the machine is in the paused mode, a “wash stage” indicator light and option buttons
will flash.
To restart the programme press the START button once again.
If you wish to add or remove items during washing, wait 2 minutes until the safety device
unlocks the door.
When you have carried out the manoeuvre, close the door, press "Start/Pause" button and
the appliance will continue working where it left off.
CANCELLING THE PROGRAMME
To cancel the programme, set the selector to the OFFposition.
Select a different programme.
Re-set the programme selector to the OFFposition.
C 
						

							8
COLD WASH button  
By pressing this button it is possible to transform every programme into a cold washing one,
without modifying other characteristics (water level, times, rythmes, etc...).
Curtains, small carpets, man made delicate fabrics, non coulor fast garments can be safely
washed thanks to this new device.
D
The option buttons should be selected before pressing
the Start/Pause button.
E“ALLERGY CARE” button 
By pressing this button you can activate a special new wash cycle in the Cotton and Mixed
Fabrics programs, thanks to the new Sensor System. This option treats with care the fibres of
garments and the delicate skin of those who wear them.
The load is washed in a much larger quantity of water and this, together with the new combined
action of the drum rotation cycles, where water is filled and emptied, will give you garments which
have been cleaned and rinsed to perfection. The amount of water in the wash is increased so that
the detergent dissolves perfectly, ensuring an efficient cleaning action. The amount of water is also
increased during the rinse procedure so as to remove all traces of detergent from the fibres. This
function has been specifically designed for people with delicate and sensitive skin, for whom even
a very small amount of detergent can cause irritation or allergy.
You are advised to also use this function for children’s clothing and for delicate fabrics in general,
or when washing garments made of towelling, where the fibres tend to absorb a greater quantity of
detergent. To ensure the best performance for your wash, this function is always activated on the
Delicates and Woollens/Hand wash programs. 
						

							9
DELAY START button   
Appliance start time can be set with this button, delaying the start by 3, 6 or 9 hours.
Proceed as follows to set a delayed start:
Select a programme (Wait that a “Spin” indicator light will go on).
Press "Delay Start" button (each time the button is pressed the start will be delayed by 3, 6
or 9 hours respectively and the corresponding light will blink).
Press "Start/Pause" to commence the Delay Start operation (the indicator light associated
with the selected Delay Start time stops blinking and remains ON).
At the end of the required time delay the programme will start.
To cancel the Delay Start function :
press the "Delay Start" button until the indicator lights will be off and the programme can be
started manually using the "Start/Pause" button or switch off the appliance by turning the
programme selector to "OFF" position.
F
Warning: If there is any break in the power supply while
the machine is operating, a special memory stores the
selected programme and, when the power is restored, it
continues where it left off.
SPIN SELECTION button 
According to the selected cycle automatically will shows if the programme’s spin is maximum
(MAX), intermediate (MED) or zero  (       ). By pressing this button, it’s possible to reduce or cancel
the spin speed shown.
To reactivate the spin cycle press the button until you reach the spin speed you would like to set.
To prevent damage to the fabrics, it is not possible to increase the speed over that which is
automatically suitable during the selection of the program.
It is possible to modify the spin speed without to pausing the machine.
Note: 
The machine is fitted with a special electronic device, which
prevents the spin cycle should the load be unbalanced.
This reduces the noise and vibration in the machine and so
prolongs the life of your machine.
G 
						

							10
Spin speed indicator light 
When you set a program, the maximum possible spin speed will be automatically shown by
the relevant indicator light. 
Choosing a smaller spin speed by the appropriate button, the relevant indicator light will go on.
H
WASH STAGE indicator lights 
= main wash
= rinse
= spin
L
Buttons indicator light 
These light up when the relevant buttons are pressed.
If an option is selected that is not compatible with the selected programme then the light on
the button first flashes and then goes off. 
M