Candy Cdcp 6e Manual

							CConnection of drain hoses
Insert the drain hose into a drain pipe with a minimum diameter of 4cm, or let it
run into the sink, making sure to avoid bending or crimping it. The free end of the
hose must be at a height lower than 60cm and must not be immersed into water to
avoid the backflow of it.
17
MAX600mm
A
Counter
Front
Drain pipe
NOTE
The top of the hose
must be less than
600mm.
φ40mm
B
PLEASE HANG UPTHE DRAIN HOSE EITHER WAYOFA, B 
						

							1818
If the sink is more than1000 mm higher than the floor, the excess water in hoses cannot be drained directly
into the sink. It will be necessary to drain excess water from hoses into a bowl or suitable
container that is held outside and lower than the sink.
Connect the water drain hose. The drain hose must be correctly fitted to avoid water leaks.
Ensure that the water hose is not kinked or squashed.
If you need a drain hose extension, make sure to use a similar drain hose.
It must be no longer than 4 metres,otherwise the cleaning effect of the dishwasher could be reduced.drain
Water Outlet
Extension Hose How to Drain Excess Water From Hoses
Start of dishwasher
The following things should be checked before starting the dishwasher.
1The dishwasher is level and fixed properly.
2The inlet valve is open.
4The wires are tightly connected.
5The power is switched on.
6The inlet and drain hoses are not kinked.
7All packing and print materials should be taken out of the dishwasher.
Attention:
The content of this manual is very helpful to the users.After installation, please make sure to keep this manual.
3Inlethose connections are fully tightened and not leaking. 
						

							9.TroubleshootingTips
Problem Possible Causes What To Do
Fuse blown, or the
circuit breaker tripped.Replace fuse or reset circuit breaker. Remove any other
appliances sharing the same circuit with the dishwasher
Suds in the tub
Spilled rinse-aidAlways wipe up rinse-aid spills immediately.
Review the charts on the following pages may save you from calling for service.
White film on
inside surface
There are rust
stains on cutlery
Knocking noise
in the wash cabinet
Rattling  noise
in the wash cabinet
Knocking noise
in the water pipesHard water minerals
The affected items are
not corrosion resistant.
The lid of softer
is loose.
The sp ay arm is
knocking against
an item in a basket.r
Item of crockery
are insecure
in the wash cabinet.
This may be caused
by on-site installation
or the cross-section of
the piping.A programme was not
run after dishwasher
salt was added.
Traces of salt have
got into the wash cy le.cTo clean the interior, use a damp sponge with
dishwasher detergent and wear rubber gloves.
Never use any other cleaner than dishwasher
detergent for the risk of foaming or suds.
Always run the Quick wash  programme .
without  any crockery in the dishwasher and
without selecting the Turbo function (if present),
after adding dishwasher salt.
Check the lip .Ensure the fix is fine.
Interrupt the programme, and rearrange the items
which are obstructing the sp ay arm.r
Interrupt the programme,
and rearrange the items of crockery.
This has no  influence on dishwasher function.
if in doubt, contact a suitably qualified plumber.
Stained tub interiorDetergent with
colourant was used.Make sure that the detergent is the one without
colourant.
Improper detergent
Dishwasher doesn t
start'
Make sure the dishwasher is turned on and the door is
closed securely.
Closed dishwasher making sure that door latches.
Make sure the power cord is properly plugged into the
wall socket. Power supply is not
turned on.
Door of dishwasher
not properly closed.
Water not pumped
f om dishwasherrKink in drain hose
Filter clogged.
Kitchen sink clogged.Check drain hose.
Check coarse  filter.
(see section titled )the
" Cleaning The Filter "
Check kitchen sink to make sure it is draining well.
If problem is kitchen sink not draining ,you may need
a plumber rather than a serviceman for dishwasher.
Use only the special dishwasher detergent to avoid
suds. If this occurs, open the dishwasher and let suds
evaporate. Add 1 gallon of cold water to the tub. Close
and latch the dishwasher,  then Start any wash cycle
to drain out the water . Repeat if necessary.
Before Calling for Service
19
Technical
problems
General
problems
Noise 
						

							Problem Possible Causes What To Do
The dishes  were not
loaded correctly.See notes in " Loading the Dishwasher Baskets ".The dishes
are not clean
Cloudiness
on glassware
Black or gray
marks on dishes
Detergent left in
dispenser cups
The dishes
are not drying
Select a more intensive programme.
See" Wash Cycle Table ."
Use more detergent, or change your detergent.
Rearrange the items so that the sp ay can rotate freely.r
Clean and/or fit the filter combination correctly.
Clean the sp ay arm jets. See "Cleaning the Spray
Arms".r
Use less detergent if you have soft water and select
a shortest cycle to wash the glassware and to get
them clean.
Use a mild abrasive cleaner to eliminate those marks.
Re-loading the dishes properly.
Load the dishwasher as suggested in the directions.
Increase the amount of rinse-aid/Refill the rinse-aid
dispenser.
Do not empty your dishwasher immediately after
washing. Open the door slightly so that the steam can
escape. Begin unloading the dishwasher only once t
he dishes are barely warm to the touch. Empty the low
basket first. This prevents water form dropping off
dishes in the upper basket.
In short programmes the washing temperature is lower.
This also lowers cleaning performance. Choose a
programme with a long washing time.
Water drainage is more difficult with these items.
Cutlery or dishes of this type are not suitable for
washing in the dishwasher.The programme was
not powerful enough.
Not enough detergent
was dispensed.
Item are blocking
the path of sp ay arms.r
The filter combination
in the base of wash
cabinet is not clean or
is not correctly fitted.
This may cause
the sp ay arm jets
to get blocked.r
Combination of soft
water and too much
detergent.
Aluminum utensils
have rubbed against
dishes.
Dishes block
detergent cups.
Improper loading
Too little rinse-aid
Dishes are removed
too soon.
Wrong programme
selection
Using cutlery with
a low-quality coating
Error Codes
When some malfunctions come on, the appliance will display error codes to warn you:
WARNING!
If overflow occurs, turn off the main water supply before calling a service.
If there is water in the base pan because of an overfill or small leak,
the water should be removed before restarting the dishwasher.
 

20
Unsatis
-factory
washing
result
Unsatis
-factory
drying
result
CodesMeanings
Possible Causes
Longer inlet time.Faucets is not opened, or water intake is restricted,
or water pressure is  too low.The Rapid light flicker fleetly
The Glass light flicker fleetlySome element of dishwasher leaks .Overflow. 
						

							550mm
438mm
812mm
Height :                                    438mm
W i d t h :                                     55 0 m m
Depth :                                     500mm
Voltage connected Load :      see rating label
Wa t e r p r e s s u r e :                      0 . 0 4 - 1 . 0 M P a
Power supply:                         see rating label
Capacity:                                 6 Place settings
Technical Information
500mm
21 
						

							A+
0.61  kWh
0.4 5 W
0.4 5 W
A
1min
1280 W
Sheet of hous ehold d ishwasher according to EU Directive 1059 /2010:
Manu facturer
Type / Description
Standard place settings
En erg y efficiency c lass
Annual energy consumption
En erg y co nsumpti on of the sta ndar d cle aning cy cle
Powe r consumption of off-mode
Powe r consumption of left-on mode
Annual water consumption
D rying efficien cy c lass
Standard cleaning cycle
Program duration of the sta ndard cleaning cycle
Noise level
Mounting
Height
Width
D epth (wit h co nne ctors )
Po we r consumption
Rated voltage / freque ncy
A + + + (highest efficiency) to D (lowest efficiency)
Energy consumption 174 kWh per y ear, based on 280 standard cleaning cycles using cold water fill and
the consumption of the low power mode s. Actual energy consumptio n will depend on how the appliance is used.




Water consumption 0 litres per year, based on 280 standard cleaning cycles. Actual water consumption
will depend on how the appliance is used.



A (highest efficiency) to G (lowest e fficiency)
This program is suitable for cleaning soiled normally soiled table ware and that it is the
most efficient programme in terms of its combined energy and water consumption for
that ty pe o f tab leware.
The device meets the European standards and the directives in the c urrent version at delivery:
- LVD 2006/95/EC
- EMC2004/108/EC
- ErP 2009 /125/EC
The above values have been measured in accordance with standards under specified operating conditions.
Results may vary greatly according to quantity and pollution of the dishes, water hardness,
amount of detergent, etc.
The manual is based on the European Unions stand ards and rules.
Technical Data Sheet
NOTEÖ
EC O 50

23 0 V~ 50 Hz
Water pressure (flow pressure)
0.4-10 bar = 0.04-1 MPa
Could be built-inYe s CANDY
Free standing
CDCP 6/E . CDCP 6/E-S
      6
174   kWh
1820liter
51 dB(A) re 1 pW
43.8cm
55cm
50 cm
18295