Brother HL 2250DNR User Manual

Driver and Software 
47
2
Manual Duplex Printing2
For Mac OS X 10.4.11
aSelect Paper Handling.
bChoose Odd numbered pages and click Print. 
cTurn the paper over and reload it in the tray, and then choose Even numbered pages and click Print.
For Mac OS X 10.5.x and 10.6.x
aSelect Paper Handling.
bChoose Odd only in Pages To Print and click Print. 
cTurn the paper over and reload it in the tray, and then choose Even only in Pages To Print and click 
Print.
 

Driver and Software 
48
2
Automatic Duplex Printing (HL-2240D / HL-2242D / HL-2250DN / HL-2270DW only)2
For Mac OS X 10.4.11
aSelect Layout.
bChoose Long-edged binding or Short-edged binding in Two-Sided. 
cSelect Paper Handling.
dChoose All pages in Print and click Print. You can print pages on both sides of the paper. 
 

Driver and Software 
49
2
For Mac OS X 10.5.x and 10.6.x
aSelect Layout.
bChoose Long-edge binding or Short-edge binding in Two-Sided. Automatically the Two-Sided 
check box is checked.
 
cSelect Paper Handling.
dChoose All pages in Pages To Print and click Print. You can print pages on both sides of the paper. 
 

Driver and Software 
50
2
Status Monitor2
This reports the machine status (any errors that may happen with the machine) when printing. If you would 
like to turn the status monitor on, follow these steps:
For Mac OS X 10.4.11
aRun the Printer Setup Utility (from the Go menu, choose Applications, Utilities), then choose the 
machine.
bClick the Utility, then the status monitor will start up.
For Mac OS X 10.5.x
aRun the System Preferences, select Print & Fax, then choose the machine.
bClick the Open...

Driver and Software 
51
2
Uninstalling the printer driver2
You can uninstall the printer driver that you have installed with the following steps.
Note
• This is not available if you installed the printer driver from the Windows® Add a printer function.
• After uninstalling, we recommend that you restart your computer to remove files that were in use during 
the uninstall.
 
Printer driver for Windows®2
aClick the Start button, point to All Programs1, Brother, and then to your machine name.
bClick...

Driver and Software 
52
2
Software2
Software for networks (HL-2135W / HL-2250DN / HL-2270DW only)2
For the information about network utility software, see Chapter 1 of the Network Users Guide.
Remote Printer Console  (For Windows® only) 2
Remote Printer Console is software to change many of the printer settings independently of your application. 
For example, you can change the settings for printer margin, sleep mode, character set and so on. These 
settings are then remembered and used by the machine....

53
3
3
LEDs (Light Emitting Diodes)3
This section refers to four LEDs Toner, Drum, Error, Ready and Go button on the control panel.
The LED indications shown in the table below are used in the illustrations in this chapter.
Control Panel3
 
1Toner LED
The Toner LED indicates that the Toner is low.
2Drum LED
The Drum LED indicates that the Drum will need to be 
replaced soon.
3Error LED
The Error LED indicates when the machine is in one of 
the following states:
No paper / Paper jam / Cover open
4Ready...

Control Panel 
54
3
LEDsMachine Status
 SLEEP
The machine is in Sleep mode (Power Save mode). The machine acts as though it 
were turned off. Receiving data or pressing Go wakes up the machine from Sleep 
mode to Ready mode.
DEEP SLEEP
The machine is in Deep Sleep mode (reducing more power consumption than Sleep 
mode). The machine acts as though it were turned off. If the machine does not 
receive data for a certain length of time while it is in Sleep mode, it enters Deep Sleep 
mode automatically....

Control Panel 
55
3
 TONER LOW
The toner cartridge will need to be replaced soon. Buy a new toner cartridge and 
have it ready for when REPLACE TONER is indicated.
The Toner LED will turn on for 2 seconds and off for 3 seconds.
 REPLACE TONER (Stop mode)
Replace the toner cartridge with a new one. See REPLACE TONER on page 71.
CARTRIDGE ERROR
The drum unit assembly is not installed correctly. Take the drum unit out of the 
machine and put it back in.
NO TONER
Open the front cover, install the toner...

Control Panel 
56
3
 DRUM END SOON
The drum unit will need to be replaced soon. We recommend that you get a new 
drum unit to replace the current one. See Replacing the drum unit on page 79.
The Drum LED will turn on for 2 seconds and off for 3 seconds.
 REPLACE DRUM
Replace the drum with a new one. See Replacing the drum unit on page 79.
 NO PAPER T1
Put paper in the paper tray. Then press Go. See Printing on plain paper, recycled 
paper, bond paper, thin paper or thick paper on page 10.
MANUAL FEED
Put...