Bose 131 marine speaker system Sold from 1997 User Manual

AM188201_02_V.pdf                                                                    October 30, 2001                                                                                                     1 1
Snap the grille in place on the mounting flange.
No hardware is needed to secure this part. You
are now finished with the assembly. Enjoy your
music system!
Place the template over the area where the speaker
is to be located. The round outer edge shows how
much room to allow for the grille. The long...

12              October 30, 2001                             AM188201_02_V.pdf
Use a half-round file or wood rasp to smooth out
any roughness in the speaker hole you have cut.
Using the sabre saw, cut the hole for the speaker,
carefully staying just inside the line. Take your time;
you want a smooth edged circular hole.B 4
Installing Your Speakers From The Front Of The Bulkhead
Drill a starter hole that is large enough for your sabre
saw blade. Be sure to drill inside and close to the line
you have...

AM188201_02_V.pdf                                                                    October 30, 2001                                                                                                     1 3
Connect the speakers. Be sure the receiver or amplifier is
turned OFF. If possible, disconnect the power source.
Use the supplied silicone-filled wire nuts to secure the
ends of each wire pair. Place the stripped end of the
positive (+) right channel receiver wire together with the
stripped end of the...

14              October 30, 2001                             AM188201_02_V.pdf
Remove the speaker enclosure.
Tie a knot in each joined wire pair to protect the
connection from being pulled apart.
Installing Your Speakers From The Front Of The Bulkhead
B 10
Reinsert the speaker enclosure.
Note: For added protection against water enter-
ing the bulkhead, you can apply a generic silicone
sealant between the flange and the mounting
surface.
B 14
Drill six 1⁄8 inch (.32 cm) holes.B 13
B 12
Reinsert the...

AM188201_02_V.pdf                                                                    October 30, 2001                                                                                                     1 5
Finally, snap on the grille to the mounting flange. No
hardware is needed to secure this part. You are now
finished with the assembly.  Enjoy your music
system!
Install six screws, if possible. You need at least three
screws installed and equally spaced. Remove the perforated speaker cone shields from...

16              October 30, 2001                             AM188201_02_V.pdf
Problem What to do
• Make sure the boat’s receiver is turned ON.
• Make sure the power supply of the boat is connected and
adequately charged.
• Make sure the receiver is not set to MUTE.
• Refer to the owner’s guide that came with your receiver.
• Check connections to both the speakers and the receiver.
Refer to “Test the speakers” on page 6. Correct any connection
errors.
• Disconnect the working speaker from the receiver.
•...

AM188201_02_V.pdf                                                                    October 30, 2001                                                                                                     1 7
Bose®  Corporation
Italia
Bose S.p.A., Via della Magliana 876
00148 Roma
www.bose.iT
TEL 06-65670802 FAX 06-65680167
Japan
Bose K.K., Shibuya YT Building
28-3 Maruyama-cho
Shibuya-ku, Tokyo 150
TEL 3-5489-0955 FAX 3-5489-0592
Nederland
Bose B.V., Nijverheidstraat 8
1135 GE Edam
TEL 0299-390111 FAX...

©2000 Bose Corporation
The Mountain, Framingham, MA 01701-9168 USA
188201   AM Rev.02   JN97843